Public Works Department Tender

Hire and labour charges for Shuttering with or without staging upto 4.0 m height using approved stout props with wooden planks/ply wood/steel sheet plate with required bracing for any kind of plain or reinforced concrete works in all sorts of minor structure including culvert, box culvert, crossdrain etc. The rate is inclusive of fitting, fixing and striking out after completion of work as per specification and direction. (b)Where staging is not required

Plain/Reinforced Cement Concrete in Open foundation with or without reinforcements, in any part of foundation of bridges/culverts with graded stone chips of appropriate nominal sizes, including screening and cleaning of coarse aggregates, fine aggregate (sand) conforming to proper grading zone, both of approved quality and cement, as necessary, cost of curing with water, including cost and carriage of all materials and 1.05 including preparation of design mix, approval of the same by the Engineer-in-Charge, cost for quality control, sampling, testing etc. including cost of formwork but excluding reinforcement complete as per drawing and technical specifications. RCC M-25 Grade:

Supplying, fitting and placing HYSD bar reinforcement in Bridge foundation including initial straightening, straightening of coils bars. removal of loose rust (if any), cutting to requisite length bending, binding with annealed wire not less than 1 mm in size and conforming to 15 280 at every intersection hooked and bent to correct shape and placed on forms etc. including cost of black annealed wire and cost of loading unloading, carriage of all steel materiais complete as per drawing and technical specifications Tor fiteel rod/HYSD bar/TMT bar. (SAIL/TATA/RINL) (Fe415 Fe500/Fe500D, conform to IS: 1786)

Providing weep holes in Brick masonry/Plain / Reinforced concrete abutment, wing wall/rotum wall with 100 mm dia AC pipe, extending through the full width of the structure with slope of 17:20H towards drawing face. Complete as per drawing and Technical specifications

Protection of embankment by cosely driven ven 150 mm dia eucalyptus bullah each of 5 m of total length driven 3 m into ground /bed of pond 300 mm c/c with 1800mm exposed height of each bullah including fittings of 3nas 100 mm dia half spiit eucalyptus bullah runner two on top of each face of close bullah walling and one on middle height of it, along full length of the walling including 100 mm diameter, 2.5 m long eucalyptus bullah tie fitted 2.5 m c/c with tie post, anchoring by driving 100 mm diameter, 2.5 m long eucalyptus bultah tie post, 1100mm into ground on the road side including fitting fixing 10cm to 13cm dia Eucalyptus bullah as ties and runners including necessary nails, bolts & nuts including supplying eucalyptus bullah, coal tar, nails, bolts, empty gunny bags etc and labour charges for cutting splitting bullah, coal tarring to each bullah driving charges for driving bullah into ground/bed of pond in standing water condition, fitting foxing charges for runner and tie, all complete in all respect as per drawing and direction of Engineer-In-Charges. (Payment will be made on finishede length of embankment complete in all respect as per specification and direction of Engineer-In-Charges. (Analysis Item)

Taking out Eucalyptus piles from elsewhere including carrying stacking materials in the nearest stack yard., Protection of embankment by cosely driven 150 mm dia eucalyptus builah each of 5 m of total length driven 3 m into ground /bed of pond 300 mm cic with 1800mm exposed height of each bullah including fittings of 3nos 100 mm dia half split eucalyptus bullah runner -two on top of each face of close bullah walling and one on middle height of it, along full length of the walling including 100 mm diameter, 2.5 m long eucalyptus bullah tie fitted 2.5 m c/c with tie post, anchoring by driving 100 mm diameter,2.5 m long eucalyptus bullah tie post, 1100mm into ground on the road side including fitting, fixing 10cm to 13cm dia Eucalyptus bullah as ties and 1.09 runners including necessary nails, bolts & nuts including supplying eucalyptus bullah, coal tar, nails, bolts, empty gunny bags etc and labour charges for cutting splitting bullah, coal tarring to each bullah driving charges for driving bullah into ground / bed of pond in standing water condition, fitting fixing charges for runner and tie, all complete in all respect as per drawing and direction of Engineer-In-Charges. (Payment will be made on finishede length of embankment complete in all respect as per specification and direction of Engineer-in-Charges. (Analysis Item) N. B. Considering 30% new bullah & balance 70% will be reuse from already used bullah.

Supplying empty cement bags in good condition, and labour for filling empty cement bags with sand and placing them in position including tying or sewing mouth (cost of thread included) and all incidental charges complete but including cost of earth and gunny bags

Dismantling Brick/Tile Work Dismantling of existing structures like culverts, bridges, retaining wells and other structures comprising of brick masonry, including disposal of unserviceable material and stacking the serviceable material with all lift and lead of 1000 m as per Technical Specifications Clause 202 for Rural Roads of MORD. (b) Cement mortar

Dismantling of Structure Dismantling of existing structures like culverts, bridges, retaining walls and other structure comprising of masonry, cement concrete, steel work, including T&P and scaffolding wherever necessary, sorting the dismantled material, disposal of unserviceable material and stacking the serviceable material with all lifts and lead of 1000 m as per Technical Specifications Clause 202 for Rural Roads of MORD (b) Cement Concrete

SUB TOTAL

GST @ 18% over Sl. No. 1 to 12

Labour Welfare Cess @ 1% over Sl. No. 1 to12