Municipal Affairs Department Tender

Cement concrete with 30 mm down graded shingles excluding shuttering. N.B. Variety. In ground floor (a) 1:3:6 proportion

Hire and labour charges for shuttering with centering and necessary staging upto 4 m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works (upto roof of ground floor) (f) 25 mm to 30 mm shuttering without staging in foundation

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface] ii) With 1:4 Cement mortar. c) 10 mm Thick plaster

Neat cement punning about 1.5mm thick in wall,dado,window sill,floor etc.

Supplying and laying in the specific pattern of interlocking concrete block pavements (ICBP) with concrete blocks(with concrete grade as specified as per Table-I of I.S. 15658:2006) manufactured in steel mould clamped to a vibrating table by hydraulic pressure (as per cl. no. 6.30 of IRC : SP : 63(2018) from BIS licensee manufacturer with spacer nib (small protriuding profiles on the vertical face of a paver block used as a device for keeping minimum joint gap in between the paving blocks as per Cl. No. 3.26 of IS: 15658) and of specified size and shape with aspect ratio (The ratio of length to thickness of a paver block as per Cl. No. 3.3 of IS: 15658) as per Table 2 of IS:15658 with flexural strength/breaking load as per Annexure G of IS:15658, on the prepare base course of specified CBR as per Table I of IRC SP 63(2018) or else as mentioned in design and drawing with a cushion of compacted bedding sand of 25-35 mm thick ( grading of the bedding sand as per clause 6.5.1 of IRC SP-63) and filling up the gaps in between paver blocks with joint filling sand (the grading of the joint filling sand will be as per clause 6.5.2 of IRC SP-63) and completing the edges with cut blocks as per cl. no. 8.7 of IRC SP-63(2018) with proper confinement of bedding and joint filling sand, compaction, levelling and filling up of the edge gap. 80mm thick. Colour Decorative

Add- 18% GST for Sl. 1 to 20

CESS- 1 % for sl. 1 to 21