Military Engineer Services Tender

M&L for sand cushioning with a layer of river sand 23 cm thick under and above the cable complete all as specified and as directed. Note : - Punned down thickness upto 18cm shall only be measured and paid.

M&L for providing of new sub class 'B' bricks, old size, well burnt laid flat dry for protection of under ground cable complete all as specified and directed.

M&L for Cement concrete (1:4:8) type D-2 (using 40 mm graded crushed stone aggregate) as in foundation and mass concrete for fixing poles etc including excavation of any strata, taken out cable & demolition of old concrete complete all as specified and directed.

M&L for plain cement concrete (1:3:6) type C1 (using 20 mm graded crushed stone aggregate) in coping / plinth blocks for poles and the like including weathering, slightly rounded or chamfered angles and throating, as directed including necessary Steel form work and finishing the surfaces fair in forms & demolition of old concrete complete all as specified and directed.

M&L for electrical high insulation tape roll of 25mm wide and 25 Mtr length (RYB) for repair/maintenance of cables joining in pannels (1100 Volts)/ conductors or fixing of thimbles or colour coding of cables in panels/joints and installation of securituy lights in poles etc complete all as specified and directed.

Supply and fixing in replacement LED flood light 70 watt compatible to operate with 150 V to 230 V AC outdoor type with thermal management in multiple optics and equipped with IP65/66 protection, with impact and corrosion resistant complete with driver and lamp complete all as specified and directed.

Supply and fixing in replacement LED flood light 100 watt compatible to operate with 150 V to 230 V AC outdoor type with thermal management in multiple optics and equipped with IP65/66 protection, with impact and corrosion resistant complete with driver and lamp complete all as specified and directed.

Supply and fixing in replacement LED flood light 120 watt compatible to operate with 150 V to 230 V AC outdoor type with thermal management in multiple optics and equipped with IP65/66 protection, with impact and corrosion resistant complete with driver and lamp complete all as specified and directed.

Supply and fixing in replacement LED flood light 150 watt compatible to operate with 150 V to 230 V AC outdoor type with thermal management in multiple optics and equipped with IP65/66 protection, with impact and corrosion resistant complete with driver and lamp complete all as specified and directed.

Supply and fixing in replacement LED flood light 170 watt compatible to operate with 150 V to 230 V AC outdoor type with thermal management in multiple optics and equipped with IP65/66 protection, with impact and corrosion resistant complete with driver and lamp complete all as specified and directed.

Supply and fixing in replacement LED flood light 210 watt compatible to operate with 150 V to 230 V AC outdoor type with thermal management in multiple optics and equipped with IP65/66 protection, with impact and corrosion resistant complete with driver and lamp complete all as specified and directed.

S&F in replacement of 2 runs of PVC insulated 1.5 sqmm single core multistranded aluminium conductor cable and one run of 1.5 sqmm copper wire as earth continuity conductor drawn through and incl rigid non metalic conduit 20 mm external dia fixed on poles & connecting up complete all as specified and diretced. Note: Two runs of cable and one run of earth wire and one run of conduit shall be measured as one length.

M&L for earthing complete with galvanized steel earth plate electrode 60 cm x 60 cm x 6mm thick buried directly in ground vertically to a depth not less than 2.5 mtr below ground level with top edge of earth plate at a depth not less than 1.5 mtr connected to and incl galvanized earth lead wire 4.0 mm dia up to 7.5 mtr long by means of nuts, bolts, thimbles, check nuts and washers etc made of galvanized iron connected to earthing test point all as shown in electrical plate No 3 of SSR Part-I 2009 and as specified or indicated and testing on completion incl earth work and excavation in any type of soil PCC (1:3:6) type C1 chamber, precast slab 40mm thick in cement concrete (1:2:4) type B1 with 8 mm dia MS bars reinforced at 10 cm centre to centre both ways incl funnel with watering pipe wire mesh and lugs, incl test point complete all as specified and as directed

M&L for repair /replacement of following accessories in panel of high mast light:-

Indicating light in Green, Red , Yellow

Combined multimeter voltmeter and ammeter

Selctor switch

Timer On/Off

Control gear box for fitting with Winch double drum type having operating speed and gear ratio as per existing manufacturer design working manually / electrically with stainless steel wire rope, two point suspension system all as per sample-1 No.

Lantern carriage ring suitable for 9X120W capacity

Lightning arrester spike including GI strip 25mm x 3mm 15 Mtr long

Aviation obstruction light

Stainless steel wire rope of 6 mm dia 97/19 guage

Contactor 32 amps 4 pole

Supply & lay cable XLPE insulated, armoured heavy duty electric cable with stranded aluminium conductor, 1100 Volts graded of cross section area :-

50 Sqmm, 4 core

6 Sqmm, 4 core

4 Sqmm, 2 core

M & L for street light panel 3 KW confirm to IS/ IES 60947-4-1 suitable for three phase MCB rating 63 amps on /off timer Astronomical, conractor rating 32 amp including internal wiring in built short circuit protection, IP-54 complete all as specified and directed.

M&L for compression/ crimping type sleeve joints for jointing conductors/ jumper connections including treatment with conducting jelly Upto 10mm dia of conductor wire overall in repair/ replacement complete all as specified and directed.

S&F in repair/ replacement of porcelain aerial fuses 15 Amp, 3mm thick suitable for line wire, with brass contact bolts and nuts complete all as specified and directed.

S&F in repair/ replacement of porcelain aerial fuses 30 Amp, 3mm thick suitable for line wire, with brass contact bolts and nuts complete all as specified and directed.

S&F in repair/ replacement of porcelain aerial fuses 60 Amp, 3mm thick suitable for line wire, with brass contact bolts and nuts complete all as specified and directed.

S&F in repair/ replacement of double stiff pendants, comprising of galvanised steel or chromium plated brass bell mouth connectors 2 Nos with back plate and 2×1.50 metre long parallel 20mm dia galvanised or stove enamelled screwed steel conduit with two check nuts for fixing tube light fitting and upto 1.5 metre long twin core 0.5 sqmm copper conductor flexible wire/ cable in main receiving station complete all as specified and directed.

M&L for common salt commercial use for increasing the earth resistance value of Earthing by dissolving in water and filling in earth pits of Earthing at various locations complete all as specified and directed.