Municipal Administration And Water Supply Department Tender

Plastering with cement mortar 1:5 (One cement and five sand) 12mm thick in all floors including cost and conveyance of all materials to site etc,complete as per standard specifications

Supplying and fixing of 48W LED Street fitting with LED ( Higher end ) with 32mm dia.GI pipe ( class B ) with 1 no 32mm GI bend complete on the exisiting post / on wall with PVC unsheathed copper leads with MS clamps and with Painting . SD 448

Providing UPVC ( Un-plasticized polyvinyl chloride ) Door ; providing and fixing casement doors fabricated from un-plasticized polyvinyl chloride ( UPVC) sections Profiles ; The profiles should be three chamber system which provides high inusulation properties with outer frame 60mm x 55mm with an outer wall thickness of 2.4mm. The window unit should be desigend with all corner joints mitred and fusion weleded . windows should be steel reinforced wit 25 x 24 x 25mm steel reniciforcement with a thickness of 1mm to have dimensional stability. The sash should be of 60 x 102mm . The mullion should be of 60 x 74mm . The profiles should have co-extruded seals. Hard ware ; All the hard ware like friction stays , handles should be screwed with self tapping screws . The handles, locks should be desgined so that they cannot be released from outside . Glazing ; The window system should be glazed with 5mm plain float glass / 6mm bision lam. Installation ; The profiles should be cut to length and welded 45 degrees. The window should be desgined such that the water drainange does not pass throught the reniforcement chamber. The window system should be fixed directly to the plastered brick wall using self expanding nylon plug and driving ms electroplated screws into plug . (M-0673-RS.8313.00 - Less 5mm Glass cost Rs.500.00 + AddTuffen glass cost Rs. 1150 = Total Rs. 8963.00)

Supplying , erection fixing and installation of Pre cost / predressed concrete ring of Mix 1:1:2 ( cement :m sand :metal chips 4 of 6MM size ) element in correct and final position with proper line level and plumb at site making all arrangements such as push and pull rope and all other tools and plants for lifiting placing and alignments of elements with in correct tolerance as per IS 15916 and all complete etc as directed by departmental officers . 3 feet outer diameter of 38MM prestressed concrete wall thickness with 38cm height .

Manfacturing, supplying and fixing precast Reniforced Cement Concret slabs in RCC 1:2:4 ( one cement , two crushed stone sand and four aggregates ) , using following HBGS jelly excluding cost of moulding charges , casting of slabs , finishing , curing and fixing in postion in all floors etc,complete complying with standard specification and as a directed . ( 50MM Thick )

Plain Cement Concrete 1:1.5:3 (one cement, one and half fine aggregates and three coarse aggregates) using 20mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges and all incidential charges etc., complete as per standard specification

Supplying and laying Interlocking paver block M40 grade Providing and laying of 83mm thick high strength type conforming IS 15658-2006 Interlocking paver lock in size of minimum compressive strength of 40N/mm2 in uniform shape of approved make to be laid in flurring bone pattern with stone dust cushion below the uniform shape of approved non skitting surface in the top and the rate including levelling the base preparation of pavers as sub base,sand cushion 150mm thick laying out of pavement cut the pieces to fix the edge vibrating the pavers, sweeping tranporting loading unloading of laying paver block as per standard specification.,

Control panel consisting of PLC and MCBs, Contactors , overload relays , Time totalizers , push button units, ON/OFF switches , Indication lamps, Digitial Volatameter with selector switch , 3 point temperature recorder , Terminals for connection leads ( There will be a separate control panel as a stand by to the PLC system with 12 ON/OFF swiches to be used as stand by to be PLC system )

Supply and erection of 25KVA Diesel Generator set with acoustic enclosure conforming to CPCB IV + Norms and BIS Specfications . SOR -Page - 229 ( M - 2345 )

Supply and fixing of ATS Control power panel for 25KVA Diesel Generator set . (MR)

Painting two coats of newly plastered wall surface with approved cement paint over cement plastered wall surface, ceiling and including preparing the surface, clean removal of dirt and including necessary plaster of paris putty wherever required and cost of painting materials, brushes, preparation of surfaces and scaffolding charges etc., complete complying with standard specification and as directed by the departmental officer

Charges for Structural designing of the Effulient Treatment Plant as per Polluction Control Board rules and preparation of drawings ,site plan, building as fitted drawings etc documents for grant an approval

Supply and delivery of Single Phase 2.0 HP Submersible pump 20x150 lpm/m set with including cost and conveyance to work site and handling charges etc complete TWAD SOR P.87

Supplying, laying and jointing PVC pipes (having working pressure 10 kg. / sq.cm) of approved quality and best variety conforming to BIS of the following dia including cutting, threading and fixing PVC specials using PVC adhesives (but excluding cost of such specials) and fixing into wall with teak wood plugs, PVC clamps and screws making holes on the wall (or) drilling holes in the roof and making good the dismantled portion to original condition with necessary brick work / cement concrete and plastering neatly wherever necessary with necessary scaffolding charges, etc., complete complying with standard specifications. The PVC pipes shall be got approved by Executive Engineer before use on works.

25mm PVC Pipe

ETP area

25mm PVC Elbow

25mm PVC Tee

25mm Ball valve

Supply and fixing of Alumininum Dye Cast Letters of approved size and colour . The colour treatment process is achieved with MRF colour coat and then the processed coloured layer is set into the kin for the heat tretment process for the following sizes.

Aluminium Dye cast Letters 9'' size . M - 0692

Tamil Stainless Steel Letters 15'' size - M - 0703

Supply and fixing of PA Mixing Amplifier 240W with USD Drive operation as directed by Departmental officers concern . M - 2150

Supply and fixing of Wall speaker 30W as directed by Departmental officers concern . M - 2153

Supply and Laying of 2 core 1.5 sq.mm shielded copper speaker wire with PVC 19mm with clamp as directed by Departmental officers concern . M - 2158 ( Speaker wire Rs. 43 +19mm PVC pipe Rs.20 + Clamp and labour charges Rs. 45 = Total Rs. 108.00)

supply and fixing of 4U Rack with all acessories SOR Ele M-2225 P-166