Zilla Parishad Tender

Hire and labour charges for shuttering with centreing and necessary staging upto 4 m. using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams, columns, lintels curved or straight including fitting, fixing and striking out after completion of works. (upto roof of ground floor). 25 mm to 30 mm shuttering without staging in foundation

Ordinary Cement Concrete M - 20 (mix 3 :1.5 :1) with graded stone chips (20 mm.down) excluding shuttering and reinforcement, if any, in ground floor, as per relevant IS codes. i) Pakur Variety

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups,binders etc. including supply of rods, initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape,placing in proper position and binding with 16 gauge black annealed wire at every inter-section, complete as per drawing and direction. JSW/ISPL/Shyam/SRMB/Elctrosteel/SSL

Holding down bolt with nut including 100 x 100 x 6 mm plate washer at bottom fitted complete and packing the hole with cement concrete or cement grout as directed.

Module – 100 wp (12 volt) : -Reputed Brand a) The PV Module shall contain Poly Crystalline black silicon solar cells and must have MNRE certified b) The power output of the modules under STC would be a minimum 100 wp at a load voltage of 20 (+/-) 0.2 V c) The open circuit voltage of the PV modules under STC would be 20 Volts. d) The module efficiency would be 14.5% e) A bird spike shall be provided to avoid bird sitting on the solar module at the highest point of the module structure. f) SPV module shall be highly reliable lightweight and shall be a service of life of more than 25 years. It shall have a limited power loss of not more than 10% of normal output at the end of 10 years and not more than 20% at the end of 25 years. g) The solar module shall be able to withstand the following environment at conditions normally encountered at the site – Temp. extremes ranging from 10’C to 85’C, wind load – 200 km/h, Max mean heavy rainfall of 40mm, Humidity level up to 95% h) Strip must contain the followings – Manufacturer name, model number, year of make.

Luminary – 24 watt LED based : (LED-Philips) + Housing a) LED Luminaries must be to prevent water seepage and entry of insects. b) The light source will be of white LED type. The luminous performance of LEDs used. Use of LEDs, which emit ultraviolet light must be avoided. c) The light output should remain constant with variations in the battery voltages. d) The make model number and technical characteristics of LED lights should be furnished.

Dusk to Dawn MPPT Charge Controller – 30Ah : -Raimond a) Battery over charge cut off : 20 V b) Battery deep discharge cut off : 23.5 V c) Short circuit protection inbuilt with the system d) Protections against battery reverse polarity inbuilt with the system e) Load re-connects facility inbuilt with the system

Luminary – 24 watt LED based : (LED-Philips) + Housing a) LED Luminaries must be to prevent water seepage and entry of insects. b) The light source will be of white LED type. The luminous performance of LEDs used. Use of LEDs, which emit ultraviolet light must be avoided. c) The light output should remain constant with variations in the battery voltages. d) The make model number and technical characteristics of LED lights should be furnished.

Supplying Octa Pole of height 7 m including Panel Structure and Light Arm a) A corrosion resistant metallic frame structure must be fixed on the pole to hold the SPV module. b) The frame structure must have provision to adjust its angle of inclination to the horizontal between 0 & 45,so that the module can be oriented at the specified tilt angel. c) Street Light (Round Pole)- Pole height 6 mtr, dia - top to bottom 76 mm, thickness 2 mm and weight 18kg with grouting facility.

Wire, Cable & Accessories : ISI STANDARD Cables are designed for connecting photovoltaic power supply systems. Cable shall contain: a) Capacity : According to requirements for Solar PV System b) Rated Voltage :- 0.6/1Kva AC c) Rated DC Voltage :- 1.5 K.V d) Working Voltage :- DC 1000V e) Insulation Resistance :- 1000M SI-Km f) Ambient :- 40°C – +90°C

Add photography and Marbel Falak including allied materials complete as per direction of EIC.

Add GST 18.00% [ CGST( 9.00%) + SGST (9% ) ]

Add Labour Welfare Cess @ 1.00%