Central Coalfields Limited Tender

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:6 (1 cement : 6 coarse sand)

12 mm cement plaster finished with a floating coat of neat cement of mix : 1:4 (1 cement: 4 fine sand)

Stone tile work for wall lining upto 10 m height with special adhesive over 12 mm thick bed of cement mortar 1:3 (1 cement : 3 coarse sand), including pointing in white cement with an admixture of pigment to match the stone shade.Granite stone of any colour and shade

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means over areas (exceeding 30cm in depth. 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead upto 50m and lift upto 1.5m, disposed earth to be levelled and neatly dressed. All kinds of soil

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift upto 1.5 m.

Granular Sub-Base with Coarse Graded Material (Table:-400-2) Construction of granular sub-base by providing coarse graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401. grading-I Material.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand : 8 graded stone aggregate 40 mm nominal size).

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:1½:3 (1 Cement: 1½ coarse sand: 3 graded stone aggregate 20 mm nominal size)

Providing and installing of Fountain at Office Premises complete (1. Supply Of 3 Tier Yellow Marble Fountain with Hand Carved Designs and 6ft Diameter Pond, 2. Supply Of Multicolour fountain lights.Led IP-68 Rating lights in 55 304. Multicolour bulb LED 9X3 watt, Wattage 18W Voltage 12 volt Lense angle 25 degree to 60 degree (12V/27W), 3. Supply of R.G.B Controller with 12V output Supply with inbuilt load circuit of 20Amp with multiple preprogramed colour patterns, 4.1 Supply Of 0.5hp Submerssible Openwell Pump With Greaves Valve Size 32*50 For Better Flow Rate, 4.2 Complete all plumbing work for pool 10 kg High pressure piping and fittings as Pipes, tee, elbow, MΤΑ, FTA, Bush, Ball valve Solvent Excluding Inlets poind and drain point/complete electrical workrequired for the such as 1.5sqmm 3 core flat Submersible cable for pumps 1.5 sqmm 4 core cable for lights, Conduits, bend PVC Tape and submersible joints. 5.1 Complete Installation, testing commissioning and handover. 5.2 Complete civil work for the foundations of all stone fountains beds with waterproofing and tiling.)

Providing and planting Foxtail Palm ht. 120-150 cm bottom girth 15-20 cm well developed in big poly bag size 25 cm complete as per EIC.

Providing and planting of Bush Rose in different colour 2 to 3 healthy branches 30 cm & above ht. well developed with 8 or more flowers/flower buds in 20 cm earthen pot/ plastic pot complete as per EIC.

Providing and planting Hibiscus Rosasinesis of height 90-105 cm bushy in big size HDPE bag complete as per EIC.

Planting permanent hedges including digging of trenches, 60 cm wide and 45 cm deep, refilling the excavated earth mixed with farmyard manure, supplied at the rate of 4.65 cum per 100 metres and supplying and planting hedge plants at 30 cm apart.

Providing and fixing stainless steel (Grade 304) railing made of Hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (wherever required) and fitting the same with necessary stainless steel nuts and bolts complete, i/c fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc., of required size, on the top of the floor or the side of waist slab with suitable arrangement as per approval of Engineer-in-charge, (for payment purpose only weight of stainless steel members shall be considered excluding fixing accessories such as nuts, bolts, fasteners etc.).

Total impact of GST for the purpose of CTC