Drinking Water And Sanitation Department Tender

Supplying installtion and commissioning of vertiucal turbine water lubricated pump water lubricated pump set of KIRLOSKAR/ JYOTI/Mathar and Platt/WPIL make having discharge 13.33 LPS against total head 25M with 60 FT column assembly, discharge head with suitable capacity vertcal hollow shaft squirrel cage induuction motor of KIRLOSKAR / JYOTI /CROMPTON GREAVES/ ABB make operated on 415 volts 10%, 3 phase 50HZ A.C. supply having speed 1460 rpm with non reversible ratchet, including cost of supplying fitting and fixing of all required accessories such as D.I. D/F Sluice valve, N.R. valve, pressure gauge, strainer, M.S. channel base plate as required, suitably automated star delta starter of L&T/MEI/CUTLER HAMMER/ JYOTI/ SIMENS make. ( Contractor will again have to check the design of motor, pump and he will get it approved by the deptt.) (pump & motor). Discharge 13.33 LPS, Head=25M and 10 HP. No of pump set= (1W+1S) and jointing it with rising main by constructing requried size header all complete. Discharge :- 13.33LPS; Head/25 (1w+1s) a) incoming feeder-TPN MCCB DTH-100 thermal release with adjustable realy haring and breaking capacity of 35A with rotary operating mechanism handle (front drive) L&T/ SIEMENS/ALSTOM/HAVELE/HPL make-1 no, 100 A MCCB as incoming feeder b) Outgoing feeder 32 A-415 V TP MCCB DL 100 having breaking capacity of 25 KA with rotary operating mechanism handle 9 front drive of L & T/HPL SIEMEN/ ALSTOM/HAVELE make -3 no including 1 no as as spare feeder c) Bus bar- 4 pole 100 amp. Copper stripp bus enclosed in MS sheets etc all completed job-1 no d) Volumeter - (0-500) volt, voltmeter with selector switch of IMP/L&T/AE or of equivalent approved make 2 NO e) Ammeter- ammeter CT operated with selector awitch LMP/L&T MAKE 0 to 100A-2 nos f) Indicating lamp LED L&T/ SIEMENS make in red, yellow and green colour-1 g) 2 Nos 32 amp MCB for light and other loads of L&T/ Havells / Alstom/HPL make including 1 no.63A MCB outgoing Feeder for other load.

Panel should be duly painted with two coats super enameled paint of approved colour one coat of red oxide primer and internally wired with suitable size of copper control wire/cable, etc. all complete. (Including their control cables and as shown in the attached diagram) capacitor or APFC Panel to be provided for desired p.f. of 0.96, etc. all complete. As per site requirement & IE rule.

Supplying fitting and commissioning of switch disconectded isolator (TPN) rated current 100A-415V