Military Engineer Services Tender
BidAssist is a very user-friendly website which helps in finding the specific Assam e-tender that one is looking for. For getting any information or detail about any e-tender the Assam government must have posted, BidAssist is designed in such a manner so as to provide information on all government tenders in one place without any inconvenience.
Costs
EMD
₹ 90,000Document Cost
₹ 500Tender Fee
Refer Documents
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2024_MES_680908_1Bid Award Id
ViewTender No
622/E8Tender Authority
Military Engineer Services ViewPurchaser Address
-Website
http://http://mes.gov.in/
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
BOQ Items
Fixing only newly procured chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc including provission of binding wire complete all as specified in disrected.
2410
-
-
S&F in repair galvanised 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) complete all as specified and directed.
36
-
-
-Ditto- as item No 05 above but fixing only of old taken down/ dismantled barbed wires complete
4
-
-
Demolition of cement concrete (unreinforced) in ground floors and pavings n exc 15 cm thickness (below or above ground level) complete
80
-
-
M&L cement concrete type C-2, 1:3:6 mix (40 mm graded stone aggregate) in foundation, filling & mass concrete complete all as specified and directed.
30
-
-
M&L for providing reinforced cement concrete type B-l, 1:2:4 (20 mm graded aggregate) in precast posts, fencing posts, straining or terminal posts, struts etc. for fencing, average sectional area exc 100 and n.exc 250 sq. cm, with or without chamfered angles and flat, splayed, rounded or mitred tops as directed and fixed
19
-
-
- Dtto- as item No 09 above but fixing only existing precast RCC fencing posts after necessary repair to edges etc with CM (1:1) complete
2
-
-
M&L for TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified.
2000
-
-
Ditto all as per item No 11 above but 5 mm dia and over up to and including 10 mm dia in stirrups,spacers and binders complete all as specified.
900
-
-
M&L for round bars of Fe-410-W(Gde.E-250) of 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified.
1860
-
-
S&F for hand rails, half round or other steel section or core for wooden handrail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all specified and as directed.
3960
-
-
S&F in repair 12 mm dia, MS bolts (machine made) of length exc 10 cm but not exc 15 cm with one washer & one nut all as directed.
360
-
-
Demolition of brick work built in cement mortar including all quoins arches,pillars etc complete all as specified. .
20
-
-
M&L Brick work with sub class 'B' bricks, straight or curved on plan exc 6 mtr mean radius, built in CM 1:6 complete all as specified.
20
-
-
Taking down cement plaster on wall including raking out joints, hacking for key scrubbing down with water to receive new plaster including a coat of cement slurry complete all as specified and directed.
500
-
-
M&L Rendering 15 mm thick in CM 1:4 on brick or concrete surfaces, finished even and fair complete all as specified.
680
-
-
M&L for preparation of new plastered surface of wall and applying three coats of white wash complete all as specified and directed.
480
-
-
M&L for preparation of newly plastered surfaces of wall and applying two coats of cement base paint over a coat of primer complete all as specified and as directed.
200
-
-
M&L cement concrete type B-1, 1:2:4 mix (20 mm graded stone aggregate) in coping of brick wall complete all as specified.
1
-
-
Demolition of cement concrete (reinforced) in any position not otherwise specially provided for complete all as specified.
3
-
-
M&L Reinforced cement concrete nominal mix type B-1, 1:2:4 mix (20 mm graded stone aggregate) as in foundation, footings, beams, plinth beams, bases of column etc complete all as specified.
1
-
-
M&L Reinforced cement concrete type B-1, 1:2:4 mix (20 mm graded stone aggregate) as in columns piers,pillars etc complete all as specified. and as directed.
2
-
-
M&L use and water of form work to rough flat sides of concrete foundation, footing, bases, sides and soffits of foundation and plinth beams and similar works complete all as specified.
20
-
-
M&L use and water of form work to rough flat sides form work to sides of RCC Column and pillars etc for fair finished surface complete all as specified.
20
-
-
Dismantling structural steel work including doors, gates but excluding framed truss etc. complete all as specified.
10
-
-
S&F Rolled mild steel Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering, Doors etc. to be prepared for hanging or sliding with & including either hooks & hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails & guides) & hanging; also fastening & fixing complete GDE Fe410-0 or Fe 310-O
1000
-
-
Applying two coats of synthetic enamel paint on steel & iron surfaces of any description, n exc 10cm width or girth when unconnected with other painting or when painted in different tint, including preparation of new surface & applying one coat of red oxide, zinc chrome
300
-
-
M & L preparation of steel and iron surfaces and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified. .
165
-
-
Supply only in repair concertina coil of 1 Mtr dia in 06 coil in stretch of 1.0m length for fencing work,straining and fixing to angle iron/barbed wire with and including necessary clips for each bundle of coil) for securing complete all as specified and directed.
87
-
-
Fixing only in repair concertina coil of 1 mtr dia in 06 coil in stretch of 1.0m length for fencing work,straining and fixing to angle iron/barbed wire with and including necessary clips for each bundle of coil) for securing complete all as specified and directed.
30
-
-
Taking down existing concertina coil of any dia and any description and at any position including cutting of existing securing / binding / welding and re-fixing the same after repair of fencing at same or other location with securing it as per site requrement complete.
25
-
-
M&L for 60mm thick rubber moulded coloured glossy finish precast cement concrete interlocking pavers blocks / tiles Grade M-35 made with grey cement and no pigment manufactured by automatic hydraulic compression with high compressive strength ,any size, pattern and shape as approved by GE, laid dry over and including 30 mm thick sand cushion in patteerns with different colour paver block /tiles as in path, complete all as spd and directed
250
-
-
M&L for 80mm thick rubber moulded coloured glossy finish precast cement concrete interlocking pavers blocks / tiles Grade M-40 made with grey cement and no pigment manufactured by automatic hydraulic compression with high compressive strength ,any size, pattern and shape as approved by GE, laid dry over and including 30 mm thick sand cushion in patteerns with different colour paver block /tiles as in path, complete all as spd and directed
80
-
-
M&L for glossy finished coloured chequered cement concrete tiles 30cm x 30cm x 25mm thick, set, jointed and pointed in neat cement slurry and pointed in white or coloured cement to match the shade of tiles over and including 15mm thick screed bed in CM (1:6) complete all as specified and directed
250
-
-
Dismantling floor hearth and wall tiling including cement mortar bedding (but not backing), removing rubbish off the premises, complete all as specified and directed.
129
-
-
M&L for non skid ceramic tiles 7 to 8mm thick (square/rectangular) polished area of tiles exc 0.11 sqm but n exc 0.18 sqm each in floors etc set and jointed with grey cement slurry and pointed in white or coloured cement to match the shade of colours over 15 mm thick screed bed or bedding leyer in CM (1:6), complete all as specified and as directed.
85
-
-
M&L for non skid ceramic tiles 7 to 8mm thick (square/rectangular) polished area of tiles exc 0.11 sqm but n exc 0.18 sqm each on vertical surface such as skirtings, dados and risers etc set and jointed with grey cement slurry and pointed in white or coloured cement to match the shade of colours including 10mm thick rendering in CM 1:4, complete all as specified and as directed.
4
-
-
M&L for glazed ceramic coloured tiles (light shade) of size 350x250x7mm/450x300x7mm thick for work on vertical surface such as skirting, dado, set & jointed neat in cement slurry and pointed in white or coloured cement to match including10 mm thick plaster in CM (1:4) complete all as specified and as directed.
40
-
-
M&L providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required and inclusive of excavation and returning filling and removal to erect the kerb stone in position complete. complete all as specified and directed
10
-
-
M&L PCC in foundations, filling and mass-concrete type D2 (1:4:8) using 40 mm graded stone aggregate complete all as specified and directed
50
-
-
M&L for 25mm thick levelling course in cement concrete type B-1 1:2:4 using 20mm graded aggregate complete
20
-
-
M&L for broken stone hardcore of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface complete all as specified and directed .
5
-
-
M&L for cement concrete work in pavement / hard-standing of flexural strength 40 kg/per square centimetre in field using 400 kg of cement per cubic metre and finishing the surface with broom finish complete all as specified and directed .
2
-
-
M&L for forming Contraction (Dummy) joints 65mm deep x 10mm wide, filled with sealing compound grade A complete all as specified and directed .
2
-
-
M&L for forming 12mm thick expansion joints in 150mm thick pavement filled with pre-formed bituminous filler and top 30mm primed and sealed with sealing compound, Grade ‘A’ complete all as specified and directed .
1
-
-
M&L for forming Construction joint 30mm deep x 10mm wide filled with sealing compound grade A complete all as specified and directed .
1
-
-
M&L for Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, watering, and removing surplus soil to a distance n.exc.50m and making good surface in soft/disintegrated rock.
429
-
-
cutting of bushes/Site clearence up to 1m both sides from the fencing, complete all as specified and directed .
2464
-
-
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements