Rural Development And Panchayat Raj Department Tender

Supply and run of 4 x 6 sq.mm (84/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100V grade in 32mm dia GI pipe (Class 'B') suitably bent at both ends with necessary angle iron up right and end supports for mains (SD-73)

Providing Purified Water Supply System (RO Plant) at GYPSY Campus near Esaniya Lingam in Tiruvannamalai

Earth work open excavation in all soils and sub-soils and to full depth as may be directed except in rock requiring blasting inclusive of shoring shuttering, bailing out water wherever necessary and depositing the excavated earth with a lead of 10 mts. within the compound in places shown by the departmental officers and clearing and levelling the site, etc., complete complying with standard specification.

Supplying and erecting in position of following liters capacity Industrial Model Reverse Osmosis Water-cum-Purifier to deliver Potable Water with World Health Organisation (WHO) Standards with following accessories. (a) MS Skid - 1 No. (b) Media 11054 No. Vessel with 20 nb Multiport Valve (with Media Pubble and Fine Sand and Activated Carbon Filling) set (c) Feed Pump 0.50 HP – 1 No. (d) Vertical Pump 2-9, 2.00 HP / Single Phase – 1 No. (e) Membrane 40 x 40 filmtech (or) equilaents / Osmonic (USA) - 1 No. and Membrane Pressure Vessel 40 x 40 -1 No. & Pressure Gauge - 2 Nos. (f) Flow Meter - 1 No. 20” Filter with Housing - 1 No., Low Pressure Switch - 1 No., Level Switch - 1 No. & Necessary CPVC Pipes and Fittings. The system shall be provide with Two Panel Control System with necessary Stainless Valves and Fittings and Float Control etc. The rate should be inclusive of all civil works, wherever necessary to install the System in position and intact

Wiring with 2x1.5 sqmm (22/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessoires in flush with wall with 3mm thick hylum sheet cover with TW switch box and 5A F.T. switch and making good of the concealed portion with suitable colour for PVC concealed light / Fan Point (For electronic regulator) (5 Points Per Coil) SD-25

Supplying and filling of conveyed well Gravel by lorry with a lead of 3 km in basement filling including stacking for premeasurement, conveyance, loading and unloading charges and all other incidental charges and including filling laying watering and consolidating etc., complete as directed by the department officers and complying with standard specifications

Supplying, fixing of cylindrical vertical notational polyethene water storage tank of 1000 litres capacity confirming to IS 12701 / 96. The tank is meant of outer (or) indoor, use complete with removable hnged top locking arrangements and to make provision to fix with simply pipelines necessary man hole with cover and including all PVC specials, plugs, screws, nails to fix the tank etc., and the tank should be fixed firmly as directed. The rate shall inclusive of all materials labour, conveyance, hoistings and fixing charges etc., (The water tank should be got approved by the Executive Engineer before use on works by the departmental officers) SINTEX / EQUIVALENT

Supplying, Laying and Jointing UPVC Pipes (having a pressure of 10 kg. / sq.cm) of approved quality and best variety comforming to BIS of the following dia including cutting, Threading and fixing PVC specials using PVC adhesives (but excluding cost of such specials) and fixing into wall with teak wood plugs, PVC clamps and screws making holes on the wall (or) drilling holes in the roof and making good the dismantled portion to original condition with necessary brick work/cement concrete and plastering neat wherever necessary with necessary scaffolding charges upto 4 meter height above ground level etc., comopleted complying with standard specification . The PVC Pipes shall be got approved by Executive Engineer before use on works. Below Ground Level (External Water Supply)

Cement Concrete 1::4 (One Cement, Two crushed stone M.Sand sand and four hard broken stone jelly) using 0 mm gauge hard broken granite stone jelly for all fabricating charges, centering and shuttering but including laying, vibrating with mechanical vibrators, finishing curing etc and providing fixtures like fan clamps in the RCC floor/ roof slab wherever necessary and bearing surfaces of walls, beams etc. shall be finished smooth with CM 1:3

Supply and fixing of Ceiling fixture 4' 18W Crystal Glass LED Tube Light Fitting (Havells / Equivalent)

Supply and Installation of 1000 Litre capacity Stainless Steel Storage water tank with (SS 304) with round / ring MS base with legs along with fixtures / plumbing including labour charges and all other incidental charges etc. complete as per standard specification

Supply and Fixing of Stainless-Steel water sinks (2 no’s) with 6 water taps for staircase using 50mm dia 304L Grade Stainless Steel pipe of 1.60mm thick at required locations to a height of 0.90m from finished floor level welded to 38mm dia Stainless Steel pipe post of 1.00mm thick as vertical at 900mm centre with 2 Nos. of 25mm dia intermediate horizontal stainless-steel pipe of 1.60mm thick in between. The vertical pipe has to be welded to the 100 X 100 X 6mm MS base plate encased in the base concrete. The rate is inclusive of the charges for cutting, bending, welding, grinding, polishing, conveyance, etc. including labour charges and all other incidental charges etc. complete as per standard specification

Earthing as per the ISI specification with an earth electrode of 2.1mt class 'B' GI pipe of dia not less than 40mm, with copper earth plate of size 125mm x 50mm x 6mm, with necessary funneling arrangements with necessary masonry work and with 38mm RCC cover slab for the brick masonry

Cement Concrete of mix 1:11/2:3 (One cement, one and half M.sand and three aggregate) using 0 mm guage hard broken granite stone jelly for all RCC items of works exluding cost of reinforcement grill and fabricating vibrators, finishing, curing etc

Paving the floor with best approved quality super fine polished Granite Stone Slabs of size 1200 x 600 of 18 / 20mm thick of Synthetic Grey, Paradise and similar varieties with machine cut edges laid over a cement mortar bed of 20mm thick using cement mortar 1:3 (One cement and three sand) fixing the slabs with required cement slurry and laid in true right angles with minimum possible width of joints and pointing the joints with white cement mixed with mathcing colouring pigments etc., The granite stone slabs and other materials to be used shall be got approved by the Executive Engineer concerned before use on work, etc., complete as per standard speicification.

GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column "BB" for all works in this package}

Towards the cost of Supply at Tiruvannamalai Girivalam Site and erection of 100mm thick sandwich PUF Wall Panel made out of Minimum 0.50 mm thick pre-coated GL sheets on both sides (tongue and groove type) as per the required Room size 4.80m x 3.50m and roof size 5.00m x 3.65m with minimum density of 40 Kg/M3 including all necessary fixtures, Zinc coated fasteners, Yield Strength of 380 MPA , Closed cell contents 100 KPA, Pitch 333 With 9 stiffing ribs etc. complete. Wherever gaps are there between PUF panels and Glass window / PVC door frame gaps shall be filled with silicone sealants to avoid leakages, and fixing cold formed MS 'Hollow Square Tube' with minimum Zinc coating of 120 GSM of size 3 mm thick 100mm x100mm for fixing at plinth and necessary support required to hold the 100mm PUF wall panels, GL colour coated accessories such as Flashings, Ridges, end caps, etc. complete with all necessary Zinc coated. Upto 500 mm Girth, and fixing glass panes 3 Nos size of 1.20m x 2.10m for 4mm thick glass panes including silicone sealants etc and fixing Glass & Frame of size 50x47 mm with a wall thickness of 5 mm (± 0.2 mm), made out of single piece extruded PVC profile, with mitred cut joints and joint with 2 no’s of PVC bracket of size 190 mm x 100 mm long arms of cross section size 35 x 15 mm & self-driven self-taping screws, the vertical door profiles to be reinforced with 40x20 mm M.S. rectangular tube of 0.8mm , including providing EPDM rubber gasket weather seal throughout the frame, including jointing 5 mm PVC frame strip with PVC solvent cement on the back of the profile. The door frame to be fixed to the wall using 8 x100 mm long anchor etc., including labour charges and welding, polishing, conveyance, etc., supply and installation of C Flashing, L Flashing, Sealant Screws and revits for Wall - Panel, supply and fixing of L Type ACP Protective Sheets Four corners all other incidental charges, labour charges, Transport charges and charges for Protective Guard Film etc. complete as per standard specification.