Swami Keshwanand Rajasthan Agricultural University Tender

Providing and applying tack coat with Bitumen emulsion (RS-1) using emulsion distributor at the rate of 0.25 to 0.30 kg. per sqm. on the prepared granular surface treated with primer & cleaned with Hydraulic broom as per MORTH Specification Clause 503.

Providing and applying tack coat with Bitumen emulsion (RS-1) using emulsion distributor at the rate of 0.20 to 0.30 kg. per sqm. on the prepared bituminous surface cleaned with Hydraulic broom as per MORTH Specification Clause 503.

Providing, laying and rolling of open graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using Viscosity grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80 -100 kN static roller capacity, finished to required level and grades to be followed by seal coat of either Type A or Type B or Type C as per MoRTH Specification Clause 510 Case II- By Mechanical Means Bitumen (VG-10)

Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type A, Type B and Type C as per MoRTH Specification Clause 511 (B) By Mechanical Means Case - II : Type B Bitumen (VG-10)

Proiding & laying 20 mm thick premix patching with 0.27 cum of stone chipping (0.18 cum of 13.2 mm size and 0.09 cum of 11.2 mm size) mixed with 14.6 kg. of suitable VG-Grade as per 10 sqm. of road surface including heating of binder and aggregate mixing of aggregate and binder, cleaning the area of patch, pot holes cut to regular shape with vertical side, removing all loose & disintegrated material, application of tack coat Bitumen VG-10 @ 2.25 kg. per 10 sqm, laying of patching material and compacting with 8-10 tonne power road roller including cost of bitumen, aggregate, fuel, lubrication, binder, hire charges of Machinery T & P etc.

Providing and laying factory made chamfered edge Plastic coated designer cement concrete paver blocks of required strength, thickness and size/ shape made by table vibratory method, to attain superior smooth finish using PU or equivalent moulds, laid in required Grey/ Yellow/ Red or any other colour and pattern over 50 mm thick compacted bed of Coarse sandcompacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand in footpath, parks, lawns, drive ways or light traffic parking etc. all complete as per manufactur’s specification and direction of Engineer incharge 60 mm thick C.C. paver block of M-30 grade with approved color design and pattern.

Providing and laying at or near ground level factory made kerb stone of M-25 grade cement in position to the required line, level and curvature jointed with cement mortar 1:3 (1 cement : 3 coarse sand ) including making joints with without grooves (thickness of joints except at sharp curve shall not to more than 5mm) including making drainage opening wherever required complete including painting etc. as per direction of Engineer-in-charge (length of finished kerb edging shall be measured for payment). (Precast C.C. kerb stone shall be approved by Engineerin- charge).