Bhabha Atomic Research Centre Tender

Installation of Flame detector with address module, in inactive area this work includes fixing of 4-Way JB Box 120x120x60 mm in wall, 4 Nos of 12mm brass cable glanding in junction box ,Insitu drilling 4 nos of 12 mm holes using hole saw cutter (including supply of hole saw cutter ) in JB Box and 16 nos End termination of FAS system cables inside theJB Box connector this work includes tag preparation and praper leg crimping as per drawing and specification. Installation cost shall be including all fasteners as per the scope of work and as directed by the Engineer-in charge.

Installation of Beam detector with reflector and address module, in restricted area this work includes fixing of 4-Way JB Box 120x120x60 mm in wall, 4 Nos of 12mm brass cable glanding in junction box ,Insitu drilling 4 nos of 12 mm holes using hole saw cutter (including supply of hole saw cutter ) in JB Box and 16 nos End termination of FAS system cables inside theJB Box connector this work includes tag preparation and praper leg crimping as per drawing and specification. Installation cost shall be including all fasteners as per the scope of work and as directed by the Engineer-in charge.

Supply of 1 pair 1.5 sqmm armoured FRLS FAS cableas per technical specification.

Supply of 12mm brass cable gland as per technical specification.

Laying of 1 pair 1.5 sqmm FRLS FAS system cable in restricted area of open wall and ceiling and excavation trench. Installation cost shall be including all fasteners as per the scope of work as directed by the Engineer-in charge.

Laying of 1 pair 1.5 sqmm FRLS FAS system cable in inactive area of open wall and ceiling and excavation trench. Installation cost shall be including all fasteners as per the scope of work as directed by the Engineer-in charge.

Supply of standard route maker as per the specification

Supplying and filling in restricted area basement with Quarry dust, filling in layers of not more than 150mm thick, each layer well rammed and consolidated by hand/mechanical roller including watering, leveling, dressing the top surface to the required level complete all as per specification and as directed by the Engineer.

Providing and constructing brick masonry in restricted area at all lifts using well burnt stock bricks without cement mortar complete as per specifications and drawings for foundation, superstructure, etc. for the following floors. 2a) for Basement and Ground Floor (Refer note A in the reference column)

Earthwork excavation in restricted area by manual means for foundation, substructures, plinth beam, cess pits & trenches, all kinds of foundation etc., in all types of soil like hard gravelly soil, sandy soil for the following depth from average ground level up to the required founding level, line and grades in both dry and wet conditions including shoring, strutting, bailing out of water if necessary, leveling and ramming the bottom of trenches, dressing of sides, stacking the excavated materials away from the edge of trenches, refilling the sides of foundation as required with selected excavated earth and depositing / disposing the surplus excavated earth (Disposed soil to be leveled by breaking clods, if any and neatly dressed and leveled) within the lead specified below all complete as per specifications and as directed by the Engineer-in-charge.(2a) All kinds of soil with depth up to 1.5m below average Ground level and disposing surplus excavated earth up to a lead of 50 meters.