Military Engineer Services Tender
If you're typing tender ID over and again or finding it difficult to go through the cumbersome government websites for looking at Delhi tenders online. We have come up with a solution i.e. we have collated every eprocurement Delhi tender on BidAssist. Also, for any queries related to an e-tender Delhi, like the bidding process, registration process, etc., the same are explained below.
Costs
EMD
₹ 97,100Document Cost
₹ 500Tender Fee
Refer Documents
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2024_MES_670375_1Bid Award Id
ViewTender No
8024/A/T-40/E8Tender Authority
Military Engineer Services ViewPurchaser Address
-Website
http://http://mes.gov.in/
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
BOQ Items
M&L for epoxy based self leveling screed having a minimum thickness of 3800 microns. The self leveling screed shall consist of a low viscous epoxy-amine cured system and graded aggregates. The epoxy system shall have a volumetric ratio of mixing of resin in (2:1) ratio. The aggregates shall be added in the ratio of (1:3) or (1:3:5). The screed shall have compressive strength of minimum 70 N/Sqmm. The layer shall be desecrated by spike roller to dislodge air pocket etc complete all as specified andd as directed by Engineer-in-Charge. [Make:-SIKA, Fosroc, Choksey]
2134
-
-
M&L for applying primer of two component, solvent-free, epoxy-polymido amine system having a volumetric ratio of mixing of (2:1). Mixing resin and hardener by weight shall not be allowed. The primer shall be applied @ coverage of 5 Sqm per litre, yielding a DFT of 200 microns. [Make:-SIKA, Fosroc, Choksey]
2134
-
-
M&L for applying EPU based self levelling top coat. The top coat shall be of EPU type where urethane linkages are infused in to epoxy matrix, so as to enhance wear resistance, flexibility and impact resistance. EPU top coat shall have a volumetric ratio of mixing of (2:1). No filler or aggregates are added in the top coat at the site, as the addition of fillers will reduce the flexibility. It should yield a thickness of 1000 microns. The volumetric mixing ratio will be (2:1). The compressive strength of the top coat shall be in the range of 60-70 MPa, Tensile strength will be 15-20 MPa, Elongation in the range of 45-50% and flexural strength in the range of 40-50 MPa. Top coat wear resistance (weight loss)/ Abraission Resistance37 mg, complete all as specified and as directed by Engineer-in-Charge. [Make:-SIKA, Fosroc,Choksey]
2134
-
-
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements