Rural Development Department Tender

Item No 3:Excavation in Hared murum/ soft Rock including depositing the excavated materials as & where directed etc.Complete.

Item No 4 :Dewatering by using diesel pumps durring excavation & execution etc. complete.

Item No 5: Providing and laying in situ c.c. 1:3:6 M-75 IN(40MSA) of trap,granite,gneiss of graded metal including curring and compaction etc. complete.

Item No 6:- Providing and laying in situ c.c. 1:2:4 (40MSA) of trap,granite,gneiss of graded metal including curring and compaction etc. complete. Below NBL

ABOVE NBL

Item No 7:- Providing and laying in situ c.c. 1:2:4 (20 MSA) of trap,granite,gneiss of graded metal including curring and compaction etc. complete. Below NBL

Item No 8: Providing and laying M.S steel bar reinforcement including cutting,bending,binding and hooking etc. complete. Below NBL

ABOVE NBL

Item No.9:- Providing and filling in foundation with approved excavated materials including laying in layers, watering ramming etc. complete.

Item No..10 :- Manufacturing with QAP & fabrication of KT weir needle gates - straight type size 2.15*0.50 M - 94 Kg weight as per relevant Indian standards with all material , Mild steel confirming to IS 2062 , Rubber seal confirming to IS 4623 & welding electrodes AWS E6013 for general weld joints. It includes all materials , Labour charges , machinery charges , 1 Km lead charges of transportation ,loading and unloading charges of Gate parts at site , Inspection & Quality control charges , Sand blasting , Painting with one coat of Zinc rich primer on dry film to give total dry film thickness 70 +/- 5 microns and 2 coats of sloventless coal tar epoxy paint applied to give minimum dry film thickness of 150 +/- 5 micron per coat as per IS 14177 , overhead charges of 10% , and all incidental charges including all duties , taxes , levies and insurance charges.

Item no. 11:Providing and fixing seal beam and vertical posts of channel 125*65 MM medium size etc. complete.

ITEM NO.12:- Providing and fixing canal information board of 1.20 * 0.75 m prepared on 16 gauge M.S. sheet with angle iron frame of size 35*35*3 mm with cross bracing of size 25*25*3 mm including painting with one coat of zinc chromate storing primer and two coats each of green/white back ground and back side grey store enamelled bonded with red retro reflective sheet Engineering grade , border / letters / numeral / arrows coated with non pealable crystal clear protective transparent coat retaining 100% reflection including two angle iron post of size 50*50*5 mm of 3.65 m long inflated at bottom drilled on top and painted in white and black bonds of 30 cm with four numbers high strength of G.I. bolts and nuts of size 10 mm dia. and 20 mm long sheet and angle iron post in one piece without joints including all taxes , conveying , fixing in ground with cement concrete in M-15 block of size 60*60*75 cm as directed by engineer-in-charge.