Military Engineer Services Tender

(b) Design parameters shall be as under :- (i) Grade of concrete - Not less than M-25 for buildings & not less than M-30 for water retaining structures. (ii) Grade of Steel - Fe500 TMT bars conf to IS-1750. (iii) Seismic Zone-III & fire rating to be considered as 1.5 hours (iv) Basic wind speed : 47 m/s. & Importance factor shall be considered S 1 for design. (v) Floor loads shall be as per codal provisions for the type of buildings (vi) All structural analysis and design shall be carried out using software STAAD Pro (latest version) with sound engineering practice and as per all Relavant IS codes. The format of the structural drawings shall be similar to that being followed in the design section of HQ CEJZ, Jodhpur. (vii) Structural design drawings shall be got vetted from any of IITs/NITs/any other reputed Government Engineering Collage. (viii) One set of structural drawing in hard and soft copy alongwith design calculation in hard copy and soft copy shall be submitted by the firm for approval by Dir (Design). After approval, submit the final structural drawings of Gateway Tracing Paper (95/100 gm/Sqm), one set in soft copy, ten sets in hard copies, design calculation in soft copy and hard copy. Note. (a) Quantities mentioned under column - 3 are provisional. (b) Unit rates are quoted against Ser Item No 1 above shall be deemed to be included any changes/revisions in the drgs till the physical completion of Main Job(s). Revised/Amended drgs shall be submitted by consultant to the client without any extra cost. (c) Rate Quoted shall Deemed to be include all levies sales tax, GST, Octroy and other taxes. (d) 10% of the payment shall be retained and released after physical completion of main job on account of site visit during execution of main contract and clarifications on structural drawings.

STRUCTURAL DESIGN, EVALUATION AND DETAILED STRUCTURAL DRAWINGS:- (a) Structural evaluation, analysis & structural drawing as per Approved Architectural Drawings for the works as given in Appendix 'E' :- (i) Detailed structural drawings of the footing and foundation i.e. plan, elevation, section with dimension in mm for columns including details of sub base for foundation and reinforcement details of pedestal (scale 1:50). (ii) Structural details of framed construction (Scale 1:50). (iii) Structural details (plan, section & reinforcement detailing) of plinth beams columns, lintel beams, roof beams, floor/roof slab and all structural members. (iv) Typical reinforcement details of all structural members mentioned in Para (i) to (iii) and other reinforcement details as per latest IS 456-2000, IS 13920-2016 & SP-34 including structural notes relevent to IS/SP. (v) Detailed drawings for expansion/crumple joints if required as per codal requirement. The design of hard standing as given in Architectural Drawings shall also be given.