Public Works Department Tender

Close Bamboo Walling made of 65mm to 75mm dia. bamboos (in single line) driven about half-length into the ground side by side, with stout stays at an interval of 1m, 3nos. of half split bamboo runner of same dia fitted and fixed with nails etc. complete as per direction. (Measurement to be taken along the length of piling after finishing the works). With bamboos of length above 2.00m and upto 2.50m

Filling empty Cement bags with dry earth or sand, stitching the bag (cost of thread included) and carrying and placing them in position and all incidental charges complete but excluding cost of sand and gunny bags.

Supplying empty Cement bags in good condition.

Supplying transporting & fabrication of welded steel girder as per approved drawing duly made up built up sections of MS Plate, Angle, Channel of different thickness including metalizing priming coat followed by finish coat of paints of total thickness of 165μm. The rate shall be inclusive of supply of all the steels, labour consumables & machinery and all other materials & accessories required for fabrication to complete in all respect with all lead, lift etc. The rate is also includes( i) Cost of to and fro transportation between contractor's work shop & work site including all lead, lift, loading, unloading etc. (ii) Cost of inspection, testing of girders in stages by nominated inspection agency. Nomination of inspection agency for passing of fabricated members and trial assembly will be decided by Engineer-in-Charge. iii) Cost of supplying & fixing of HSFGI High strength bolts (not less than 8.8 grade). iv) Cost of blast-cleaning the steel surface including supplying & applying of zinc phosphate primer followed by finish coat of micaceous iron oxide pigmented drying oil type paint of total thickness of 165μm.

Cutting to requisite length or shape department R.S joists, channels, angles, tees, plates etc.

Labour for hoisting and placing in proper position (Up to 1st floor level) R.S joists, channels, angles, tees, plates etc. including fitting and fixing same with bolts and nuts, if necessary (But excluding cost of such bolts and nuts)

Direction and Place Identification Signs with size more than 0.9 sqm size Board. Providing and erecting direction and place identification retro- reflectorised sign as per IRC :67 made of high intensity grade sheeting vide clause 801.3, fixed over aluminium sheeting, 2 mm thick with area exceeding 0.9 sqm supported on a mild steel angle iron post 75 mm x 75 mm x 6 mm, 2 Nos. firmly fixed to the ground by means of properly designed foundation with M 15 grade cement concrete 45 cm x 45 cm x 60 cm, 60 cm below ground level as per approved drawing and Clause 801 of Specifications for Road & Bridge Works of MoRT&H (5th Revision)..

18 % GST of Amount Rs. 634319.61

1 % Cess of Amount Rs.748497.14