Directorate Of Health Services Tender

Auto Analyser • It should be Automated, Discrete, Random Access; patient prioritized Clinical chemistry Analyzer capable of performing biochemistry and immunoturbidimetry assays. • It should be a floor model. • The throughput should be at least 400 tests/hr photometric tests for a cycle of 9 seconds and 640 tests/hr with ISE (optional). • It should have more than 52 on line chemistries. • It should not have any limit on number of programmable Chemistries, Profiles and Calculation Item. • It should accept Linear, Non-Linear, Multi Point Calibration. • Sample disk should accept minimum 75 samples at a time. All the positions on the sample disk should accept STAT samples, blanks, controls, standards and ISE solutions. • It should accept 5 ml, 7 ml, 10 ml and sample cups for keeping samples. • The sample pipetting should be between 2 – 70µl in steps of 0.2 µl. • It should have a sample probe & two separate reagent probes for R1 & R2. • The reagent tray should be cooled at 4degree C to 12degree C and should have 56 reagent bottles. It should accept 20 ml, 50 ml bottles and 5 ml adapters. • Display of Reaction Cuvette temperature and Reagent Tray temperature should be available on Screen. • Biohazard waste should be collected in a separate container. • System should be capable of performing 2 Reagent Chemistries. • It should have fixed barcode reader for both reagents and samples (Optional). • Reagent pipetting should be between 10 – 300µl in steps of 1 µl. • The reaction cuvettes should be 72 permanent hard glass cuvettes maintained at 37 degree C ± 0.2 degree. • On line Reaction Graph should be displayed on the screen and all the reaction graphs should be stored in the memory. • The minimum reading volume should be 180 µl. • It should have on board laundry for washing of the cuvettes. • Photometer should consist of 12 wavelengths in the range 340 to 750 nm. It should be capable of doing Monochromatic and Bichromatic measurements. • Light source should be pre aligned Halogen Lamp (12 V/20 W) • Absorbance range should be 0.0 – 3.0 Abs. • It should have extensive Q. C. program. Should show daily and monthly Levy Jennings Chart and Twin Plot. • It should have facility of auto re-run, auto dilution of sample facility, • Facility of Skipping of dirty cuvettes should be available. • The mixing stirrer should have user defined variable speed (minimum 3 speeds). • Probe should have Vertical obstruction Detection.Power Requirement should be AC 110 V ± 10% Hz and 60 ± 1 Hz or AC 220 V ± 10% Hz and 50±1 Hz.