Bhabha Atomic Research Centre Tender

Servicing of the following type of rolling shutters of different sizes maximum size upto 6m x 7m including dismantling for over-hauling of individual parts for repairing and refixing after repairs i.e. top hood shaft cage, shaft case shaft brackets, springs, main curtain with lathe or mid bar type grills, wicket gate, side guides bottom tails, gear units, bearings, electric motors, starters and thoroughly cleaning all the components, adjusting the tensioning springs, if required overhauling or repairing shaft and gear units, re-conditioning end clips, re-aligning curtain ends, reconditioning dents if any, on the surface bottom rail and side guides, repairing the starter, inspecting, taking out and replacing the damaged or defective components (replacement of parts at extra rate is shown under item No.2 below), ensuring proper locking arrangements from both side and outside including all welding, drilling straightening, grinding, scaffolding, ladders, tools, tackles, with all consumables, such as lubricants, kerosene, grease etc. and shall hardware such as nuts, bolts, rivets, washers, keys, etc. making good any damages to civil works, cleaning, oiling, greasing and demonstrating proper functioning of the shutters after each service such as nuts, bolts, rivets, screws, washers, keys and necessary scaffolding etc. all complete as per direction of Engineer-in-charge at site. Electrically operated type with lathe or grilled curtain, mechanical gear operated and pull & push type rolling shutters. (All types of Rolling shutters) Note : 1) Measurement will be done once only, for entire contract period. 2) The measurement of Rolling shutters will be as per structural openings, Hood etc. will not be measured separately.

Providing, Supplying and replacing in position wherever required the following parts after removing the damaged old part carefully including all labour, taxes, duties, scaffolding, transport, welding, drilling, grinding, tools, tackles etc. and with applying one coat of primer wherever required, including transporting the dismantled M.S/ metal scrap and depositing at Trombay stores as directed by the Engineer-in-charge at site. Up to 5.00 M Height

G. I. Laths - 18 G X 75 mm made from CRCA Sheet.