Zilla Parishad Tender

Ordinary Cement Concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement, if any, in ground floor as per relevent I.S Codes.

Hire and labour charge for shuttering with centering and necessary staging upto 4m. using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slab, beams, columns, lintels curved or straight including fitting, fixing and striking out after completion of works. (up to roof or ground floor) 25 mm. to 30 mm. shuttering without staging in foundation.

Reinforcement for Reinforced Concrete work in the all sorts of structures including distribution bars, stirrups, binders etc. Including supplies of rods , initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction. For works in foundation, basement and upto roof of ground floor/upto 4m

Plaster (to wall, floor, ceiling etc.) with sand cement morter including rounding off or chamfering corners as directed and racking out joints or roughening of concrete surface, including through ting, nosing and drip course where necessary.

Neat cement punning about 1.50 mm. thick in wall, dado, window sills, floor drain etc.

Supplying, fitting and fixing PVC pipes of approved make of Schedule 80(medium duty) conforming to ASTMD - 1785 and threaded to match with GI Pipes as per IS : 1239 (Part - I). with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads,fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials. Payment for painting will be made seperately) 20 mm dia

25 mm dia

Supplying, fitting and fixing pillar cock of approved make. d) Polythene Piller Cock (EMCO / ATLAS or equivalent) (i) 15 mm

Supplying P.V.C. water storage tank of approved quality with closed top with lid (Black) - Multilayer (a) 1000 litre capacity

Labour for boring tube well of required dia. by water jet system through any type of soil strata including hire and labour charges for boring pipes, scaffolding, tools and plants as necessary and taking out them and lowering pipes, strainers, blind pipe etc. and fitting and fixing the same complete including bucket washing and other incidental works in theconnection. The tube well should have a minimum 50 mm gap in between the outside of the tube well pipe and the bore. (a) For depth upto 150 metre. (i) 80 mm dia. boring etc.

Supplying high density polythene Strainer of approved make with adopter conforming I.S. Specification ( Each strainer must be 2.00m length and best quality). (i) 75mm dia

Supplying fitting and fixing Steel Cutter Piece upto 450mm long with socket. (i) For 40mm dia.

Patching the annular space between the outside of tube well pipe & strainer and the bore with pea sized washed gravel of approved quality having size 2 mm to 5 mm or the size approved by the Engineer-in-charge including cost of all materials, labour and equipment complete

Supply of P.V.C. rigid pipe & fittings (Medium quality) conforming to ASTMD 1785 &threaded to match with G.I. pipes as per IS-1239 (part-1) a) 80mm dia

Supply of G.I pipes as per IS specification a) 80mm dia (Medium Quality) b) Supply of G.I Socket with I.S.I. Mark

125 mm. thick brick work with 1st class bricks in cement morter (1:4) in ground floor.

Supplying, fixing, commissioning and testing solor Photo Voltaic Module 250Wp, 40V on existing iron frame structure each 156mm Monocrystalline Silicon solar cells laminated between sheet of -Ethylene Vinyl Acetate (EVA) and high transmissivity 3mm tempered glass. connforming to IEC 61215(revised) specifications or equivalent National or International Standards. The power output of the module(s) under STC should be a minimum of 250 W. The operating voltage corresponding to the power output mentioned above should be 56 V. The open circuit voltage of the PV modules under STC should be at least 57.0 Volts. The terminal box IP 65 Protection level on the module should have a provision for opening for replacing module.

Controller Unit (PCU) Supplying, fixing, commissioning and testing pump controller unit consisting with PCU Switching elements MOSFET Type of Charger PWM with MPPT technology Input from PV 800V max to 370V DC, 1 to 1.5HP, single Phase with protection Short circuit, Deep discharge, Input surge Voltage, over current, Battery reverse Polarity, Solar array reverse polarity Dielectric strength 1.1 KV between input/output and ground with EMI protections removed. Cooling Forced with temperature sensitive fan operation Ambient temperature 50 degree Celsius (Max) Operating Humidity 95% maximum Assembly/Mounting as per normal industrial practice Finish Epoxy Power Costing' Cable Entry from rear, preferably 200 mm above ground level all system parameters shall be displayed System parameters LCD display such as battery voltage, output (load) voltage, load current etc. (Kriloskar/Sukam/Exide) make

Suppy and Fixing round 2 core 4sqmm PVC multi core FR wire for array connecting

Earting with copper earth plate 600mmx600mmx4mm thick including accessories and providing masonary enclosure with cover plate having locking arrangemetn and watering pipe of 2.7 meter long etc with charcoal/choke and salt as require

Supplying and laying 13 mm X 3 mm copper strip at 0.50 metre below ground as strip earth electrode, including connection/terminating with nut, bolt, spring, washer etc. as required. (Jointing shall be done by overlapping and with 2 sets of brass nut bolt & spring washer spaced at 50mm)

Providing and fixing of lightning conductor finial, made of 25 mm dia 300mm long, copper tube, having single pro at top, with 85 mm dia 3mm thick copper base plate including holes etc. complete as required

Supply, Installation, tesing & lowering of 1 HP capacity photovoitatic solar submersible pump motor set complete having suitable dischage as per yeld test of well. Submerisble cable of 30mtr 3 core 2.5 sqmm that cable (Finolex) with MOC bar chart (KSB make Pump) and necessary control panel and starter as per manufacturar specifications

Water testing report from authenticate authorised organization/Instructions

Making soakpit with cover and necessary drain including all complite

Providing & fixing Concrete Sign Board as per IRCspecification of size 900 x 750 x 37 mm. thick made with RCC 1:12:3 with pakur variety stone chips reinforced with double layer IRC febric (75 x 75 mm. mesh) and fixed with necessary nuts & bolts on two RC precast posts 100 mm. x 150 mm. of height 2.65 m. of which top 750 mm. is of section 100 x 13 mm. and 1.90 metre above GL & 0.75 metre below GL including digging hole, repacking the same with cement concrete 1:3:6 with jhama khoa or with local stone chips etc. complete including painting two coats on both faces lettering sign marks etc. as per direction of the Engineer-in-Charge. (The rate is inclusive of cost of reinforcement, concrete, shuttering, nuts & bolts, washer etc. complete.)

Add GST @18%

Add Cess @1%