Military Engineer Services Tender
Bidassist is designed as a single destination for all government tenders from across the world in one place. If you require any information or detail about any e-tender the Ladakh government has posted, Bidassist helps a registered bidder to get the same.As BidAssist is a very user-friendly website it will help you find the specific Ladakh etender you're looking for. Read further to learn how to search and bid for etender Ladakh.
Costs
EMD
₹ 29,800Document Cost
₹ 500Tender Fee
Refer Documents
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2024_MES_683374_1Tender No
GE/KHU-57(R)/2024-25Tender Authority
Military Engineer Services ViewPurchaser Address
-Website
http://http://mes.gov.in/
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
Documents
BOQ Items
S&F for Pre- painted galvalume aluminum zinc coating GI based corrugated/semi corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified.
120
-
-
S&F Fibre glass reinforced translucent corrugated sheeting with two corrugations side lap fixed with coach screw and washer in roof, wall
90
-
-
S&F for Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as
specified
30
-
-
Taking down cement plaster on brick or concrete wall etc including racking out joints hocking for key scrubbing down with water etc.
60
-
-
M&L for rendering to brick/PCC block wall surfaces, 15mm thick in cement mortar 1:4, with WPC (as per manufactures instructions) complete all as specified
Note :- WPC should measured and paid separately
250
-
-
Supply only integral water proofing compound
18
-
-
M&L for rendering to brick wall surfaces, 15mm thick in cement mortar 1:6, finish even and smooth with or without using extra cement complete all as specified and directed.
30
-
-
M&L preparation of newly plastered surfaces and applying two coats of oil bound distemper on surfaces of walls over a coat of primer over 2mm thick wall care putty including preparation of surfaces complete all as specified and as directed by Engineer-In-Charge.
30
-
-
M&L for preparation of New plastered surface and applying two coat Cement base paint on wall over a coat of primer complete all as specified and directed.
250
-
-
Demolition of cement concrete (unreinforced) in ground floor and paving n exc 15 cm thickness (below or above GL).
6.5
-
-
M&L for 75mm thick, cement concrete, type C-1, 1:3:6 (20 mm graded stone aggregate) as in floors & pavings, plinth protection, path, etc. finishing top surface even and Smooth with using extra cement all as specified.
50
-
-
M&L for 100 mm PCC cement concrete type B2 1:2:4 (using 20mm graded aggregate) finishing concrete surface even and smooth with out using extra cement complete all as specified.
40
-
-
M&L for glass dividing strips, 3 mm thick and 28 mm width complete all as specified.
60
-
-
Dismantling wrought iron or mild steel work of any description not otherwise provided for all as specified and directed.
1
-
-
S&F Rolled mild steel in Joist, channel, angle, or tee sections, fixed independently, without connecting plates, etc (cut to ordinary lengths i:e within 20mm of the length indicated) FE 410-W (gde-E-250) quality-A complete all as specified and directed
100
-
-
M&L preparation of new steel surfaces of any description and apply two coat of synthetic enamel paint over a coat of red oxide primer, complete all as specified and directed.
325
-
-
M&L for preparation of old plastered surface and applying one coat Cement base paint on wall complete all as specified and directed.
1500
-
-
S&F in repair steel Rolling Shutters,1.25mm thick with ball bearing,as specified including top cover,anchoring rod,hasp and staple and one shop coat of primer ;erected in position as indicated, gear operated type with bevel gear box and crank handle incl complete accessories and fixing of guide to appropriate direction complete all as specified.
120
-
-
M&L for Providing servicing/ greasing to Steel rolling shutters where ever directed and specified, servicing/ greasing to all parts of a rolling shutter including guide channels, hood covers, gear rods, laths, lock rails, bearings, chains and other connected parts of all types of rolling shutterts, taking down the rolling shutter in any postion and any type where ever directed by Engineer In charge and carryout the repairs/ servicing / greasing and making into smooth operational condition as directed by Engineer In charge, top cover, anchoring rod, hasp and staple erected in same position or any other openings as indicated and make serviceable/functional and as directed, in repairs complete all as specified and as directed
136
-
-
M&L for preparation of old painted steel and Iron surface of any description, not other wise described over 10cm width or girth and applying one coat of synthetic enamel paint complete all as specified and directed.
1500
-
-
Deduct Credit for Demolished/Dismantled material Rs (-) 33750.00 (Minus) as listed in Schedule 'A' Sec-II (Credit Schedule)
Note : Tenderers will not quote against this item being a tentative amount, to be considered to arrive at the 'Contract Sum'.
-
-
-
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements
Past BiddersThis list is curated from the bidders of the similar tenders in the past
- Bidder NameThis Information is for unsubscribed user This Information is for unsubscribed user
- Awarded Ratexx%
- Bidder NameThis Information is for unsubscribed user This Information is for unsubscribed user
- Awarded Ratexx%
- Bidder NameThis Information is for unsubscribed user This Information is for unsubscribed user
- Awarded Ratexx%