Andhra Pradesh Medical Services And Infrastructure Development Corporation Tender

Labour charges for run of U.G cables from 70 to 300 Sqmm on wall with necessary fixing arrangments such as saddles, clamps etc., as directed by department including cost and conveyance of all materials etc., complete.

Supply and making one end termination with 3.5 core x 150 sq.mm heavy duty double compression brass gland as per BS 6121:2005 ,IP 66 complete,SIBG type, heavy duty Alluminium lugs duly crimped with crimping tool, PVC tape etc for following size of Armoured PVC insulated & PVC sheathed/ XLPE aluminium conductor cable of 1100 volt grade as required of size. Makes:Dowels/Comet/SMI

Supply Installation Testing and commissioning of free standing floor mounted dust and vermin proof outdoor feeder pillar box of size 600x600x1200 mm made out of CRCA sheet, required hardware, duly painted by two coats of zinc/red oxide primer followed by Powder coated / epoxy / PU painted with phosphatisation in grey or required shade after rinsing. The panel having PU/Neoprene rubber gasket of not less than 3mm thickness,separate detachable, gland plate M.S. base channel, hinged door with locking arrangement for equipment/switchgear. Thickness of sheet shall not be less than 1.6mm up to 600mm length/width of any compartment and be of 2.0mm above 600mm. Load bearing structure shall be of 2.0mm thick sheet supported by base M.S. channel if required. Side walls and cable alley compartments having bolted type doors with detachable extension type structure (only outer area on all sides shall be measured and panel to be fabricated from CPRI approved fabricator). Incomer :- 160A Four Pole, MCCB of adjustable, confirms to IEC 60947-2 and IS 13947-Part 1&2 having Breaking Capacity 25KA with thermal magnetic release Panel Mounted. Makes: L&T- D shine / Schneider-CVS/Legrand -DP X3/ Meetering:- Supply and Fixing of 240/220 V, LED (22.5 mm dia) Pilot lamp Red & Yellow Colour with integral circuit, terminal block, including connection etc. as required Supply and Fixing of 240/220 V, LED (22.5 mm dia) Pilot lamp Blue Colour with integral circuit, terminal block, including connection etc. as required

Bus Bars:- Supply and fixing of Electrolytic grade aluminium bus bars by means of SMC / DMC type insulator, high tensile nuts and bolts spring washers in existing panel including bending , cutting in required shape and size and colour coding with heat shrinkable PVC sleeves Control wiring with suitable size of approved make FRLS PVC flexible copper wires, Earth Bus Bar, Door Loop earhtings, Ferrules, Feeder identifications, danger plate, door locks etc., labour charges for errection of switch gears, panels boards, with all other accessories including all labour charges etc with connections for finished item of work including transportation. Feeder Pillar Box

Supply Installation Testing and commissioning of free standing floor mounted dust and vermin proof outdoor feeder pillar box of size 600x600x1200 mm made out of CRCA sheet, required hardware, duly painted by two coats of zinc/red oxide primer followed by Powder coated / epoxy / PU painted with phosphatisation in grey or required shade after rinsing. The panel having PU/Neoprene rubber gasket of not less than 3mm thickness,separate detachable, gland plate M.S. base channel, hinged door with locking arrangement for equipment/switchgear. Thickness of sheet shall not be less than 1.6mm up to 600mm length/width of any compartment and be of 2.0mm above 600mm. Load bearing structure shall be of 2.0mm thick sheet supported by base M.S. channel if required. Side walls and cable alley compartments having bolted type doors with detachable extension type structure (only outer area on all sides shall be measured and panel to be fabricated from CPRI approved fabricator). Incomer :- 250A Four Pole, MCCB of adjustable, confirms to IEC 60947-2 and IS 13947-Part 1&2 having Breaking Capacity 35/36 KA with thermal magnetic release Panel Mounted. Makes: L&T- D shine / Schneider-CVS/Legrand – (DP X3/DRX)/ Siemens- 3VL / Hager-h3/C&S - Winbreak/HPL-Techno Metering:- Supply and Fixing of 240/220 V, LED (22.5 mm dia) Pilot lamp Red & Yellow Colour with integral circuit, terminal block, including connection etc. as required Supply and Fixing of 240/220 V, LED (22.5 mm dia) Pilot lamp Blue Colour with integral circuit, terminal block, including connection etc. as required

Bus Bars:- Supply and fixing of Electrolytic grade aluminium bus bars by means of SMC / DMC type insulator, high tensile nuts and bolts spring washers in existing panel including bending , cutting in required shape and size and colour coding with heat shrinkable PVC sleeves Control wiring with suitable size of approved make FRLS PVC flexible copper wires, Earth Bus Bar, Door Loop earhtings, Ferrules, Feeder identifications, danger plate, door locks etc., labour charges for errection of switch gears, panels boards, with all other accessories including all labour charges etc with connections for finished item of work including transportation. Feeder Pillar Box

Supply Installation Testing and commissioning of free standing floor mounted dust and vermin proof outdoor panel made out of CRCA sheet, required hardware, duly painted by two coats of zinc/red oxide primer followed by Powder coated / epoxy / PU painted with phosphatisation in grey or required shade after rinsing. The panel having PU/Neoprene rubber gasket of not less than 3mm thickness,separate detachable, gland plate M.S. base channel, hinged door with locking arrangement for equipment/switchgear. Thickness of sheet shall not be less than 1.6mm up to 600mm length/width of any compartment and be of 2.0mm above 600mm. Load bearing structure shall be of 2.0mm thick sheet supported by base M.S. channel if required. Side walls and cable alley compartments having bolted type doors with detachable extension type structure (only outer area on all sides shall be measured and panel to be fabricated from CPRI approved fabricator). Incomer :- 630 A Four Pole, MCCB of adjustable, confirms to IEC 60947-2 and IS 13947-Part 1&2 having Breaking Capacity 50 KA with thermal magnetic release Panel Mounted 1 No. Makes: L&T- D shine / Schneider-CVS/Legrand –(DP X3/DRX)/ Siemens- 3VL / Hager-h3 Outgoing feeders:- Supply of 250A, 3 Pole MCCB, Adjustable, Confirms to IEC 60947-2 and IS 13947-Part 1&2 having Breaking Capacity 36/35 KA with thermal magnetic release Panel Mounted with separate individual neutral connector link.-5 Nos Makes: L&T- D shine / Schneider-CVS/Legrand -DP X3/ Supply of 160A, 3 Pole MCCB, Adjustable, Confirms to IEC 60947-2 and IS 13947-Part 1&2 having Breaking Capacity 25 KA with thermal magnetic release Panel Mounted with separate individual neutral connector link. - 3 Nos Makes: L&T- D shine / Schneider-CVS/Legrand -DP X3/

Metering:- Supply and Fixing of (0-500) V range Volt meter on existing panel, making connection by PVC insulated copper conductor with PVC sleeves/channel etc., as required 1 No. Make:Conzerve/Elmeasure/Meco/HPL/L&T/socomec Supply and Fixing of CT operated direct reading type Ammeter, below 500A, on existing panel , making connection by PVC insulated copper conductor with PVC sleeves/channel etc. as required 1 No. Make: Conzerve/Elmeasure/Meco/HPL/L&T/Schneider/AE/Socomec Supply and Fixing of Current Transformer, from 500 / 5 to 1600/5 Ratio , 15 VA , class 1 accuracy with all necessary support in existing panel including connection etc. as required 3 No.s Make: Kappa/L&T/Seimens/C&S/Schneider Supply and Fixing of 240/220 V, LED (22.5 mm dia) Pilot lamp Red & Yellow Colour with integral circuit, terminal block, including connection etc. as required Supply and Fixing of 240/220 V, LED (22.5 mm dia) Pilot lamp Blue Colour with integral circuit, terminal block, including connection etc. as required 10 kA - 6-32A range SP MCBs 6 No.s Make: Legrand-DX3 / Schneider-A9/Hager-h3/ Siemens- 5SX4/ Havells STADx /L&T-AU/ Bus Bars:- Supply and fixing of Electrolytic grade aluminium bus bars by means of SMC / DMC type insulator, high tensile nuts and bolts spring washers in existing panel including bending , cutting in required shape and size and colour coding with heat shrinkable PVC sleeves Control wiring with suitable size of approved make FRLS PVC flexible copper wires, Earth Bus Bar, Door Loop earhtings, Ferrules, Feeder identifications, danger plate, door locks etc., labour charges for errection of switch gears, panels boards, with all other accessories including all labour charges etc with connections for finished item of work including transportation. Outdoor Main Panel

Providing independent earthing for Important equipment with 40mm dia 'B' class 2.5m long G.I pipe and 19mm dia 'B' class G.I pipe of 0.3mtr. long connected with reducer providing G.I funnel with mesh enclosed in C.C.Chamber of 400m x 400m x 400mm with R.C.C. Slab cover duly providing staggered holes filling with salt and charcoal from the bottom of the pipe giving earth connection from electrode through G.I strip of 40 x 6mm x 200mm length with all accessories and labour charges complete, as per IS specifications 732/1982 (Part II)

Supply and Run of 25mm x 6mm G.I Strip including cost of all accessories and labour charges etc., complete.

Supply and Run of 40mm x 6mm G.I Strip including cost of all accessories and labour charges etc., complete.

Rupees Eight Lakhs Eighteen Thousand and Sevnety Eight only