Military Engineer Services Tender

Taking down carefully old FTL/CFL fitting of any wattage/any other types of light fittings and making good disturbed surface of walls and floor etc complete all as spacified and directed

S&F MCB DB sheet enclosure single pole and neutral 240V with 200 Amp suitable size plate and common neutral link all enclosed in standard steel sheet flush mounting type factory fabricated complete confirming to IP 42/43 without MCB and with enclosure blank plates for unused way suitable for 12 way double door complete all as specified and directed by Engr-in-charge. Make : L&T/Schneider/Legrand/Hager

S&F MCB SPN 32 to 40 Amp 240 volts 10 KA 'C' curve breaking capacity complete as directed.

S&F MCB SP 10 to 32 Amp 240 volts 10 KA 'B' curve breaking capacity as directed.

S&F in replacement MCB, triple pole & neutral 63 Amp, 415 volts, 10 KA breaking capacity, 'C' curve complete all as specified and directed.

M & L of GI pipe light grade of 40 mm dia base in trenches/poles/walls for protection of cable including fittings

M&L for two single core PVC insulated cable with 6 sqmm nominal cross sectional area stranded copper conductor and one single core green PVC insulated 6.0 sqmm stranded copper conductor earth continuity cable drawn through non metallic rigid PVC conduit complete.(PVC Conduit and accessories shall be deemed to be included in the quoted rate)

M&L for two single core PVC insulated FRLS cable 10 sq mm nominal cross sectional area stranded copper conductor and one single core green PVC insulated 10 sqmm stranded copper conductor earth continuity FRLS cable drawn through non metallic rigid PVC conduit 20mm dia including all conduit and fixing accessaries concealed in wall including cutting chases in wall and making good disturbed surface to match of walls /ceiling complete. (Note-The cost of PVC pipe and accessoried shall be deemed to be included in the quoted rate)

M&L for earthing with galvanized steel earth plate electrode 600 x 600 x 6 mm thick buried directly in ground earth pit not less than 2.25 m below normal GL with the top edge of the plate not less then 1.5 m below the normal GL connected to GI wire 4mm dia protected by 15mm GI pipe (light grade) and watering pipe 20mm bore GI pipe (light grade) and chamber with PCC (1:4:8) type D2 using 40mm graded stone aggregate, coping with (1:3:6) type CI using 20mm graded stone aggregate and with RCC pit cover (50 mm thick) in 1:2:4 type B1 using 20mm stone aggregate, reinforced with 8mm for MS bar at 80mm c/c both way in lieu of CI pit cover with angle iron frame including excavation and earth work and removal of surplus soil of earth complete all as shown in electrical plate No 3 of SSR Part I and including charcoal dust, common salt and earth lead connected to earthing test point testing of earthing complete all as specified and directed by Engr-in-charge.NOTE: Main earthing lead and protection GI pipe from earth electrode to test point up to 7.5 m is to be provided and the cost for the same shall deemed to be included in the above quoted rate.

M & L Galvanised steel wire 4 mm dia as continous earth wire including stringing for earth conductor for pole, including binding etc, fabrication,of cradle guards, hexagonal/ rectangular complete all as specified and directed by Engineer-in-Charge.

M & L for repair/construction of earthing pit chamber with PCC (1:4:8) type D2 using 40mm graded stone aggregate, and Cast iron frame including excavation and earth work and removal of surplus soil of earth complete all as specified and directed.

S & F MCB DB TPN 4 Way (Vertical Type) double door, for mounting, MCBs, isolator, ELCBs etc factory made, confirming to IS: 13032 fabricated out of CRCA sheet not less than 1.2 mm thick fitted with DIN channel, neutral link and 200 Amps rated bus bar including 100 Amp MCCB , DBs shall be semi glossy finished with epoxy polyester based powder paint sprayed and backed at high temperature, between powder paint process the sheet steel having to go through the anti rust conditioning in not less than seven tank process to ensure smooth finish and protection against corrosion atmosphere. The DBs shall be double door type with hinged door with locking arrangement. The DBs shall be of same make as MCBs /Isolator. DB shall also be provided with label marking indicating the incoming and outgoing circuits on all way as specified. The DBs shall be of IP 42 protection class.

S&F MCB DB sheet enclosure single pole and neutral 240V with 200 Amp suitable size plate and common neutral link all enclosed in standard steel sheet flush mounting type factory fabricated complete confirming to IP 42/43 without MCB and with enclosure blank plates for unused way suitable for 2 + 8 way double door complete all as specified and directed by Engr-in-charge. Make : L&T/Schneider/Legrand/Hager

S&F in repair MCCB 63/100 Amp 415 V, 4 pole, breaking capacity 16 KA complete all as specified and directed by Engr-in-charge.

M&L for two single core PVC insulated FRLS cable 6 sq mm nominal cross sectional area stranded copper conductor and one single core green PVC insulated 6.0 sqmm stranded copper conductor earth continuity FRLS cable drawn through PVC conduit 20/25mm dia including all conduit and fixing accessaries concealed in wall including cutting chases in wall and making good disturbed surface to match of walls /ceiling complete. (Note-The cost of PVC pipe and accessoried shall be deemed to be included in the quoted rate)

S&F 5/6A switch piano,, 230 volts complete all as specified and directed,

S&F socket outlet 5/6A, 5 pin, 230 volts complete all as specified and directed,

S & F cabin fan AC single phase, 230/240 Volt heavy duty of size 300 mm sweep and making connection with three core PVC insulated and sheathed copper conductor flexible cable complete all as specified and directed.

S&F of exhaust fan made of sturdy Engineering plastic body complete with louvers shutter single phase, 230/240 V, 50 Hz of size 250 mm sweep 1100-1325 RPM copper winding and making connection with three core PVC insulated and sheathed copper conductor flexible cable of size 1.5Sqmm complete all as specified and directed

M & L for cutting, opening Square/circular in shape, through brick wall of 230 mm thick built in Cement mortar required for fixing of 250 mm dia exhaust fans including making good the surrounding of opening Jambs, cills etc in PCC 1:2:4 type B-0 (using 12.5 mm grade stone agg ) complete all as specified and directed

S & F Thermal Auto clean Filterless Hood Wall Mounted Kitchen Chimney, Suction Capacity 1350 m3/hr and touch control type, metal bar oil collector, LED lamp, minimum 60 cm, motor power 160 Watt including civil work (cutting of holes, making good to disturbed surface as per existing) as specified and directed by the Engineer-in-Charge. Note:- Two year comprehensive maintenance shall be provided by contractor without any extra cost to department and contractor shall undertake warantee/Guarantee as per manufacureres policy. Brouchers and literature shall be submitted after installation. Make:- Elica,Glen, Faber,Hindware

M & L for 6 inch aluminium chimney exhaust pipe/chimney installation kit/pipe & cowl cap, tape for all grand chimneys (flexible aluminium duct pipe up to 10 feet) complete installation Kit with free Cowl and @m tape and clamp all as specified and directed by the Engineer-in-Charge. Make:- Ardnib, Oxyair,Solanki, Oicota, Lifeplus

M&L for point wiring complete for one light point or one fan point controlled by one, one way 5 Amp switch with PVC (FRLS) insulated unsheathed multistranded copper conductor of size 1.50 sqmm nominal cross sectional area single core drawn through PVC conduit 20/25mm dia including all conduit and fixing accessaries concealed in wall including cutting chases in wall and making good disturbed surface to match of walls /ceiling complete. including pressed steel concealed terminal switch boxes not less than 1.6mm thick of reqd size factory made duly painted inside and outside with one coat red oxide primer, 3mm thick plastic laminated bakelite sheet top cover (ISI Marked) fitted with chromium plated brass screws & washers complete including 1.50 sqmm nominal cross sectional area PVC(FRLS) insulated unsheathed multistranded copper conductor green as earth wire connected to earth dolly with all accessories complete all as specified and directed. (Note-The cost of PVC pipe and accessoried shall be deemed to be included in the quoted rate) into conceled conduit,

All as per item no 26 above but for one 5 pin 5 Amp socket outlet point on an independent board.

S&F ceiling rose surface bakelite three terminal complete as directed.

S&F in replacement angle/batten type holder insulated body with back plate suitable for batten fittings as directed

Supply and Fixing wall/surface mounting luminaires integrated LED Batten 20/22 W, 6500 K,110 lumens/watt , 230V with extruded Aluminium housing 4 feet long with frosted PMMA/PC diffuser & integrated electronic driver, 25k burning hours ,2.5 KV surge protection complete including Electrical connection with PVC three core copper flexible wire & all necessary fixing arrangements all as per specified and directed by Engr-in-charge

S & F in replacement FTL fittings with decorative LED batten made up of aluminium casting 18/20 W of size complete standard fittings and fixtures including fixing on walls/roofs/ through MS downrod suspended type with fitting arrangement including neccessary elect connection from ceiling rose to luminaries with suitable size PVC cord complete all as directed. Make: HAVELLS with cat Part No. REGALBATTEN8UPTO1X22WDSBSWH ,or of equivalent as specified and directed by Engineer in Charge.

Supply and fixing in repair Material glass led tube ,voltage range 220-240v-50hz ,cct 6500k,lumen ,wattage 20/22W surge 2.5kv ,CRI 70 POWER FACTOR _0.9 ,sigle side BURING HOURS 25K HOURS 110 L/W ,6000 K with high efficency, with neccessary electrical connection incl disconnection old elecronic ballast if any complete all as directed.

S& F in repair Decorative wall light fixture made up of Metal base, synthetic white in colour and square/round metal base with bend pipe and glass globe with nickel finish, ( B-22/E27 base), with 01 No. 7/9 W LED Bulb, 230 V, 6000K, complete incl all required electrical connecting arrangements all as specified and as directed. Make Phillips Model Grace / Bajaj / Havells decorative model Floretine WL 1LS B22 SS ( Note: Rates shall be including 01X 7/9 W LED Bulb with each fitting)

Supply and fixing wall/surface mounting luminaires (Mirror Light) integrated LED Batten( 2 feet) 10/12 W, 6500 K, 230V , minimum 110 lumens/watt,with extruded aluminium housing & integrated electronic driver complete including Electrical connection with PVC three core copper flexible wire & all necessary fixing arrngements all as per specified and directed by Engr-in-charge.

S&F in repair super bright LED (2X2), 36 W, 6500 K recess mounting minimum 110Lumens/watt IP20 ,IK02 PF.9 and 4kv inbuilt surg protection with high efficent LED source all as per specified and directed by engineer in charge.

S&F 9 watt LED bulb (lamp) all as specified and directed by engineer in charge.

Supply & fixing bulk head light fitting made from cast aluminium body with heat resistance pressure die cast housing, IP-65 and IK 08 protection cover suitable for bulk head fitting integrated type 10/12W LED, 6500K , 110 lumens/watt including inbuilt electronic driver complete all as specified and as directed.

S&F in repair LED Building security light 20/25 Watt with high power LED source (100 lumen/watt) PDC housing, IP66 and IK 07 with 4 KV inbuilt surge protection ,minimum 50000 burning hours hv cutoff@325/440 volt protection for 8 hours including Electrical connection with PVC three core copper flexible wire & all necessary fixing accessories , as specified and directed by Engr-in-charge.