Zilla Parishad Tender

Supplying ,Fitting & Fixing Of Poly Crystaline Module- 100 WP ( ERTL and Flash Tested) I. The PV module shall contain crystalline silicon solar cells and must have a certificate of testing conforming to IEC 61215 Edition II. The power output of the module(s) under STC would be a minimum of 75 Wp at a load voltage* of 16.4 ± 0.2 V III. The open circuit voltage* of the PV modules under STC would be 21.0 Volts IV. The module efficiency would be 14.5% V. SPV module shall be highly reliable, lightweight and shall have a service life of more than 25 years. SPV modules shall have a limited power loss of not more than 10% of nominal output at the end of 10 years and not more than 20% at the end of 25 years VI. The solar module shall be able to withstand the following environmental conditions normally encountered at site – Temp. extremes ranging from -100 C to +850 C Wind load (WAAREE/ TATAPOWER /BIKRAM) with all are MNRE APPROVED

24 Watt LED with 36 AH Li-FePO4 Inbuilt Battery & MPPT Charge Controller with 5 Years Warranty With 3 Miter Cable-2.5 Sq.mm for battery charging GOODNICK ELECTRONICS/ PHILIPS/HAVELLS

G I. Pole (Folding) with Module Mtg Structure, Luminaire bkt. I. A corrosion resistant metallic frame structure must be fixed on the pole to hold the SPV module. II. The frame structure must have provision to adjust its angle of inclination to the horizontal between 0 and 45, so that the module can be oriented at the specified tilt angle. III. Pole height: Fledge 2 PART 6.5 Mtr. (Dia = 76 mm X 63 mm) With grounding facility (Corrosion resistance) & 2.5mm thickness IV. Necessary Supporting Parts also be attached for Solar panel and light and battery V. GI Display board also be attached size 0.45 mt X 0.45 mt. at the hight of 2.5 mt from ground level JINDAL/TATA/ NEZONE