Municipal Affairs Department Tender

Plum concrete work with 40 % cement concrete with 30 mm down graded stone metal and 60 % stone boulder of size 150 mm and above, placed in position as directed excluding shuttering if any.(1:3:6) proportion

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and ranking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor). [Excluding cost of chipping over concrete surface] (ii) With 1:6 cement mortar (c) 15 mm thick plaster

Neat Cement punning in wall dado, window sills,floor, drain etc.

Picking up and removing old bituminous layer or sand sealing coat from old black topped surface and cleaning the exposed surface by scraping and stacking the material as directed (a) By manual means (i) From 25 mm to 50 mm thick .

Water Bound Macadam Base Course Providing, Laying, spreading and compacting stone aggregates of specific sizes to water bound macadam application including spreading in uniform thickness, hand packing, rolling with vibratory roller 8-10 tonnes in stages to proper grade and camber, applying and brooming requisite type of screening/ binding materials to fill up interstices of coarse aggregate, watering including lighting, guarding, barricading and making necessary carthen bundh of one metre width on each side and preparing the bed by necessary cutting or filling including cost of all materials and hire and labour charges of all men and machinery and compacting to the to the required density, as per Cluase 404 of Specifications for Road & Bridge Works of MoRT&H (5th Revision) (iii) Grading - II Aggregate (53 mm to 22.4 mm) Using Stone Screening Type B (11.2) B. Manual Means;

Prime Coat Providing and applying primer coat with Catonic Bitumen Emulsion of approved grade conforminbg to IS; 8887- 1978 and requisite quantity on prepared surface of granular surface including cleaning of road surface and spraying primer using Mechanical means including coast and carriage of bitumen emulsion and all other identical costs of work complete as per Clause 502 of Specifications for Road & Bridge Works of MoRT&H (5th Revision) (i) For WBM / WMM Surface. (with primer @ 0.70 - 1.0 kg/sqm);

Bituminous Macadam using Mobile Hot Mix Plant (Light Duty) : Providing and laying bituminous macadam with Mobile Hot Mix Plant (Light Duty)using approved aggregates of specified grading as per Table 500.7 premixed with bituminous binder, transported to site laid over a previously prepared surface at specified laying temperature by means of approved and suitable arrangements to the required grade, level ana alignment and rolled with suitable power roller to break down, intermediate and finished rolling as per specification to the desired compaction including cost and carriage of stone materials and bitumen, hire charges of machinery and equipment, cost of fuel and lubricants and wages of operational staff, quality control complete as per Specifications for Road & Bridge Works of MoRTE&H (5th Revision) B. For Grading 2 (19mm nominal size, 50-75 mm thick.);

Mastic Asphalt : Providing and laying Mastic asphalt wearing course with paving grade bitumen meeting the requirements given in table 500-29 using approved coarse aggregate, fine aggregate, filler material and bitumen, prepared by using Mastic cooker including cost and carnage of all ingredients, cost of heating aggregates and binder, mixing in specified proportions conforming to approved Job Mix Formula and laid to required level and slope after cleaning the surface, compacting, sealing the construction joints and surface finishing conforming to specifications including providing antiskid surface with bitumen pre-coated fine grade hard stone chipping of 13.2 mm nominal size at the rate of 0.005 cum per 10 sqm and at an approximate spacing of 10 cm center to center in both directions, pressed into surface when the temperature of surfaces not less than 100'C, protruding 1 mm to 4 mm over mastic surface, including the hire charges of all tools and plants and machinery, pay of operators, cost of fuel and lubricants and all other incidental charges and quality control all complete as per Clause 516 of Specifications for Road & Bridge Works of MoRT&H. (i) 25 mm thickness;

Hire and labour charges for Shuttering with centering and necessary staging upto 4m using approved stout props and thick hard wood planks of approved etc.

Add GST @18%

Add Labour Welfare Cess @1%