Chandigarh Administration Tender

Providing and Fixing of M.S. Flat Railing 9'-10 ½" long and 6'-9" high ( 4'-9" above ground level and 2'-0" in ground) consisting of 2 No. vertical member made out of M.S. channel 125 x 65 x 5 mm with 0'-9" long anchorage piece welded at bottom embedded in cement concrete block 1:2:4 of size 1'-6"x1'-6"x 2'-0" in ground the rate further include diggigng of pit and removal of earth. The frame of railing consist of 2 Nos. top & bottom horizontal member as MS angle 65mmx65mmx6mm. The railing panel having vertical members of MS flat 50 mm x 6mm of 4'-4" height @ 6 ¼" & 3" spacing alternately and 7 ½" high vertical flats and @ 6 ¼" long horizontal members at top and bottom in between vertical members and welded alternatively at top. The M.S. Flat 50x6 mm are welded to each other with 12mm Dia long bar by making hole at the center of the each vertical member and 2 nos MS Flat 50 x 6 mm 9'-10 ½" long welded with vertical members on both side. The rate further including the cost of 2 Nos. 12mm dia nut, bolt and washers with 3" long sleeve of G.I. pipe 19mm dia for fixing of vertical members of railing panel to each other above the ground level, finished with two coats paint over one coat of metal primer (special quality) complete in all respects. and to the entire satisfaction of the Engineer-in-charge. N.S.

Providing & fixing of factory manufactured fine finished Cylindrical Bollard 150mm dia Fiber Reinforced Plastic moulds of size 950mm high over ground level and 300mm below G.L.made with M-35 mix concrete design using 1250 mm long 4 nos 10 mm dia TMT Steel bars, 6 mm Dia Stirrups @ 150mm c/c consisting of 2 cuts of 75mm height at top for reflector sheet type-IV, Fibre reinforcement plastic moulds fixed in ground with C.C. 1:2:4 block of size 300mm x 300mm x 450mm. The rate further includes making of pit complete in all respects and to the entire satisfaction of Enginner-in-charge. N.S.

Providing and fixing retro reflective high intensity microprismatic sheeting 50mm wide long conforming to type - IV of ASTM-D 4956-01 in required color and size over existing surfaces like railings in center verge, guard rails etc. including cleaning/rubbing of surface complete in all respects and to be entire specification of Engineer-in -charge. N.S.