Gorkhaland Territorial Administration Tender

Stone boulder delivered and stacked at site. (N.B variety stone metal)

Ordinary cement concrete (mix1:2:4) with graded stone chips (20mm down) excluding shuttring and reinforcement, if any, in ground floor as per relevent IS Codes. (b)River bazree

Ordinary cement concrete (mix3:1.5:1) with graded stone chips (20mm down) excluding shuttring and reinforcement, if any, in ground floor as per relevent IS Codes. (b)River bazree

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc. including supply of rods, initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at inter-section, complete as per drawing and direction.II. Other than SAIL/ TATA/RINL

Hire and labour charge for shuttering with centreing and necessary staging upto 4 m. using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, columns, lintels curved or staight including fitting fixing and striking out after complection of works. (upto roof of ground floor)

Plum concrete work with 40% cement concrete with 30 mm down graded stone metal and 60% stone boulder of size 150 mm and above, placed in position as directed excluding shuttering if any. (i) (1:3:6) proportio

125 mm. thick brick work with 1st class bricks in cement mortar (4:1) in ground floor.

Wood work in door and window frame fitted and fixed complete including a protective coat of painting at the contact surface of the frame. (The quantum should be corrected upto three decimals) Sal : Local

Supplying, fitting and fixing M.S. clamp for fixing door and window frame made of flat bent bar, end bifurcated, fixed in cement concrete with stone chips (4:2:1) fitted and fixed complete as per direction. (Cost of cement concrete will be paid separately).(a) 40mm X 6mm, 250mm Length

Panel shutters of door and window, as per design (each panel consisting of single plank without joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings. In ground floor. (i) 50mm thick shutters with 25mm thick panel of size 30 to 45 cm (a) 1st class best Indian teak wood.

(a) M.S.or W.I. Ornamental grill of approved design joints continuously welded with M.S, W.I. Flats and bars of windows, railing etc. fitted and fixed with necessary screws and lugs in ground floor. (i) Grill weighing above 10 Kg./sq.mtr and up to 16 Kg./sq. mtr

Plaster ( to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering conrners as directed and raking out joints or roughening of concrete surface, including throating, nosing and drip course where necessary (ground floor). (ii) With 4:1 cement mortar (a) 20 mm thick plaster

Supplying best Indian sheet glass panes set in putty and fitted and fixed with nails and putty complete. (In all floors for internal wall & upto 6 m height for external wall) (i) 3 mm thick (weighing 7.4 kg/Sq.m)(ii) 4 mm thick

M.S. structural works in roof trusses with hollow sections conforming to IS: 806- 1957 & IS: 1161- 1958 connected to one another with bracket,gusset,cleats as per design, direction of Engineer-In-Charge complete including cutting to requisite size. fabrication with necessary metal arc welding conforming to IS: 816- 1956 & IS: 9595 using electrodes of approved make and brand conforming to IS: 814- 1957, haulage, hoisting and erection all complete. The rate includes the cost of rolled steel section. consumables such as electrodes, gas and hire charges of all tools and plants and labour required for the work including all incidental charges such as electricity charges, labour insurance charges etc. Payment to be made on the basis of calculated weight of structural tubular memebrs as specified in relevent IS code in finished work.Payment for gusset, bracket, cleat may be gas and hire charge of all tools and plants made by adding the actual weight of such items with rates are considered for a height of erection 8 m. /2nd floor level from the ground. Add 1.5 % extra over the rate for each additional floor or 4m. beyond the initial 8 m. or part thereof. i) For trusses spanning up to 12.00 m

Galvanized corrugated iron sheet work (excluding the supporting frame work) fitted and fixed with 10 mm. dia J or L hook-bolts, limpet and bitumen washers and putty complete with 150 mm. end lap and one corrugaion minimum side lap. (Payment to be made on area of finished work) (GCI sheet to be supplied by contractor) (i)In roof.(b)with 0.63mm.thick sheet.

Galvanised iron sheet eaves gutter fitted and fixed with necessary 50 mm X 6 mm M.S flat bar clamps bent to design, bolts, nuts, washers etc. complete. Eaves gutter made of 0.63 mm. sheets.(300mm End lapping) (b) 300 mm. wide gutter

Ceiling of commercial ply as per design fitted and fixed complete (excluding the supporting framework but including c necessary wood battens of size 40mm x 20mm.) In ground floor

Supplying, fitting and fixing CPVC (Chlorinated Polyvinyl Chloride) pipes of approved make conforming to IS-15778: 2007 . with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials. (a) For Exposed Work 50 mm (i) CPVC Pipes Class-1, SDR-11

Iron butt hinges of approved quality fitted and fixed with steel screws, with ISI mark. 100 mm x 75 mm x 3.50 mm

Iron secket bolt of approved quality fitted and fixed complete. 300 mm long x 10 mm dia bolt

(b) Priming one coat on timber or plaster surface with synthetic oilbound primer of approved quality including smoothening surfaces by sand papering etc.

Applying Acrylic Emulsion Paint of approved make and brand on wall and ceiling including sand papering in intermediate coats including wall putty (to be done under specific instruction of Superintending Engineer) :(b) Two Coats

Applying Exterior grade Acrylic primer of approved quality and brand on plastered or cencrete surface old or new surface to receive decorative textured (matt finish) or smooth finish acrylic exterior emulsion paint including scraping and preparing the surface throughly,complete as per manufacturer's specification and as per direction of the EIC In Ground Floor: (b) Two Coats

Acrylic Distemper to interior wall, ceiling with a coat of solvent based interior grade acrylic primer (as per manufacturer's specification) including cleaning and smoothning of surface. Two Coats

Supplying,fitting and fixing in position G.I. pipes of TATA make for underground works with all necessary accessories, specials viz.socket, bend, tee, union,cross, elbow,nipple,short piece etc.including cost of all materials, jointing materials ,cutting pipes,making threads,cutting trenches upto 1.5 metre below surface in all sorts of soil and refilling the same as directed with two coats of painting on G.I. pipes and specials with bituminous paint complete in all respect. (Payment will be made on the centre line measurement of the total pipe line including all specials No separate payment will be made for accessories, specials.Payment for painting will be made seperately) (iii) 25 mm dia. medium quality

Supplying,fitting and fixing White Vitreous China Sink in position on C.I. brackets including two coats of painting of brackets.

Supplying, fitting & fixing Cast iron soil pipe only With bobbins, nails etc. including making holes in the wall,floor etc. and cutting trenches etc. in any floor through masonry concrete, if necessary, and mending good damages with necessary jointing materials and painting two coats to the exposed surface with approved paint complete. (Measurement will be made along the center line of the total pipe line in fitted condition including specials,payment for specials & Painting will however be paid seperately). A)    With valamoid joints including sealing with sand cement morter (4:1) upto quarter depth.

Supplying,fitting and fixing Orissa pattern water closet in white glazed vitreous chinaware of approved make in position complete excluding 'P' or 'S' trap (excluding cost of concrete for fixing) (i) 580 mm X 440 mm

Supplying,fitting and fixing 10 litre white glazed vitreous Chinaware of approve low-down cistern of approved make With either side or bottom inlet,side overflow,brackets complete with all internal fittings.(ModelCode No. S1060106 of CERA or equivalent.(i) 580 mm X 440 mmincidental charges such as electricity charges, labour insurance charges etc. For trusses spanning upto 12.00m.

Construction of septic tank of different capacities as per approveddrawing with 1st class brick work in cement mortar (1:4) including two560 mm dia. R.C.C. manhole cover(heavy type)of approved makesupplied, fitted and fixed in the 100mm thick R.C.C (1:1.5:3) top slabwith necessary fittings, 20mm thick cement plaster (4 : 1) with neatcement finish to the internal surfaces and 15 mm thick cement plaster (4: 1) to outside wall upto 200 mm below G.L floor finished with 25 mm thick grey artificial stone over 100mm thickR.C.C (1:1.5:3) bottom slabincluding supplying, fitting and fixing all necessry specials, fittings,S.W. tees, C.I. foot rest etc. including excavation earth in all sorts ofsoil, shoring, bailing out and pumping out water asnecessary, ramming,dressing the bed and fefilling the sides of the tanks with earth, removingspoils, filling up the chamber with clear water, removing foreignmaterials from the chamber and including constructing attachedinspection pit as per approved drawing and connecting all necessarypipes, joints etc. with internal plaster work and artificial stone flooringis to be done with admixture of water proofing compound @ 0.5% byweight of cement with all costs of labour and materials.