Military Engineer Services Tender

S&F for wall mounted fan 300 mm sweep, 230V, AC with built-in regulator and swing function including electric connection from ceiling rose to fan connector with PVC insulated 2 core copper cable of size 0.75 Sqmm complete all as specified. [Model 'Swing' of make: Havells or its equivalent in Almonard/ Bajaj/ Crompton]

M&L for submain wiring with two single core FRLSH PVC insulated flexible copper conductor of size 2.5 Sqmm 1100 Volt grade and one single core PVC insulated FRLSH flexible copper conductor cable green colour of size 2.5 Sqmm as earth lead in and including a separate concealed PVC conduit medium grade ISI mark of dia not less than 25 mm including cutting chases to walls for laying conduit and making good the disturbed wall surfaces to match with existing surface complete all as specified.

M&L for submain wiring with two single core FRLSH PVC insulated flexible copper conductor of size 4 Sqmm 1100 Volt grade and one single core PVC insulated FRLSH flexible copper conductor cable green colour of size 4 Sqmm as earth lead in and including a separate concealed PVC conduit medium grade ISI mark of dia not less than 25 mm including cutting chases to walls for laying conduit and making good the disturbed wall surfaces to match with existing surface complete all as specified.

S&F for switch piano flush type one way 5 Amp SP 240 volts complete all as specified.

S&F for socket outlet 2 in 1, 5 pin 5/6 Amp flush type 240 volts complete all as specified.

S&F for ceiling rose of size 65 mm x 50 mm three terminals complete all as specified.

S&F for flush mounting factory made Ekinoxe SPN distribution board, double door, IP-43 Protection, IK-09 with metal door, with neutral bar, earth bar and cables ties for cable management fully insulated bus bar 4 way with 100 Amp rated bus bar complete all as specified.

S&F for MCB SPN (single pole and neutral) 40 Amp 240 Volt, breaking capacity 10 KA, ‘C’ Series complete all as specified.

S&F for MCB SP (single pole) 6 to 32 Amp, 240 Volt, 50HZ, 10 KA ‘C’ series complete all as specified.

M&L for earthing complete with Copper earth plate electrode 600 mm x 600 mm x 3 mm thick buried directly in ground (earth pit not less than 2.25 metres deep below ground level) with top edge of earth plate not less than 1.5 metres below normal ground level connected to Copper earth strip of size 20 mm x 3 mm by means of bolts, nuts, check nuts and washers of copper all as shown on electrical plate No. 3 of MES Schedule Part-I and connected to main switch board/main DBs / earth test point including all necesary excavation and earth work in any type of soil, adequate quantity of charcoal dust and common salt all around the earth plate in alternate layers minimum 150 mm (compacted thickness) in all directions with and including watering pipe 20 mm dia galvanised iron medium grade, galvanised iron funnel made out of 0.63 mm thick galvanised iron sheet, wire guage, 50 mm thick RCC cover of size 450 mm x 450 mm in cement concrete 1:2:4, type B-1 duly reinforced with 8 mm dia mild steel TMT bars @100 mm both ways center to center with suitable lifting handle made of 10 mm dia mild steel round bar to lift the cover, earth pit of PCC 1:3:6 type C-1, galvaised iron protection pipe light grade 40 mm bore including testing on completion of job complete all as specified and directed.

S&F for single pointed air termination aluminium rod 12 mm dia and 300 mm long with all connected accessories and PCC block in 1:2:4 type B-1 of suitable size complete all as specified and directed.

S&F for test point terminal block made of gun metal or phosphorus bronze size 75 mm x75 mm x 25 mm drilled and screwed including 3 Nos 8 mm dia 25 mm long hex. head screws for holding the bronze plate including fastening/bolting the roof down conductor and earth electrode over the bronze plate with copper bolts and nuts of suitable size, providing 10 mm thick fibre sheet size 15 cm x 15 cm below the test point to avoid direct contact with wall including enclosing the test point with 1.6 mm thick mild steel sheet complete all as specified.

S&F for aluminium strip 20 mm x 3 mm size as in earth continuity conductor or main earthing lead buries in ground, fixed to wall or any other indicated situation for loop earthing and the like up to test point on necesary insulators and fastening screws, rawl plugs complete all as specified.

S&F for copper strip 20 mm x 3 mm size as in earth continuity conductor or main earthing lead buries in ground, fixed to wall or any other indicated situation for loop earthing and the like up to test point on necessary insulators and fastening screws, rawl plugs complete all as specified.

S&F for 40 mm bore steel tubing meduim grade galvanised with and including all galvanised iron fittings as reuqired at site laid in trenches, surfaces under floor or fixed to wall complete all as specified.