Muzaffarnagar Development Authority Tender

Cement Concrete with 2 cm gauge stone grit, approved coarse sand, cement in proportion of 4:2:1 including supply of all materials, labour, T&P etc. required for proper completion of the work. SI No. 279(a)

12mm thick plaster with cement and fine sand mortar in 1:4 over brick work minimum thickness not to be less than 1cm including supply of all materials, labour, T&P etc. required for proper completion of the work. [S.I.no. 584].

Supply and laying of 40mm gauge dry brick ballast all complete as direction of the E/I.

Construction of un-reinforced dowel jointed at expansion and construction joint only, plain Cement Concrete pavement, thickness as per design, over prepared sub base with 43 grade cement and any other type as per clause 1501.2.2 (1:1.5:3) coarse and fine aggregates confirming to IS: 383 maximum size of coarse aggregate not exceeding 25mm mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weight batcher using approved mixed design, laid in approved fixed side from work (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the framework as per drawing) spreading the concrete with shovels. rakes compacted using needle, screed and plate vibrators and finished in continous operation including provision of contraction and expansion, construction joints as per norms, applying debonding strips primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved curing of concrete slabs for 14 days, curing compound (where specified) and water finishing to lines and grade as per drawing and technical specification clause 1501 including cost of polythene sheet and dowel bars and also including complete shifting of materials and concrete etc. But when thickness of CC is less then 20cm (With Out dowel bars) New Item - 9(1)/road

Supply and Laying of 80mm thick coloured ISI marked I shaped mechanically compressed interlocking cement concrete paver blocks with top layer of minimum 8mm thickness O.P.cement having plan dimension 200x(160+120mm) , smooth high gloss finish, skid resistant manufactured from rubber moulds through vibro-compression mechanism. The compressive strength of concrete paver blocks shall not be less than 30Mpa (M-30) and weight 5.0 kg per no. confirming to IS:15658-2006 including cost of all materials, labour, T&P etc., laying with a blanket layer of 4.00 cm thick local sand including leveling and dressing surface up to required level and slope filling joints with local sand including all required for proper completion of the work as directed by the E/I.