Public Works Roads Department Tender

Bituminous Macadam using Mobile Hot Mix Plant (Light Duty): Providing and laying bituminous macadam with Mobile Hot Mix Plant (Light Duty) using aggregates of Grading-2 of Table-33 (22.4 mm S/Chips @ 0.4241m3/m3, 13.2 mm S/Chips @ 0.2827m3/m3, 11.2 mm S/Chips @ 0.3535m3/m3, 5.6 mm S/Chips @ 0.2121m3/m3 & Stone Dust with Grit @ 0.1414m3/m3) premixed with 75kg of bitumen per cum, transported to site laid over a previously prepared surface at specified laying temperature by means of approved and suitable arrangements to the required grade, level and alignment and rolled with suitable power roller for break down, inter-mediate and finished rolling as per specification to achieve the desired compaction including cost and carriage of stone materials and bitumen, hire charges of machinery and equipment, cost of fuel and lubricants and wages of operational staff, quality control complete as per Specifications for Road & Bridge Works of MoRT&H (5th Revision). For Grading 2 (19 mm nominal size, 50-75 mm thick.) Rate is inclusive of Cost of Applying of Tack Coat {Using Bitumen Emulsion @ 0.25 Kg/Sq.M.}.

Open-Graded Premix Surfacing using Bituminous (Viscosity grade Paving Bitumen / Modified bitumen) Binder and Mobile Hot Mix Plant (Light Duty). Providing, laying and rolling of Open - graded premix surfacing of 20 mm thickness composed of 13.2 mm (@ 0.018 m³ per m²) and 11.2 mm (@ 0.009 m³ per m²) size stone aggregates, including thoroughly cleaning of the surface, screening, cleaning and pre-heating stone chips and fully pre-coating the same using viscosity grade paving bitumen @ 1.46 Kg. per m2, carrying the mixture by any suitable arrangements, laying the mixture uniformly over the surface, including line, grade and level to serve as wearing course on a previously prepared base by applying tack coat using Bituminous Emulsion @ 0.25 Kg./m2, including mixing in Mobile Hot Mix Plant (Light Duty) and thoroughly rolling with a smooth wheeled roller 8-10 tonne capacity, finished to required level and grades including the cost and carriage of stone chips, matrix and emulsion, heating the matrix, preheating the aggregates to required temperature and including the hire charges of Mobile Hot Mix Plant (Light Duty) and other machinery, pay of operators, cost of fuel and lubricants etc. complete to be followed by seal coat of either Type A or Type B as per Technical Specification Clause 508 for Rural Roads of MORD. Rate is inclusive of Cost of Applying of Tack Coat {Using Bitumen Emulsion @ 0.25 Kg/Sq.M.}.

Seal Coat: Providing and laying Premixed Seal Coat (Type B) with approved quality sand/grit @ 0.6 m3/ 100 m2 and bitumen binder on thoroughly cleaned black top surface coated with tack coat, including heating and mixing cleaned sand/grit (100 % passing through 2.36 mm sieve and retained on 180 micron sieve) uniformly with bitumen binder, laying and spreading the mix at an uniform rate using suitable means, brushing the surface, if necessary, to ensure uniformity, followed by rolling with power roller including the cost and carriage of binder and aggregates, cost of heating the binder and aggregates and all other incidental charges, cost of fuel and lubricants, including hire charges of machineries, tools & plants required for construction and quality control complete as per Clause 511 of Specifications for Road & Bridge Works of MoRT&H (5th Revision). By Mechanical Means, over freshly laid 20 mm P.C. With Hot Bitumen Binder (@ 6.80 kg / 10 sqm.)