Municipal Corporation Tender

Wet Mix Macadam Base Course Providing, laying, spreading and compacting graded stone aggregate to Wet Mix Macadam specification including screening of aggregates and granular materials, premixing the material with water at OMC in Wet Mix Plant, carriage of mixed material by tipper to site, laying in uniform layers with Paver in Sub- base / Base course on well prepared surface and compacting with Vibratory Roller to achieve the desired density, including supply of all materials, machinery, fuel and lubricants, including incidental costs for lighting, guarding, barricading, making earthen bundh to protect the edges including cost of quality control complete as per Clause 406 of Specifications for Road & Bridge Works of MoRT&H (5th Revision). [PWD (Bldg) 2017, Analysed Rate]

Supplying ready mixed concrete of M 20 grade with well graded stone chips of 20 mm nominal size containing designed quantity of cement per Cu.m. of wet concrete produced in computerised batching plant under controlled condition using approved super plastisizer designing concrete mix following I.S. 10262 and I.S. 456 transporting the mix with agitation in transit mixer to work site depositing the mix on a platform erected for the purpose at required levels of concreting and then placing the mix in its final location of form work, compacting and curing the same complete as per specification & direction of the Engineer-in-charge including computerised batching plant transit mixer with all accessories vibrators etc. inclusive of all other incidental chages in this connection complete but excluding cost of hire charge of platform and its supporting staging which would be paid through separate item. [Cement to be supplied by the Manufacturer or supplier (i) Without approved concrete Pump [Ref: P.W.D (Bldg), Page-33 Item-19(i)]]

Brick work with 1 st class bricks in cement mortar (1:4) (a) In foundation and plinth [Ref : P.W.D.(Bldg) 2017 , Page - 15, Item-7]

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary.[Excluding cost of chipping over concrete surface] (a) 15 mm thick plaster (Ground floor) [Ref : P.W.D.(Bldg) 2017, Page-189 , Item-1.ii.]

Neat cement punning about 1.5mm thick in wall, dado, window sill, floor etc. [Ref : P.W.D.(Bldg) 2017, Page- 192, Item-15]

Supplying & laying as per IRC-SP:063-2004 paver unit of any shade of approved quality as per relevant IS code, laid in pattern as directed in pavement, footpath, driveway (paver block only), etc including necessary underlay complete in all respect with all labour and material. [Border concrete if necessary to be paid separately]. Note: Sub-grade CBR should not be less than 5.80 mm thick interlocking designer concrete paver block M-40 grade for medium-traffic zone & utility cuts on arterial roads etc. as per IS: 15658-2006 (over 20-40 mm medium sand bed on 250mm thk WBM/ WMM base course & 250 mm thk bound gnaular/ granular sub-base course & filling the interstices of blocks with fine sand by brooming & subsequent watering including cost of sand for sand bed but excluding cost of base, sub-base course & subgrade preparation.) complete as per direction of Engineer-in-Charge. [Note: Subgrade CBR should not be less than 5] i) Grey [Ref : P.W.D.(Bldg.) 2017, Page - 286 Item-8]

Hire and Labour Charges for shuttering with hard wood for precast R.C. Slab curved, or stright and striking out the same including fitting, fixing the precast slab in position with necessary carriage and haulage, hosting etc, complete in all respect. [Ref: P.W.D (Bldg) 2017, Page-43, Item No- 38]

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction. Tor steel/Mild Steel a) SAIL/ TATA/RINL [Ref : P.W.D (Bldg) 2017, Page-1 Item No. 40(a)(i)&(b)]

Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. (i) Pakur Variety [Ref: P.W.D (Bldg) 2017, Analysed Rate]

Add 18% G.S.T.

Add 1% Welfare Cess