Public Works Department Tender

1st. Floor

2nd floor

3rd floor

4th floor

Plaster ( to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering conrners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (ground floor). [Excluding cost of chipping over concrete surface]. with 1:6 cement mortar. 15 mm. thick plaster. Basement

Ground Floor

1st Floor

2nd Floor

3rd Floor

4th Floor

Supplying and laying true to line and level Anti-Skid, Full Body,Homogeneous & Granular finish Vitrified Tiles conforming to IS:15622-2006 & IS 4457-2007 and testing shall be made in accordance withIS:13630 [Non- modular sizes for tiles with Skid resistance 0.5, Mohr'shardness 5.0, Staining resistance: Class-1, Water Absorption: E 0.5%], MOR 35 N/sq.mm in Internal area of building e.g. Toilet Block, Passage, Corridor, Accessible Open Terrace etc. set in 20 mm sand cement mortar (1:4) and 2 mm thick cement slurry at back side of tiles using cement @ 2.91 Kg./Sqm or using Polymerised Adhesive (6 mm thicklayer applied directly over finished artificial stone floor/ Mosaic etc without any backing course) laid after application slurry using 1.75 Kg of cement per Sqm below mortar only, joints grouted with admixture of white cement and colouring pigment to match with colour of tiles/ epoxy grout materials of approved make as directed and removal of wax coating of top surface of tiles with warm water and polishing the tiles using soft and dry cloth upto mirror finish complete including the cost of materials, labour and all other incidental charges complete true to the manufacturer's specification and direction of Engineer-in-Charge. (White cement,synthetic adhesive and grout material to be supplied by the contractor). In Ground Floor: Sizes-600 mm x600mm x10 mm with breaking strength 1500 N Basement

Ground Floor

1st Floor

Supplying,Fitting & fixing 1st quality Ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc. Wall With Sand Cement Mortar(1:3)15mm thick & 2 mm thick cement slurry at back side of tiles using cement @ 2.91 Kg/Sq.m. & joint filling using white cement slurry @0.20kg/Sq.m. Area of each tile the above 0.09Sq.m. Other than Coloured decorative including white. Basement

Ground Floor

1st Floor

2nd Floor

3rd Floor

4th Floor

Labour for taking out door and window frame including shutter for repair or replacemnt of different part of the frame and refixing the same including mending good all damages complete.(Concrete and brick work for mending damage will be paid separately). up to area 2.5 sq.m.

Taking out shutter of door and window, dismantaling by parts (for repair or replacement of damaged parts), reassembling and refitting and rehanging same with old fitting but with new screws as necessary.( where different part of same shutter are renewed under different item, payment under item 73 will be made once only).

Wood work in door and window frame fitted and fixed in position complete including a protective coat of painting at the contact surface of the frame excluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be corrected up to three decimals). Sal : Local. Ground Floor

1st Floor

4th Floor

Supplying, fitting and fixing M.S. clamps for door and window frame made of flat bent bar, end bifurcated with necessary screws etc. by cement concrete (1:2:4) as per direction. (Cost of concrete will be paid separately). 40mm x 6mm, 250mm Length .

Panel shutters of door and window, as per design (each panel consisting of single plank with out joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings.In ground floor.(In case of non-supply of single plank, panel rate of reduction of 20% will be made). 35mm.thick shutters with 19 mm. thick panel of size 30 to 45cm. sishu,gamar,Champ,badam,bhola, mogra,Hallak, .

Iron butt hinges of approved quality fitted and fixed with steel screws, with ISI mark. 100 mm x 58 mm x 1.90 mm.

Anodised aliminium D-type handle of approved quality manufactured from extruded section conforming to I.S. specification (I.S.230/72) fitted and fixed complete: With continuous plate base (hexagonal/round rod). 150 mm grip x 10 mm dia rod.

Anodise aluminium barred/tower/socket bolt (full covered) of approved manufactured from extruded section conforming to I.S.204/74 fitted and Fixed with cadmium plated screws: 200 mm long x 10 mm dia. bolt.

Acrylic Distemper to interior wall, ceiling with a coat of solvent basedinterior grade acrylic primer (as per manufacturer's specification)including cleaning and smoothning of surface.Two Coats

Priming one coat on timber or plastered surface with synthetic enamel oil bound primer of approved quality including smoothening surfaces by sand papering etc.

Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.

Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand parpering etc. in cluding using of approved putty etc. on the surface , if necessary. On timber or plastered surface: With super gloss (hi-gloss). Two coats (with any shade except white). .

On steel or other metal surface: With super gloss (hi-gloss). Two coats (with any shade except white). .

Supplying, fitting, fixing marble slab/tiles of 15mm. to 18mm. thickness in floor, lobby, stair, landing & treads etc. over 20 mm (av.) thick base of cement mortar (1:2) laid with white cement slurry @4.4 kg/sq.m before placing marble & jointed with white cement slurry @ 2.0 kg/sq.m with necessary pigments including grinding and Granite polishing as per direction of Engineer-in-charge in Ground Floor. {White cement and Pigment to be supplied by the Agency} With Makrana plain pink / Adranga pink / Garbh Gulabi/Udaypur pink / Udaypur Green / Black Bhaslana Area of each Slab/tile exceeding 0.3sq.m. but not exceeding 0.6 sq.m. Basement

Ground Floor

1st Floor

2nd Floor

3rd Floor

4th Floor

Extra cost of labour for prefinished and premoulded Nosing to (A) treads of step, railing, window sill etc. of Marble stone.

Supplying & laying 25 mm thick Tiles of any shade of approved quality as per relevant IS code, IS: 1237-2012 laid in pattern as directed for footpath, ramp, staircase of public building over 25 mm thick(Avg) Cement mortar (1:3) & Cement Slurry @ 4.4 kg/Sq.m at back side of Block. Cement for Mortar & Slurry to be supplied by Department in all respect with all labour and material. [Border concrete if necessary to be paid separately]. Note: Sub-grade CBR should not be less than 5. Coloured Decorative