Military Engineer Services Tender
If you're looking for Rajasthan tenders online and are tired of typing tender ID over and again or going through the cumbersome government websites for it, you are in luck. We have collated every Eproc Rajasthan tender on BidAssist. And for any queries related to an e-tender Rajasthan, like bidding process, registration process, etc., are explained below. Read on.
Costs
EMD
₹ 19,400Document Cost
₹ 500Tender Fee
Refer Documents
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2024_MES_635581_1Bid Award Id
ViewTender No
8230/E8Tender Authority
Military Engineer Services ViewPurchaser Address
-Website
http://defproc.gov.in
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
Documents
BOQ Items
S&F 11 to 15mm dia Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, exc 5cm but n.exc 10cm long complete all as specifird and directed by Engineer-in-Charge.
49
-
-
Supply only Chain link MS galvanised fencing, any size or type complete all as specifird and directed by Engineer-in-Charge.
800
-
-
Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specifird and directed by Engineer-in-Charge.
380
-
-
S&F round Mild steel bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and as line wire for chain link fencing complete all as specifird and directed by Engineer-in-Charge.
410
-
-
Supply and fixing in repairs galvanized 2 strand, steel barbed wire 2.24 mm dia, barbed with 2 mm dia barbs at 75 mm spacing and straining and fixing to any type of stranded rails, straining bolts, including securing or tying at crossing with and provisions of galvanized MS wire, staples or steel pins, etc as directed (Each line wire to b e measured) complete all as specifird and directed by Engineer-in-Charge.
8
-
-
Dismantling mild steel work of any description not otherwise complete all as specifird and directed by Engineer-in-Charge.
6.5
-
-
S &F framed work as in doors or gates of angle or other section with gusset plates, rails, braces etc complete drilled for fixing of steel sheeting or other covering. Door etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings and decorative cast iron artical etc complete all as specifird and directed by Engineer-in-Charge.
270
-
-
M&L for preparation of new steel surfaces and applying two coats of synthetic enamel paint over a coat of zinc primer complete all as specifird and directed by Engineer-in-Charge.
55
-
-
Demolition of stone masonry built in cement or cement lime mortar complete all as specifird and directed by Engineer-in-Charge.
89
-
-
M&L for squared rubble walling, Jodhpur type brought up to courses, well bonded, bedded and solidly hearted, built in cement mortar (1:6) complete all as specifird and directed by Engineer-in-Charge.
84
-
-
M&L for squared rubble walling, Jodhpur type brought up to courses, well bonded, bedded and solidly hearted, built in cement mortar (1:6) all as specified & directed. but except stone complete all as specified.
5
-
-
M&L for rendering 15mm thick on stone masonry surface in CM 1:4 and finish the surface even and Smooth without using extra cement complete all as specifird and directed by Engineer-in-Charge.
159
-
-
M&L for preparing newly plastered surfaces of walls and applying two coats of cement base paint over a coat of white wash complete all as specifird and directed by Engineer-in-Charge.
159
-
-
Demolition of plain cement concrete of any description and in any position below or above ground levelcomplete all as specifird and directed by Engineer-in-Charge.
11.6
-
-
M&L for plain cement concrete 1:4:8 Type D2 using 40mm graded aggregateas in foundation, filling in mass concrete complete all as specifird and directed by Engineer-in-Charge.
3
-
-
M&L for plain cement concrete 1:3:6 Type C1 using 20mm graded aggregate as in coping including form work etc complete all as specifird and directed by Engineer-in-Charge.
1.6
-
-
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements