Water Resources Development Directorate Tender

Withdrawal of electrical motor Submerssible pumping set of following capacities within the Tubewell housing pipe of the following length by using all necessary requisite tools and plants and carefully as per direction of the Engineer-in-Charge and stacking the same properly at site within the Tubewell premises complete. (a)100/150/200 Cubic meter per hour capacity electric motor Pumping set. (ii) length of pump assembly of any length exceeding 18 metre length.

Jointing water proof cable with the leads of the motor including soldering with requisite water proof insulation and proper jointing compound/Vulcanized rubber tape so that proper water proof insulation is assured.

Instalation of submersible electro motor pumping set of following capacities by using necessary requisite, tools and plants by lowering the same within the tubewell housing pipe upto the following depth as per direction by fitting, fixing column pipes and other accessories, fixtures with necessary nuts, bolts and washers and suspending the entire assembly of pump set vertically by fixing the same supported by M.S. clamps over the top of housing pipe, binding the motor cable with each column pipes and drawing cable upto pump controller/starter point including opening out of the top cap of housing pipe of the tubewell and testing of motor both in loading as well as in unloaded condition before and after installation of the same. (The rate is inclusive of hiring charges of tools & plants.) (a) 100/150/200 cubic metre her hour capacity electro motor pumping set. (ii) Length of pump assembly of any length exceeding 18 metre length.