Municipal Affairs Department Tender

Supplying HDPE (Materials grade PE-100) pipes conforming to IS 14333:1996 with latest revision & amendments if any with necessary HDPE specials (excluding cost of CIDF valves) including labour charges for earth work in excavation in any kind of soil including mixed soil with boulder,road sub-grade and aits flank but excluding moorum laterite or sand stone / hard rock cutting with chisel required including cutting road flank/ brick pavement etc. without damaging the exisiting telephone/electrical cable line etc.(in case of damage of any type of cable line by the agency at the time of execution necessary damage charge as applicable by the respective authority will have to be brone by the agency at his own cost)upto the depth (av.) so as to maintain 1.10m.earth cushion from top of the pipe upto G.L. including loading unloading carrying lowering laying fitting fixing carefully pipes, valves and specials with the all types of jointing materials in trenches maintaining proper levels and alignment jointing the pipes and specials by butt welding/ adopting suitable method (But weld jointing with help of hydraulic tack and trimming machines, Hitter etc. for reaching at necessary melting point of HDPE pipe so that joint can be monolithic) so as to facilitate the maintenance of pipe line locally as per conventional method in future (A) Pressure Rating : PN 6 (ii) Laying of pipe line including cost of pipe & fittings/specials but excluding cost of valves. 110mm (OD) As there is no rate for supplying and laying of HDPE pipe line for Sewer connection, rate for supplying HDPE pipe for water supply from PHED(SOR) has been taken. However works should be done following IS 14333:1996 & other related IS Code.

75mm(OD) (With each House Connection 3m)

Constructing Inspection pit of inside measurement 600mm X 600mm X up to 600mm(depth) with 250 mm thick 1st. class brick work in cement mortar (1:4) on all sides, bottom of the pit consisting of 100 mm thick cement concrete (1:3:6) with stone chips over a layer of jhama brick flat soling, 15 mm thick (1:4) cement plaster to in sidewalls and out-side walls up to G.L. and 20 mm.thick (1:4) plaster to bottom of the pit, providing necessary invert with cement concrete (1:3:6) with stone chips as per direction, neat cement finishing to entire internal surfaces, top of the pit covered with 100 mm thick R.C.C. slab (1:1.5:3) with stone chips and necessary reinforcements up to 1% and shuttering including 6 mm thick cement plaster (1:4) in all external surfaces of the slab and one 560 mm dia. R.C.C. manhole cover of approved make supplied, fitted and fixed in the slab with necessary fittings, necessary earthwork in excavation in all sorts of soil, filling sides of the pit with earth and removing spoils after work complete in all reJSW/JSPL/SHYAM/SRMB/BMASL/ELECTROSTEEL/SSL)

Supplying, fitting and fixing cast iron 'P' or 'S' trap conforming to I.S.3989/ 2009 and 1729/ 2002 including lead caulked joints and painting two coats to the exposed surface. (Painting to be paid separately).(B) 'S' Trap (ii) 75 mm

Restoration of Beneficiary Facilities

Dismantling Stone Masonry as per Technical Specification Clause 202. Dismantling of existing structures like culverts, bridges, retaining walls and other structure comprising of stone masonry, including disposal of unserviceable material and stacking the serviceable material with all lift and lead of 1000 m as per Technical Specifications Clause 202 for Rural Roads of MORD,Rubble Stone Masonry in Cement Mortar

Rubble masonry in cement (1:4) with hard dressed stones from approved quarries and clean, coarse and washed sand including carriage of all materials to site. In Fine dressed work in Building, In Ground Floor.

Stone Boulder 150 mm N.B. Variety laying 150 mm to 200 mm boulder soling including rough dressing hand packing and ramming down small pieces in the interstics including rolling and preparing the bed to proper level and filling up all joints with sandy clay or earth, without rolling but including ramming. (Rate Analysis)

Road Restoration Bituminous

Water Bound Macadam Base Course Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with vibratory roller 8-10 tones in stages to proper grade and camber, applying and brooming requisite type of screening / binding materials to fill up the interstices of coarse aggregate, watering including lighting, guarding, barricading and making necessary earthen bundh of one meter width on each side and preparing the bed by necessary cutting or filling, including cost of all materials and hire and labour charges of all men and machinery and compacting to the required density, as per Clause 404 of Specifications for Road & Bridge Works of MoRT&H (5th Revision). (i) Grading-I Aggregate (63 mm to 45 mm) Using Stone Screening Type A (13.2 mm) (Rate Analysis)

Prime Coat Providing and applying primer coat with Cationic Bitumen Emulsion of approved grade conforming to IS: 8887-1978 and requisite quantity on prepared surface of granular base including cleaning of road surface and spraying primer using Mechanical means including cost and carriage of bitumen emulsion and all other incidental costs of work complete as per Clause 502 of Specifications for Road & Bridge Works of MoRT&H (5th Revision).(i) For WBM / WMM Surface: (with primer @ 0.85 kg/sqm).

Providing and applying tack coat with Cationic Bitumen Emulsion of approved grade conforming to IS: 8887-1978 on the prepared surface cleaned with Hydraulic broom, moistening the surface including cost and carriage of emulsion, hire charges of machinery and labour, cost of fuel and lubricants all complete as per Clause 503 of specifications for Road & Bridge Works of MoRT&H (5th Revision) (ii) On Granular surfaces treated with primer (Using Bitumen emulsion at the rate of 0.275 kg per sqm.)

Providing and laying Mastic asphalt wearing course with paving grade bitumen meeting the requirements given in table 500-29 using approved coarse aggregate, fine aggregate, filler material and bitumen, prepared by using Mastic cooker including cost and carriage of all ingredients, cost of heating aggregates and binder, mixing in specified proportions conforming to approved Job Mix Formula and laid to required level and slope after cleaning the surface, compacting, sealing the construction joints and surface finishing conforming to specifications including providing antiskid surface with bitumen pre-coated fine-grained hard stone chipping of 13.2 mm nominal size at the rate of 0.005 cum per 10 sqm and at an approximate spacing of10 cm center to center in both directions, pressed into surface when the temperature of surfaces not less than 100°C, protruding 1 mm to 4 mm over mastic surface, including the hire charges of all tools and plants and machinery, pay of operators, cost of fuel and lubricants and all other incidental charges and quality control all complete as per Clause 516 of Specifications for Road & Bridge Works of MoRT&H (5th Revision).(i) 25 mm thickness.

Road Restoration C.C Road

Stone Boulder 150 mm N.B. Variety laying 150 mm to 200 mm boulder soling including rough dressing hand packing and ramming down small pieces in the interstics including rolling and preparing the bed to proper level and filling up all joints with sandy clay or earth, without rolling but including ramming. (Rate Analysis)

Hire and labour charges for shuttering with centering and necessary staging up to 4 m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works (up to roof of ground floor) 25 mm to 30 mm shuttering without staging in foundation

Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement, if any, in ground floor as per relevant IS codes. River bazree

Uplift of Manhole

Uplift of Manhole by using existing Slab and cover with attached analysed rate B. Road Type C.C Road i. Raised height 0.3 m

Uplift of Manhole by using existing Slab and cover with attached analysed rate B. Road Type C.C Road ii. Raised height 0.5 m

Uplift of Manhole by using existing Slab and cover with attached analysed rate B. Road Type C.C Road iii. Raised height 0.65 m

Uplift of Manhole by using existing Slab and cover with attached analysed rate C. Road Type Earthen ii. Raised height 0.5 m

Restoring Manhole form below the Surface Level as per direction of EIC and complete in all respect. Analysed Rate

A. Road Type Bituminous

B. Road Type C.C Road

B. Road Type Earthen

Laying of New Trunk Line with Road Restoration

Supplying, laying, fitting fixing completed in all respect with road restoration as per Direction of EIC. 160 mm dia HDPE pipe with Road Restoration B. i. On C.C Road

Supplying, laying, fitting fixing completed in all respect with road restoration as per Direction of EIC. 160 mm dia HDPE pipe with Road Restoration ii. Construction of MH completed in all respect

Supplying, laying, fitting fixing completed in all respect with road restoration as per Direction of EIC. 160 mm dia HDPE pipe with Road Restoration C. i. On Earthen Road

Supplying, laying, fitting fixing completed in all respect with road restoration as per Direction of EIC. 160 mm dia HDPE pipe with Road Restoration ii. Construction of MH completed in all respect

C.I. sluice valve with flanged ends drilled to as per I.S. 1358/62 and having all cast iron components as per I.S. 780/71 solid forged bronze inside screw spindle having ultimate tensile strength not less than 4.72 MT per sq. cm. Spindle nut valve and seat faces of hard wear resisting, manufactured from best quality gunmetal conforming to I.S. 780/71, painted black all over with asphalt base paint tested to 21 kg (hydraulic pressure) per sq. cm., valve opening to anticlockwise direction, fitted and fixed complete. (iii) 100mm

Sluice valve chamber with C.I. heavy cover with locking arrangement,(weight not less than 25 kg) (size of chamber 450 mm X 600 mm inside up to 900 mm depth) 250 mm thick cement brick walls (6:1), 150 mm thick cement concrete (6:3:1) bed with stone chips, 20 mm thick cement plaster (6:1) for inside wall and 15 mm thick cement plaster (4:1) for outer walls including rounding corners.

Operational and Maintenance Cost of General Works of STP's & Sewer Lines including House Service connection

Operation and Maintenance Cost of House service connections, Sewer Lines and Trunk Lines for 3 years

Operational and Maintenance Cost of STP-2

Operational and Maintenance Cost of 1 Nos STP-1 3 years (E & M Part)

Annual Repair and Maintenance cost of STP-1 for 3 Years (as per KMDA norms)

Add GST @ 18% ( Sl no 1 to Sl no 9)

Add CESS @ 1%