Military Engineer Services Tender

M&L for preparation of steel surfaces over 10cm width or girth and applying two coats of synthetic enamel paints over one coat of red oxide primer complete all as specified and directed

M&L for Rendering 15 mm thick on faces of brick work or concrete surface in CM (1:6), finished even and smooth without using extra cement complete all as specified and directed

M&L preparation of new surface of walls and applying white cement based wall care putty (minimum 1.5mm thick), apply two coats of distemper with 1st quality acrylic distemper (ready mixed) having VOC content less than 50gms/litre, of approved manufacturer, of required shade and colour complete, as per manufacturer's specification.

M & L for anodised aluminium frame for doors, windows, ventilators with one or more rebates including joining cleat for fixing and powder coated (minimum thickness of powder coating 50 micron)etc. complete all as specified and directed

M&L for Providing and fixing Powder coated aluminium (minimum thickness of powder coating 50 micron) for shutters of doors, windows & ventilators including providing and fixing hinges/ pivots ,necessary fittings and making provision for fixing of fittings wherever required including the cost of EPDM rubber/ neoprene gasket required with extruded built up standard tubular sections/ appropriate Z sections and other sections of approved make conforming to IS: 733 and IS:1285, fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required EPDM rubber/neoprene gasket etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing/ paneling, C.P. brass/ stainless steel screws all complete as per architectural drawings and the directions of Engineer-in-Charge.

M & L for 5.50 mm thick sheet glass, ordinary quality and glazing fixed in aluminium frames in square/rectangle not exc 0.5 sq. m in each pane complete all as specified and directed

M & L for 5.50 mm thick sheet glass, ordinary quality and glazing fixed in aluminium frames in square/rectangle exc 0.5 sq. m in each pane complete all as specified and directed

S & F in stainless steel wire cloth, 0.36 mm nominal dia of wire and average width of aperture 1.40 mm and fixed with tinned tacks, or galvanised wire staples complete all as specified and directed