Municipal Affairs Department Tender

Filling in foundation or plinth by fine sand in layers not exceeding 150 mm. As directed and consolidating the same by through saturation with water ramming complete including the cost of supply of sand . (payment to be made measurement of finished quantity )

Supplying and laying polythene sheet (150gm/sqm) over damp proof cource of below flooring terracing or in foundation trenches.

Single Brick flat soling of picked jhama bricks including ramming and dressing bed to proper level and filling joints local sand.

(I) Cement concrete with graded stone ballast (40 mm size excluding shuttering) In ground floor (A) [Pakur Variety] (a) 1:3:6 proportion

125mm thick brick work with 1st. class bricks in cement mortar (4:1). a) In ground floor

Ordinary cement concrete (Mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground Floor as per relevant IS codes. i) Pakur variety

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction. (a) For works in foundation and upto roof of ground floor/upto 4 m (i) Tor steel : SAIL/ TATA/RINL

Hire and labour charges for shuttering with centring and necessary stagging upto 4.0 meter using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs,beams & columns,lintels,curved or straight including fitting,fixing and striking out after completion of works. (up to roof of the ground floor) a) 25 mm to 30 mm thick wooden Shuttering as per decision & direction of E.I.C.

Plaster ( to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and racking out joints or roughening of concrete surface including throating, nosing and drip course where necessary.Excluding cost of Chipping over Concrete Surface. i) in ground floor b) 20mm thick (1:4) cement mortar

Neat cement punning about 1.5 mm thick in wall/ dado, window sills, floor, drain etc.Note: Cement @ 0.152 cum./% sqm.

Applying Exterior grade Acrylic primer of approved quality and brand on plastered or cencrete surface old or new surface to receive decorative textured(matt finish) or smooth finish acrylic exterior emulsion paint including scraping and preparing the surface throughly, complete as per manufacturer's specification and as per direction of the EIC (a) One coats.

Protective and Decorative Acrylic exterior emulsion paint of approved quality, as per manufacturer's specification and as per direction of EIC to be applied over acrylic primer as required. The rate includes cost of material, labour, scaffolding and all incidental charges but excluding the cost of primer. In Ground floor (Two Coat) a) Normal Acrylic Emulsion

M.S. gate of Jail type as per approved design made of strong M.S. frame work, intermediate stiffeners and round / square bars or angles. M.S. sheet (not less than 14 gauge) gussets, cleats etc. including necessary riveting, bolting, welding, locking and hanging arrangements, fitting and fixing complete as per direction of the Engineer-in -charge. in ground floor

M.S. structural works in columns, beams etc. with simple rolled structural members (e.g. joists, angle, channel sections conforming to IS: 226, IS: 808 & SP (6)- 1964 connected to one another with bracket, gussets, cleats as per design, direction of Engineer-incharge complete including cutting to requisite shape and length, fabrication with necessary bolting, metal arc welding conforming to IS: 816- 1969 & IS: 1995 using electrodes of approved make and brand conforming to IS:814- 2004, haulage, hoisting and erection all complete. The rate includes the cost of rolled steel section,consumables such as electrodes, gas and hire charge of all tools and plants and labour required for the work including all incidental chages such as electricity charges, labour insurance charges etc. Payment to be made on the basis of calculated weight of structural members only in finished work as per IS specified weight. Payment for gusset, bracket, cleat, rivets, bolts and nuts may be make by adding the actual weight of such items with the weight of finished structural members or 7% of weight for finished structural members weighing not less than 22.5 Kg. / m. or 15 % of weight for finished structal members weighing less than 22.5 Kg. / m. may be increased allow for bracket, cleat, rivet, bolts and nuts etc. and no seperate payment being made for these items, as per direction of Engineer In Charge. The rates are considered for a height of erection 8m. / 2nd floor level from the ground. Add 1.5% extra over the rate for each additional floor or 4m. beyond initiial 8m. or part thereof.

Supplying fitting and fixing 600 mm ( ±30 mm) diametre R.B.T Reinforced Barbed Tape) Concertina fencing on wall top using concertina coils stretched to approx.6 meters length at site clipped with two nos. of horizontal R.B.T strands which will be tensioned and fixed with the vertical M.S angle iron posts by means of security fasteners (such as 'C' clips, R.B.T clips etc.)

Supplying Eucalyptus-bullah piles at work site, including dressing and making one end pointed. (iii) 150 mm diameter Main Posts 400 nos of length 4.0 mtr

(iii) 125 mm diameter for Runners 2 X 100 mtr = 200 mtr

(i) 100 mm diameter for Tie post 100 X 3 Mtr =300 mtr for Tie Bar 100 X 2 Mtr = 200 Mtr

Labour for driving Sal-bullah / Eucalyptus bullah piles by monkey in sorts of soil including hoisting and placing piles in position, protecting the pile head with iron ring and cutting and shaping heads before and after driving and including hire and labour for necessary driving appliances and all tackles. (iii) 150mm diameter

Labour for fitting and fixing 10 cm. to 13 cm. diameter Sal-bullah/Eucalyptus-bullah as ties and runners including necessary nails, bolts and nuts.

Coal tarring on wooden surfaces including cost of materials a) Double coat.

Removal of rubbish,earth etc. from the working site and disposal of the same beyond the compound, in conformity with the Municipal / Corporation Rules for such disposal, loading into truck and cleaning the site in all respect as per direction of Engineer in charge

CGST 9% + SGST @9%

Cess @ 1%