Military Engineer Services Tender

Supply only solar panel glass 5 mm thick toughened size 6'x4'

Supply only heating element 3KW

Supply only insulation glass wool

Supply only complete panel of capacity 100 LPD as per existing make.

Supply only CPVC pipes size 25mm dia SDR 11 & Plain CPVC SDR 11 fittings in walls/ceilings or in floors complete all as specified and directed.

Supply only CPVC pipes size 20mm dia SDR 11 & Plain CPVC SDR 11 fittings in walls/ceilings or in floors complete all as specified and directed.

Descaling of the collectors and hot water tank 1000 Ltrs Cap with the chemical solvent for removing all silt/rust complete and making the whole system leak proof complete all as specified and directed.

Descaling of the collectors and hot water tank 500 Ltrs Cap with the chemical solvent for removing all silt/rust complete and making the whole system leak proof complete all as specified and directed.

Descaling of the collectors and hot water tank 200 Ltrs Cap with the chemical solvent for removing all silt/rust complete and making the whole system leak proof complete all as specified and directed.

Descaling of the collectors and hot water tank 100 Ltrs Cap with the chemical solvent for removing all silt/rust complete and making the whole system leak proof complete all as specified and directed.

Complete collector panel of capacity 100 LPD incl all fittings and fixtures all as specified and directed.

Supply, fabrication and fixing feeder pillar box in replacement x of size 500x 450x500 mm made out of MS sheet of 2.0mm thick bent to shape & size factory made with welding, bending works suitable for and including 200 Amps rated aluminium bus bars (length of bus bar not less than 40 cm) 4no's making holes of any size and mounted on porcelain/epoxy based post insulators of appropriate size with suitable size of nuts, bolts and washers complete with mounting leg of size 40mmx40mmx5mm and length of angle iron not less than 1 mtr, 0.5 mtr to be embeded in PCC 1:2:4 Type B-1 below G.L and 0.5 mtr above ground including painting of complete structure with two coats of super enamelled synthetic paint over a coat of red oxide and incoming/out going cable connections with required size of cable lugs with proper crimping. Make :- L&T, Legrand, Schneider, Hensel

Heating element ISI marked capacity 3 KW suitable for the existing appliance as approved all as specified and directed.

Taking down burnt cable and supply, laying, jointing and testing XLPE cable insulated, armoured, earthed, heavy duty electric cable with aluminium conductor , 1100 Volt grade, cross sectional area 6 sqmm 2 core including necessary cable lugs, glands, insulation tape etc complete all as specified and as directed.

Taking down burnt cable and supply, laying, jointing and testing XLPE cable insulated, armoured, earthed, heavy duty electric cable with aluminium conductor , 1100 Volt grade, cross sectional area 10 sqmm 2 core including necessary cable lugs, glands, insulation tape etc complete all as specified and as directed.

Taking down burnt cable and supply, laying, jointing and testing XLPE cable insulated, armoured, earthed, heavy duty electric cable with aluminium conductor , 1100 Volt grade, cross sectional area 16 sqmm 4 core including necessary cable lugs, glands, insulation tape etc complete all as specified and as directed.

Taking down unserviceable PVC rigid pipe and S&F heavy duty PVC rigid MMS pipe in concealed size 25mm having thickness 2mm ISI marked and making good surface of plaster and colour matching with existing wall all as specified and directed. Cat Part No-CP25SMIV of Make Anchor or equivalent in Kalinga, Supreme as approved.

LED secruity light fitting of capacity 25 Watt LED street light fitting in aluminium PDC housing, toughened glass cover with IP65 protection with suitable inbuilt surge protector and cable connection from ceiling rose to light fitting and testing and including removing of old unserviceable item complete all as specified and directed. Make-Havells Cat Part No-ENXTP25L WH PO PC SD of Bajaj or its equivalent in Havells or Wipro as approved by GE.

Taking down unserviceable PVC rigid pipe and S&F heavy duty PVC rigid MMS pipe in concealed size 32 mm having thickness 2mm ISI marked and making good surface of plaster and colour matching with existing wall all as specified and directed. Cat Part No-CP32SMIV of Anchor or equivalent in Havells or Wipro as approved by GE.

Taking down unserviceable PVC rigid pipe and S&F heavy duty PVC MMS rigid pipe in concealed size 40 mm having thickness 2mm ISI marked and making good surface of plaster and colour matching with existing wall all as specified and directed. Cat Part No CP40SMIV of Anchor or equivalent in Havells or Wipro as approved by GE.

Construction of PCC block around iron structure in the ratio PCC 1:2:4 Type B1 size 1'x1'x1.5' to 100 LPD Solar water heater for embedded steel structure associated with installation of Solar heater all as specified and directed.

Switch piano, flush type single pole, one way 6 Amp in replacement all as specified and directed.

Switch piano, flush type single pole, one way 16 Amp in replacement all as specified and directed.

Excavation in trenches not exceeding 1.50m wide and not exceeding 1.50m in depth for foundation laying poles, stay assembly and laying of LT/HT cables in any type of soil and getting out, complete all as specified and directed.

Returning, filling in, including spreading, leveling, watering and well ramming in layers not exceeding 25cm, in any type of soil, complete all as specified and as directed.

Socket outlet 3 pin, 16 Amp in replacement, flush type all as specified and directed

Socket outlet 3 pin, 6 Amp in replacement, flush type all as specified and directed

Removal of excavated material to a distance not exc 50m and depositing where directed at a level not exceeding 1.5m above the starting point all as specified and directed.

Switch socket combination 2 in 1, 6A flush type in replacement, all as specified and directed.

Switch socket combination 3 pin 16A, flush type in replacement, 5 in 1 all as specified and directed.

M&L for aluminium sheet cladding of thickness 50 micron over hot pipe of 50mm dia for insulation incl binding clamp all as specified and directed.

Taking down old existing unserviceable sub main wiring and S&F new sub main wiring complete with 2 run of 6 sqmm single core copper conductor (ISI marked)cable 1100 volts grade,FRLS type, PVC insulated, unsheathed,flexible,multi stranded colour coded cables drawn through and including rigid PVC conduit of size 25 mm dia medium grade(MMS) with all connected accessories such as Bend,Tee,Elbow,Short peices etc concealed in wall/roofs/floors and including one run of 2.5 sqmm single core copper conductor cable flexible, PVC insulated, unsheathed, multistranded, 1100 volts grade,FRLS type as earth continuity conductor connected to common earth dolly and including making good the disturbed surfaces to match with existing surface including cutting and cheasing and complete all as specified and directed. Note : - Two run of 6 sqmm single core copper conductor cable and one run of 2.5 sqmm single core copper conductor cable as earth continuity and one run of PVC conduit shall be measured as one unit.

Earthing complete with galvanised steel earth plate electrode 600mm x 600mm x 6mm thick buried directely in ground vertically ( earth pit not less than 2.25 meters deep below ground level) with top edge of plate not less than 1.5 metres below ground level, connected to and including galvanised strip 32x6mm by means of bolts, nuts, check nuts and washers of galvanised iron and light grade protection pipe of 40 mm dia from earth electrode up to test point or up to 7.5mtr whichever is less by means of GI bolts, nuts, check nuts and washers all as per electrical plate No 3 of SSR Pt-I and GI watering pipe of 20 mm dia medium grade,GI funnel with wire mesh, including charcoal, salt packed all around the earth electrode plate in layers, PCC earth pit chamber 1:3:6 type C1, of size 45cm x 45cm x 45 cm,RCC cover 1:2:4 type B1 of size 45x45x6 cm, excavation/earth work in any strata and returning filling, removal of surplus soil and testing/test point for required value including removing old item complete all as specified and directed. Note:- The required resistance of Earthing shall be less than 3 ohm, If not found to the required resisstance, the contractor has to re earthing for required resistance and the cost for the same included in the quoted rate and no extra shall be paid on failure of getting required resistance.

Propylene Glycol for cleaning of tank of collector plate solar water heater after complete descaling and cleaning of collector plate and tank all as specified and directed.

Supply and fix water tube for water tube collector ETC (Evacuated tube collector) for solar water heater of capacity of 100/200/300/400/500 Ltr also including lead coating and insulation all as specified and directed

Dismantling all electrical/water connection from Industrial RO capacity 500 LPH and reconnect after replacement of following parts

Supply only 40x40 membrane capacity 500LPH ISI marked to suit the existing RO as approved all as specified and directed.

Supply only carbon and sand media as approved all as specified and directed.

Supply only 20" big blue candle all as specified and directed.