National Highways Authority Of India Tender

Haryana

Punjab

Seal Coat: Type B with VG -10 bituminous binder Providing and laying of premix sand seal coat premixed in continuous type HMP of appropriate capacity not less than 75 tonnes/ hours using specified fine aggregates and penetration grade bitumen @0.68 kg/sqm laid to specified levels, grade and cross fall complete as per technical clause 511 of MORT&H specifications.

Haryana

Punjab

Removal of Existing Cracked Surface by Milling: Milling of existing BC layer including disposal of milled material and stacking of serviceable material as per direction of Engineer-in-charge and disposal of unserviceable material within all leads and lifts.

Haryana

Punjab

Recovery for milled material:- Recovery shall be made for retrieved milled material at the rates specified herein ( i.e. @ 20% of rate quoted for item of BC). Note:- Material obtained from dismantling of existing bituminous layer has been calculated @ 60% of the retrieved material as per theoretical calculation. The agency shall take away this material at the fixed rate @ 20% of quoted rate of BC. If actual material after dismantling is found on lesser side, no claim of agency on this score will be entertained and full recovery on the basis of quoted rate and quantity exhibited in the BOQ shall be made. The dismantled material can be used in any of the items for the work after modification (bringing it to required specifications) so as to fulfil requirements of MoRTH specification clause 519 and after approval from the employer. In case it is not possible to use this material on the work the agency can take away this material. However, recovery of material shall be made for the quantity exhibited in the BOQ and at the rates specified herein irrespective of the fact that material is used in the work or not. Bidder/Agency may visit site before quoting rates and make his assessment for the extent of retrieved material.

Kerb Painting: Painting Two Coats including priming coat with synthetic enamel paint in all shades on plastered concrete surface to give an even side.with special quality reputed brand paint as per MORTH specification clause No. 803 &409 and as approved by Engineer In-Charge complete in all respects.

Road Marking with Hot Applied Thermoplastic Compound with Reflectorising Glass Beads on Bituminous Surface Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35. The finished surface to be level uniform and free from streaks and holes as per MORTH specification clause No. 803 complete in all respects.

Total Estimated Cost

Bidder to quote single rate as tender premium % above or discount below the total estimated cost mentioned above.

I/We hereby agree to execute the above work on the tender premium or discount quoted here on the total estimated cost mentioned above. I/we understand that filling of both cells meant for premium or discount at a time will render my/our bid as non responsive.

Bid price in Rs.