Military Engineer Services Tender

Supply & fixing of PVC cables 1.5 Sqm 2 core FR PVC round sheathed copper conductor (flexible) industrial cable,1100 Volts conforming to IS 694 fixing/ laying on poles, through pipes, fixed to walls/surface including PVC conduit of minimum 20 mm dia, holding clips etc cross sectional area for following sizes complete, all as specified and directed.

Ditto all as per above item No.04 but 2.5 Sqmm 2 Core.

M & L GI pipe 32 mm dia light grade height 1.0 mtr with base plate, nut bolts connected all items and painting suitable for post top garden lamps complete all as specified and directed.

M&L PCC 1:2:4 type B2 (using 20 mm graded crushed stone aggregate) for foundation filling and mass concrete, complete all as specified and directed

Supply and fixing on wall/surface/floor and testing of LED strip 75W non-integral flexible LED strip light white/warm white/ neutral white IP65 with high brightness for indoor and outdoor applications each strip have 5 mtrs length with suitable LED driver complete all as specified and directed by GE. Make : Bajaj Cat Part No. BPLS-75W LED STRIP DRIVER IP65 AM or equivalent in Havells/Crompton/Philips

Supply, installation, commisioning and testing of LT Control Junction board made up of 3 mm thick CRCA Sheet, double door, outdoor type, mounted on rigid angle iron frame, over all size not less than 600 x 600 x 450 mm, having independent compartment for bus bar, incoming feeder and each out going feeder, dust and vermin proof, factory made, fabricated out of 3 mm thick CRCA sheet suitable for 3 Phase 415 volts 50 Hz, AC supply, bus bar chamber with copper bus bar of 100 Amp rating for 3 phase and neutal 4 wire system duly insulated with heat shrinkable type sleeves as per colour code, supported on epoxy insulators - 01 Set, common earth bus bar of GI Strip 32 x 6 mm at bottom with panel board at two earth terminals , cable glands with independent plates at bottom for each out going and in coming cables in cable alley and complete board painted with powder coating in siemens grey colour all as approved with and including following items with necessary excavation and earth work as required, PCC 1:3:6 type C-2 (using 40 mm grade crushed stone aggregate) for foundation of angle iron legs frame work: - Incoming & Out going :- (a) Isolator SPN 63 Amp, 240 V - 01 No. (b) Isolator SP current rating 40 Amp, 240 V - 02 Nos (c) Timer 01 No.

M & L for Earthing complete with galvanised steel earth plate, electrode, 600x600x6.0 mm thick burried directly in ground (earth pit not less than 2.25m deep below normal ground level) connected to galvanised earth lead wire 4.0 mm dia by mens of nuts, bolts, & washers of GI as shown in electrical plate No. 5 of SSR Part-I Connected to earthing ten point all as specified and including necessary earth pit PCC 1:3:6 chamber and 50mm thick PCC 1:2:4 chamber cover with 6mm dia mild steel reinforcement of 10 cm c/c spacing both ways in lieu of CI cover , watering arrangement shall be made with GI pipe medium grade of 20mm dia including funnel and protection to earth lead shall be provided with GI pipe light grade 15mm dia upto 7.5 from the earth plate electrode & refilling of soil etc including necessary excavation & earth work in any strata and PCC chamber all as specified and directed by Engr-in-Charge including testing on completion.