Department Of Higher Education Tender

Single Brick Flat Soling of picked jhama bricksincluding ramming and dressing bed to proper level andfillingjointswithlocalsand. .

Supplying and laying Polythene Sheet (150gm /sq.m.) over damp proof course or below flooring or roof terracing or in foundation or in foundation trenches.

Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement, if any, in ground floor as per relevant IS codes. a) Pakur Variety (including carraige) for ground floor

Hire and labour charges for shuttering with centering and necessary staging up to 4 m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works (up to roof of ground floor) of 25 mm to 30 mm shuttering without staging in foundation

Brick work with 1st class bricks in cement mortar(1:6) b) In superstructure, ground floor

Labour for Chipping of concrete surface before Taking up Plastering work.

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface] (ii) With 1:4 cement mortar (c) 10 mm thick Plaster for ground floor

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar (i)With 1:6 cement mortar(c)15 mm thick plaster for ground floor

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar (i) With 1:6 cement mortar(b)20 mm thick plaster for ground floor

Neat cement punning about 1.5 mm thick in wall, dado, window sill, floor etc. NOTE: Cement 0.152 cu.m per100 sq.m.

Supplying , fitting & fixing Zn-Al alloy (55% Al & 45%Zn) coating of 150 grams per sq. metre (followed bycolour coated on both side) steel sheet work havingminimum yield strength of 550 Mpa of trapizoidalprofile of approved make (excluding the supportingframe work) fitted and fixed with 55 mm & 25 mmself tapping screw, EPDM Washer 16 mm dia& 3 mmth.washer etc. complete with 150 mm end lap andone corrugation minimum side lap. (Payment to bemade on area of finished work).(i) In Roof:- a) With 0.5mmthicksheetIngroundfloor.

Priming one coat on timber or plastered surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc. in Ground floor:

(A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary (a) On timber or plastered surface : With super gloss (hi-gloss)-(iv)Two coats(with any shade except white)

Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc. in Ground floor:

(A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary (b)On steel or other metal surface : With super gloss (hi-gloss)-(iv)Two coats(with any shade except white)

Acrylic Distemper to interior wall, ceiling with a coat of solvent based interior grade acrylic primer (as per manufacturer's specification) including cleaning and smoothning of surface. Two Coats

Supplying, fitting and fixing Stainless Steel railing consist of 38 mm dia and 900 mm height vertical balustrade at every two alternative steps, 50 mm dia top rail, 3 (three) nos 19mmdia horizontal Strainless steel pipe and base/ cover plate with Strainless Steel GRADE 304 containing 7.5% nickle(Interior Grade) Brushed/Mat finish, complete as per direction of the Engineer-in charge. Weight of Strainless Steel railing per metre 6.5 Kg (approx) in ground floor.

Supplying, Fitting&Fixing30mmthickFactorymade solid Panel PVC Door Shutter consisting of outer frame made out of M.S. tubes of 19 gauge thickness and size 19 mmx19 mm for styles, top and bottom rails, M.S. frame shall have cost of steel primers of approved make and manufacture, M.S.frame covered with 5 mm th. heat moulded PVC “C” channel of size 30 mm th, 70 mm width out of which50 mm shall be flat and 20 mm shall be tapered in 45degree angle on either sides forming styles; and 5mm th. 95 mm wide PVC sheet out of which 75 mm shall be flat and 20 mm tapered in 45 degree on the inner side to form top & bottom rail and 115 mm wide PVC sheet out of which 75mm shall be flat and20 mm shall be tapered on both sides to form lock rail. Top, bottom and lock rails shall be provided either side of the panel with 10 mm (5 mm x 2) th., 20mm wide cross PVC sheet as gap insert for top rail and bottom rail. Paneling of 5 mm th. both side PVC sheet to be fitted in the M.S. frame welded/sealed to the styles&railswith7mm(5mm+2mm)th.x15mm wide PVC sheet beading on inner side and joined together with solvent cement adhesive. An additional5 mm th. PVC strip of 20 mm In ground floor.

Supplying, fitting & fixing granite slab 15mm to18 mm thick in floor, lobby, stair, landing and treads etc. over 20mm (avg) thick base of cement morter(1:2) laid with white cement slurry @ 4.40Kg per Square meter before placing of granite and jointed with white cement slurry @ 2.0 Kg per square meter with necessary pigments and complete as per direction of Engineer-in-charge including cost of all materials, labours, curing and roughening of concrete surface complete. (b) Area of each Granite slab 0.6 to 1.0 Square meter.

Wash basin vitreous china of approved make(without fittings) supplied, fitted and fixed in position on 75mm X 75 mm X 75 mm wood blocks and C.I. brackets including two coats of painting of C.I. brackets. (i) 450 mm X 300 mm size

Supplying, fitting and fixing best quality Indian make mirror 5.5 mm thick with silvering as per I.S.I. specifications supported on fibre glass frame of any colour, frame size 550 mm X 400 mm.

Supplying, fitting and fixing towel rail with two brackets. (a) C.P. over brass. (i) 25 mm dia. and 450 Mm long

Supplying, fitting and fixing soap holder. (a)PTMT (Prayagor equivalent)

Supplying, fitting and fixing PVC pipes for underground work of approved make of Schedule 80(medium duty) conforming to ASTMD - 1785 and threaded to match with GI Pipes as per IS : 1239(Part - I). with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, long screw, reducing socket, reducing tee, short piece etc. fitted including cost of all materials, jointing materials, cutting pipes, making threads , cutting trenches up to 1.5 metre below surface in all sorts of soil and refilling the same as directed complete in all respect. (Payment will be made on the centre line measurement of the total pipe line including all specials No separate payment will be made for accessories, specials.) PVC Pipes (Dia) 100 mm

Supplying, Fitting and Fixing of Window & Door Cutain including the brackets of stainless steel pipe and accessories for fitting the materials and the work has been work as per EIC.

Add GST@18.00%onTotal Cost of Work

Add Labour welfare CESS@1.00%