Ridcor Limited Tender
... More
If you're looking for Rajasthan tenders online and are tired of typing tender ID over and again or going through the cumbersome government websites for it, you are in luck. We have collated every Eproc Rajasthan tender on BidAssist. And for any queries related to an e-tender Rajasthan, like bidding process, registration process, etc., are explained below. Read on.
Costs
EMD
₹ 4,08,000Document Cost
Refer DocumentsTender Fee
Refer Documents
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2019_RIDCO_165661_3Bid Award Id
ViewTender No
NIT319Tender Authority
Ridcor Limited ViewPurchaser Address
-Website
http://https://www.ridcor.in/
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
Documents
BOQ Items
... More
Bituminous courses by mechanical means
609
-
-
... More
Granular courses by mechanical means
2741
-
-
... More
Roadway excavation including removal of unsuitable soil at embankment base necessary for construction of roadway in all types of soil including marshy soil as also excavation of existing shoulders and median to designated widths and depths in existing roadway embankment for purpose of pavement construction including transportation and disposal of surplus and unsuitable material complete with all lead & Lifts as per Technical Specification Clause 301. (orginal ground level shall be taken after clearing/grubbing operation) - All types of soil
1592
-
-
... More
Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site , spreading, grading to require slope and compacted by vibratory roller 8 - 10 Tonne to meet requirement of Table 300-2 as per MoRTH specification Clause No. 305
828
-
-
... More
Construction of granular sub-base by providing coarse graded material spreading in uniform layers with motor grader on prepared surface mixing by mix in place method with rotavator at OMC and compacting with vibratory roller to achieve the desired density complete as per clause 401 : For Grading-V Material as per MoRTH Specification Vth revision
1369
-
-
... More
Providing, laying, spreading and compacting stone aggregate for Wet Mix Macadam (as per table 400-12 and 400-13) specification including pre-mixing the material with water to OMC in wet mix plant as per approved design mix, carriage of mixed material by Tipper to site, laying in uniform layers with motor grader/front end Loader/paver finisher, in sub base/base course on a well prepared under base and compacting with vibratory roller to achieve the desired density including lighting, guarding, barricading and maintenance of diversion etc. (MoRTH specification Vth revision : Clause 406) by mechanical means with all lead
1569
-
-
... More
Construction of dry lean cement concrete Sub-base over a prepared sub-grade with coarse and fine aggregate confirming to IS: 383, the size of coarse aggregate not exceeding 25mm, aggregate cement ratio not to exceed 15:1, aggregate gradation after blending to be as per table 600-1, cement content not to be less than 150 Kg/cum, optimum moisture content to be determined during trial length construction, concrete strength not to be less than 10 Mpa at 7 days, mixed in a batching plant, transported to site, laid with a paver with electronic sensor, compacting with 8-10 tonnes vibratory roller, finishing and curing. Complete in all repect as per direction of Enigneer. (MoRTH Specification Vth Revision)
980
-
-
... More
Construction un-reinforced, dowel jointed, plain cement concrete pavement over a prepared sub base with 43 grade cement @ 400 Kg per cum, coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, laid with a fixed form or slip form paver, spread, compacted and finished in a continuous operation including provision of contraction, expansion, construction and longitudinal joints, joint filler, separation membrane, sealant primer, joint sealant, debonding strip, dowel bar, tie rod, admixtures as approved, curing compound, finishing to lines and grades as per drawing. Complete in all repect as per direction of Enigneer. (MoRTH Specification Vth Revision)
1980
-
-
... More
Thermoplastic pavement marking with hot applied thermoplastic materials for road markings with surface application of glass beads at specified rate complete as per drawing, Technical Specification Clause 803 and as directed by the Engineer. Thermoplastic marking with material conforming to Clause 803.4 of MoRTH having Tio2 (for white) minimum 10% and softening point 102.5 ±9.5°C. Complete in all repect as per direction of Enigneer.
-
-
-
... More
Lane, Centreline, Edge ,pedestrian crossing markings and other marking along strips for 2.5 mm thickness of marking(excluding drop on glass beads)
830
-
-
... More
Providing & fixing of Road studs(Swarflux) as per standards
418
-
-
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements