Military Engineer Services Tender
BidAssist is a very user-friendly website which helps in finding the specific Assam e-tender that one is looking for. For getting any information or detail about any e-tender the Assam government must have posted, BidAssist is designed in such a manner so as to provide information on all government tenders in one place without any inconvenience.
Military Engineer Services - MES Tender
Civil And Construction
Civil Works Others
Eprocure
Opening Date24 Dec 2024
Closing Date14 Jan 2025
Tender Amount₹ 24,00,000
Costs
EMD
₹ 48,000Document Cost
₹ 500Tender Fee
Refer Documents
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2024_MES_690207_1Tender No
8467/BOR/E8Tender Authority
Military Engineer Services ViewPurchaser Address
-Website
http://http://mes.gov.in/
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
Documents
BOQ Items
... More
M&L for Reinforced cement concrete design mix M25 for Beams, cantilevers, lintels, columns pillars, piers, posts, struts, chullah hoods, stair case, arches, domes, vaults, shell roofs, arch ribs, folded plates, slabs, balconies, canopies, deck slabs etc. or in similar articles upto 5th floor level as specified and directed.
2.6
-
-
... More
M&L for TMT Mild steel bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips
950
-
-
... More
Removal of excavated material exc 250m and not exc 500m and deposited where directed (4.70 + 110.25)
114.95
-
-
... More
Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm comlete as specified and as directed
(2.00 + 6.48)
8.48
-
-
... More
M&L for Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams,sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter
4
-
-
... More
M&L for Formwork to faces of walls, colums and retaining walls, abutments, parapets and staircase railings and similar work including attached pillasters, buttresses, etc.; vertical or to batter
17
-
-
... More
Rendering 15 mm thick on fair faces of brick work or concrete surface in cement mortar 1:4 mixed with WPC as per manufacturer's instruction and finished the surfaces even and smooth without using extra cement complete all as specified and as directed.
Note : WPC will be measured and paid for separately.
12
-
-
... More
M& L for Integral water proofing compound complete as specified and as directed
1.6
-
-
... More
Material and labour for preparation of new plastered surfaces of walls and applying two coats of cement base paint complete all as specified and as directed.
12
-
-
... More
M&L for Mild steel framed work as in gates for ornamental and intricate design and painted one shop coat of primer including preparation of new steel surface all as specified and directed.
500
-
-
... More
M&L for preparation of new steel surface and apply synthetic enamel paint (ordinary tint) over a coat of red oxide Surfaces of any description, over 10cm in width or girth, not otherwise described complete all as pecified and as directed.
11
-
-
... More
Surface excavation not exc 30 cm deep and averaging 15cm deep and getting out complete all as specified.
735
-
-
... More
M&L for broken stone boulders of hard core of gauge n.exc 63mm, deposited, spread and levelled in layers not exc 15cm thick, watered and rammed to a true surfaces complete all as specified.
110.25
-
-
... More
M&L for 75 mm thick PCC (1:4:8) type D2 using 40 mm graded crushed stone aggregate as in sub base, surface finished fair and even, complete all as specified & directed.
710
-
-
... More
Providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified & directed.
710
-
-
... More
M&L for PCC 1:2:4 type B2 using 40mm graded stone aggregate as in sides filling and mass concrete complete all as specified and directed by Emgr-in-charge.
2
-
-
... More
Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required complete.
3
-
-
... More
M & L for preparation of new undecorated plastered/ concrete surface by rubbing down and applying two coats of synthetic enamel poaint over a coat of primer over 10cm girth or width, all as specified.
50
-
-
... More
Excavating in trenches manually not exceeding 1.5m wide and not exceeding1.5 mtr in depth/ width for laying under ground cable / foundations and getting out in soft / loose soil all as specified and directed. Note : During excavation no mechanical excavator is permitted at site, contractor will do the excavation through manually.
11.48
-
-
... More
Removing of surplus excavating material not exceeding 50 mtr and depositing where directed at a level not exceeding 1.5 mtr above the starting point all as specified and directed.
5
-
-
... More
M&L for sand cushioning for protection of lT under ground cable with screen wash sand and punning to proper reqd cover all as specified and directed.
5
-
-
... More
M & L brick protection with old size sub class ‘B’ brick for PVC under ground cable protection in trench with width equal to length of brick laid dry and flat joining each other with gap between adjacent brick not exceeding 10mm over LT under ground cable all as specified and directed.
369.57
-
-
... More
S&F of UG cable XLPE insulated,armoured heavy duty electric cable with aluminium conductor,1100 Volts grade, cross section area incl taking down of size 10 Sqm 2 Core complete all as specified and as directed.
50
-
-
... More
M&L for boring under roads or any other specified location by reqd T&P without disturbing the top surface of the road for insertion of GI Pipe of 50 to 100 mm dia etc complete all as specified and directed.
4
-
-
... More
M&L for tubes 50 mm bore light grade galvanized with all fittings laid in trenches / wall / pole through MS flat (25X3 mm), nut, bolt & washers [where ever reqd] of proper sizes for protection cables complete all as specified and directed. Make : Nezone/ Bansal/ Jindal
6
-
-
... More
M&L for fixing the cable junction boxes of size 155X210X92mm, with PVC connector 4 way heavy duty for 10-16 Sqmm, 4.0/3.5C, 1100V cable, IP 66/65, weather proof, outdoor installation type with threaded cable glands & pole mounting brackets etc. complete all as specified and as directed. Make : Hensel / OBO
2
-
-
... More
S&F Circular LED post-top light offering excellent uniform illumination and aesthetics in one go. Made up of Pressure Die Cast aluminium body and opal PC cover, IP 66, CCT(K)-3000 and IK 07 rating ensures it stands tall amid varied environmental conditons of capacity 50 W.
Make : Havells/ Wipro/ Philips/ Bajaj of equivalent make specified in CA
2
-
-
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements
Past BiddersThis list is curated from the bidders of the similar tenders in the past
- Bidder NameThis Information is for unsubscribed user This Information is for unsubscribed user
- Awarded Ratexx%
- Bidder NameThis Information is for unsubscribed user This Information is for unsubscribed user
- Awarded Ratexx%
- Bidder NameThis Information is for unsubscribed user This Information is for unsubscribed user
- Awarded Ratexx%