Himachal Pradesh Irrigation And Public Health Department Tender

Providing and faxing of Raw water Submersible pumps of KSB/WILO (Mather & Platt) make suitable for lifting clear cold water of undermentioned charactristics with impellers priming funnel, casing ring & shaft sleeves as per manufacturers standard practice. coupled directly to electric induction motor The pump set shall be suitable for operation on 415 +/- 10% volts, 3 phase AC supply The power of motor shauld be at least 10% in excess of minimum power required by the pump in complete range of +10% and (-) 15% of DP head. The motor confirm to latest IS specifications with upto date ammendments. It should include cost of wiring nuts and bolts painting etc. complete and suitable for following requirements: Total Head: 32.00 Meters Discharge 27.78 LPS or 100 M^3/Hr or as per pump requirement Characteristics of water - Raw cold water of River Beas.

Providing & Fixing three Core Copper flat submersible Cable 10.00 Sqmm PVC insulated PVC flexible industrial cable 1100 volts ISI marked conforming to IS 694/2010 with latest ammendments in all respects all leads and lifts.

Providing, laying, fixing, jointing and testing in trenches MS pipe of 250mm dia meters confirming to confirming to BIS 3183-2007, of following grade and having wall thickness as specified below with plain end and capable of withstanding required test pressure in random length of 4 to 7 meters, including specials, short pieces, bends, reducers, tees etc. made from parent tube, providing and welding of MS flanges detailed as below. The MS flanges shall confirm to BIS 6392-1971 (with latest up to date amendments) duly welded in two layers (two inner and two outer) with pipes at both ends as per relevant BIS standards along with nuts and bolts of required sizes, 3mm thick compressed asbestos fiber/synthetic rubber gaskets confirming to relevant BIS standards. The laying of pipe will include all operation such as cutting, welding, jointing, providing & fixing of MS flanges, fabrication of bends, tees etc. including lowering and laying in excavated trenches to ensure required level including flushing, cleaning and hydraulic testing complete in all respects to the satisfaction of the Engineer in charge. The fabricated bends shall have three or four cuts having its radius not less than five times the dia of pipe. The pipes shall be factory galvanized (zinc coating both inside and outside) as per relevant IS standards and the damaged portion of the pipes and specials made form the parent tube shall be provided anticorrosive treatment by applying two coats of anticorrosive bituminous paint over a priming coat as per AWWA specifications C-203-1978. The welding electrodes shall be as per IS 814 of Advani Oerlikon / L&T or ISI marked make. The rates also includes entire carriage of material, flushing, cleaning & hydraulic testing complete to the best satisfaction & directin of Engineer in charge with in all leads and lifts. (Earth work in trenches will be measured and paid for separately). 250 mm dia -(X-42) MS Pipe 4.00 mm thickness with FT-23