Municipal Corporation Tender

Single brick flat soling of picked jhama bericks including ramming & dressing bed to proper level and filling joints with local sand [Ref : P.W.D.(Bldg.) 2017, Page -14, Item-1]

Cement concrete with graded jhama khoa (30 mm size) excluding shuttering In ground floor and foundation.(a) 1:3:6 proportion [Ref : P.W.D.(Bldg) , Page-23, Item No.1(a)]

Supplying ready mixed concrete of M 20 grade with well graded stone chips of 20 mm nominal size containing designed quantity of cement per Cu.m. of wet concrete produced in computerised batching plant under controlled condition using approved super plastisizer designing concrete mix following I.S. 10262 and I.S. 456 transporting the mix with agitation in transit mixer to work site depositing the mix on a platform erected for the purpose at required levels of concreting and then placing the mix in its final location of form work, compacting and curing the same complete as per specification & direction of the Engineer-in-charge including computerised batching plant transit mixer with all accessories vibrators etc. inclusive of all other incidental chages in this connection complete but excluding cost of hire charge of platform and its supporting staging which would be paid through separate item. [Cement to be supplied by the Manufacturer or supplier (i) Without approved concrete Pump [Ref: P.W.D (Bldg), Page-33 Item-19(i)]]

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary.[Excluding cost of chipping over concrete surface] (a) 15 mm thick plaster (Ground floor) [Ref : P.W.D.(Bldg) 2017, Page-189 , Item-1.ii.]

Neat cement punning about 1.5mm thick in wall, dado, window sill, floor etc. [Ref : P.W.D.(Bldg) 2017, Page- 192, Item-15]

Construction joint at road with 12mm thick thermocol board, in position including cutting to requisite size and shape all direction of Engineer-in-Charge. [Rate as per Analysis No: 37]

Bitumen filler for considering the section 25mm X 30mm all direction of Engineer-in-Charge. [Rate as per Analysis No: 36]

Add 18% G.S.T.

Add 1% Welfare Cess