Bhabha Atomic Research Centre Tender

General Notes: 1) The make/model/brand for all the BOQ items shall be as per suggestive makes of Annexure-B of Section-VII of the tender document. The make/model/brand mentioned in Annexure-B of Section-VII of the tender document is merely for guidance and bidders can prefer any other make which is meeting technical specifications given under Section-V and Schedule of Quantities of Tender document and shall confirm to the relevant BIS codes and other relevant codes. However, the bidder may suggest any equivelent make/ model/brand meeting technical parameters on or before pre-bid conference for approval of BARC(V). 2) The Scope of works which are not included in any specific items but indicated in the document "General Scope of all works" shall be within the scope of overall contract works. The cost of work/item/material indicated in this document shall be deemed to be included in the quoted rates of all individual items. 3) The quoted rates shall include necessary taxes, royalties, seigneiorage charges,etc. and all other charges to supply all the required construction materials. 4) For all standards and code of practices, specifications, like Indian Standard, MORT&H, ASTM, etc. refer only latest revisions including all applicable amendments, revisions and additional publications (during contract period) and these have to be followed. 5) Prior approval for source of all construction materials by submission of relavent test certificates, documents, invoices etc. have to be taken from BARC. 6) The contractor has to submit all royalty /seigneiorage slips,etc for all the naturally available construction materials before submitting the RA bills. 7) All dismantel items shall be handed over to BARC(V) in good condition. 8) All transport for men and materials inside BARC main campus and Anu Vihar shall be in the scope of contractor.

Providing and fixing Powder coated (minimum thickness of powder coating 50 micron) aluminium work for shutters, windows, ventilators, Alu Louvers, wall spans and partitions etc. with extruded built up standard tubular sections / Z Sections and other sections confirming to IS 733 and IS 1285 fixed with rawl plugs and stainless steel screws or with fixing clips or with stainless steel expansion hold fastners including necessary filling up of gaps at junctions, at top, bottom and sides with required PVC / neoprene felt etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically where ever required including cleat angle, Aluminium snap beading for glazing / panelling, C.P brass / stainless screws all complete as per architectural drawings and as per direction of Engineer-in-charge including providing and fixing hinges / pivots and making provision for fixing of fittings wherever required including the cost of PVC / neoprene gasket required. (Weight of the Aluminium sections shall not be less than Specified in the drawings). The work shall be carried out complete as per approved shop drawing and the relavent portion of technical specifications and as directed by Engineer-in-charge.

Providing and fixing 12 mm thick WPC (wood plastic composite) Flush door shutters of minimum density 0.6 gm/cm3 with specified color and pattern of design. complete all as per specifications and as directed by the Engineer-in-Charge. Note : 1. WPC Door sample to be got approved by the Engineer-in-Charge before procurement. 2. The quoted rate shall include cost of fixtures, paint mentioned above including the WPC shutter and frame.