Municipal Administration And Water Supply Department Tender

Painting two coats of newly plastered wall surface with ready mixed Cement paint of first quality and of approved colour over a priming coat including preparing the surface, clean removal of dirt and including necessary plaster of paris putty wherever required etc., complete complying with standard specification.

Geophysical Investigation charges

Drilling of borewell anywhere in tamilnadu including transportaion from one place to another place within tamilnadu in alluvial soil or sedimaentary strata of clay and sand ,stone,pebbles,boulders etc.,by first taking a pilot bore of 140mm/150mm dia upto 60m depth ending below ground level.Then enlarging to required dia by direct or reverse rotary mud and circulation method using contractor's rig ,fuel, labour , drilling betonite mud and water required for drilling at the site shown by TWAD officer's

supply and delivery of 150mm dia OD PVC Plain casing pipe etc., complete as per standard specification.

supply and Fixing 150mm Borewell PVC EndCap complete as per standard specification.

Supply & Fixing of 50mm MS clampset etc.,

supply and Delievery of 1.50 H.P.vertical submerible motor pump set Suitable For 20 LPM x 125 m Head and single Phase, 240 V etc., compete as per standard specification

Labour charges for fixing 1.5 Hp submersible motor pump set etc., complete.

Supply & Fixing of Wooden metre board etc.,

Supply and delivery of 2.0 H P panel board and accessories including all fittings suitable for Three phase pumpset as per schdule for the following

Supplying and Fixing of 1000 lit Capacity PVC Tank With I.S.I.Specification.

supply and fixing of 4.00 Sq.mm pvc sheathed 3 core copper Flat type cable with ISI specification.

supply and fixing of 50 mm dia H.D.P.E.Hose pipePN 10 kg/cm2 with ISI specification.

Supply and fixing of 1" plactic paper rope as per standard specification

Supply and delivery of MS Kisok of size 0.75m x0.45m x0.75m made up of Ms Angle of Size 50mmx50mmx4mm alround covered with 16 guage MS Sheet and Kisok door made up of MS plates of size 25mm x 3mm including cutting ,welding,grinding,locking arrangements

Supply and run of 7/20 PVc copper wire including all cost of conveyance and all labour charges etc.,complete.

Supply and fixing of 20 mm GI pipe B class including all cost of conveyance and all labour charges etc.,

Supply and fixing of 62 Amps MCB 250V/415V 50HZ Triple pole & Neutral 6A to 32A&10 KA with ISI specification.

Supply and fixing of 32 Amps Fuse unit with ISI specification.

Providing earthing as per standard specification.

Supply and Fixing of 32 mm UPVC pipe

Supply & Fixing of pvc pipes & Specials etc 25mm pvc pipe

25mm PVC elbow

25mm PVC coupling

25mm PVC Tee

PVC screw down tap heavy type 20 mm dia.

Supply and fixing of single box type 4'36W fluorescent fitting complete with electronic ballast with TW round blocks on wall or ceiling with flu tube with PVC unsheathed Copper leads from terminals to the fitting (SD 87 - PWD Elec data 2023-2024)

Paving the floor with design Antiskirt ceramic tiles (colour and shade as directed) of size 305 mm x 305mm x 6 mm in all floors over a base layer of cement mortar 1:3 (One part of Cement and Three part of Plastering Sand (P- Sand)), 20mm thick laid in-situ and pointed with same coloured cement

Dadooing walls with Glazed tiles of sizes 305mm X 200mm X 6mm size of approved make and quality and colour Set in cement mortar 1:2 (One part of Cement and two part of Plastering Sand (P- Sand)) over 10 mm base layer plastering and pointing with white cement neatly as directed.

Manufacturing supplying and fixing of MILD STEEL DOOR made out of 50 x 50 x 6 mm M.S angle for outer frame,35 X 35 X 5mm M.S.Angle for outer frame of shutter. The entire shutter area shall be covered with CRC sheets (18 G) with 5Nos, of stiffners using M.S.Flats of size 25 X 6mm at equal intervals horizontally. The corners of the frames and shutter with CRC sheets shall be welded by adopting flash butt welding or any other suitable method. Provision towards 3Nos, of Hinges incase of single shutters / 6Nos,of Hinges incase of Double shutters of 125 X 31 X 1.25mm size placed at appropriate intervals and provisions shall be made for Tower bolts 2Nos, Aldrop 1No. The frame shall be provided with 6Nos,of Hold fast of 200mm length using 50 X 6mm M.S.Flat. The entire frame and shutter shall be provided with one coat of red oxide primer including cost of hold fasts,hinges, locking arrangements, handles wind appliences etc., complete and as directed by the departemental officers.

Painting two coats with Ready Mixed Enamel Paint over the new iron works of approved quality and colour without priming coat including the cost all materials etc.,complete, in all floors.

Add GST