Municipal Affairs Department Tender

Tack Coat Providing and applying tack coat with Cationic Bitumen Emulsion of approved grade conforming to IS:8887-1978 on the prepared surface cleaned with Hydraulic broom, moistening the surface including cost and carriage of emulsion, hire charges of machinery and labour, cost of fuel and lubricants all complete asper Clause 503 of Specifications for Road & Bridge Works of MoRT&H (5th Revision).

On Bituminous Surface (Using Bitumen Emulsion at the rate of 0.20 to0.30 kg per sqm.)

Mastic Asphalt Providing and laying Mastic asphalt wearing course with paving grade bitumen meeting the requirements given in table 500-29 using approved coarse aggregate,fine aggregate, filler material and bitumen, prepared by using Mastic cooker including cost and carriage ofall ingredients, cost of heating aggregates and binder,mixing in specified proportions conforming to approved Job Mix Formula and laid to required level and slopeafter cleaning the surface, compacting, sealing the construction joints and surface finishing conforming to specifications including providing antiskid surface with bitumen pre-coated fine-grained hard stone chipping of13.2 mm nominal size at the rate of 0.005 cum per 10sqm and at an approximate spacing of 10 cm center tocenter in both directions, pressed into surface when the temperature of surfaces not less than 100°C, protruding1 mm to 4 mm over mastic surface, including the hire charges of all tools and plants and machinery, pay of operators, cost of

25 mm thickness

Retro reflective Road Marking (Cold applied)

Supplying & fixing of Raised PavementMarkers I Road Studs I Cats Eye made ofpolycarbonate moulded body and reflectivepanels with micro prismatic lens capable ofproviding total internal reflection of the lightentering the lens face which shall support a loadof 13635 kg tested in accordance to ASTM D4280 Type H and complying to clause no 804 ofMoRT&H's specification for Road &Sridge Works(Fifth Rev.). Marker height shall not be less than10 mm and shall not exceed 20 mm, width shallnot exceed 130mm and with minimum reflectivearea of 13 sq.cm. on each side and slope to thebase shall be 35 ± 5 degree. Fixing will bewithout nails but by using epoxy resin basedadhesive as per manufacturer's recommendationincluding site clearance etc. and complete asdirected by the Engineer in Charge .Thecontractor will have to provide a test certificatefrom a reputable national/international laboratoryconforming the above specifications.

Direction and Place Identification Signs with size more than 0.9 sqm size Board.Providing and erecting direction and place identification retro- reflectorised sign as per IRC :67 made of high intensity grade sheeting vide clause 801.3,fixed over aluminium sheeting, 2 mm thick with area exceeding 0.9 sqm supported on a mild steel angle iron post 75 mm x 75 mm x 6 mm, 2 Nos. firmly fixed to the ground by means of properly designed foundation with M 15 grade cement concrete 45 cm x 45 cm x 60 cm, 60cm below ground level as per approved drawing and Clause 801 of Specifications for Road & Bridge Works of MoRT&H (5th Revision)..

GST 12%

LWC 1%