District Magistrate Tender

Single layer brick flat soling of picked jhama bricks including ramming and dressing bed to proper level and filling joints with powdered earth or local sand

Cement concrete with 30mm down graded stone shingle excluding shuttering in ground floor. (i) 6:3:1 Proportion

Ordinary cement concrete with grade River Bazree(1:2.4) (20mm size) excluding shuttering and reinforcement .if any ,in ground floor. By River bazree

Brick work with 1st class bricks in cement mortar (1:4)(a) In foundation and plinth

125 mm. thick brick work with 1st class bricks in cement mortar (1:4) in ground floor.

Ordinary cement concrete with grade River Bazree(1:1.5:3) (20mm size) excluding shuttering and reinforcement .if any ,in ground floor. By River bazree

Reinforcement for reinforced concrete work in all sorts of structure including distribution bars, stirrups, binders etc. including supply of rods etc.----------etc. complete as per drawing and direction. Other than TATA/SAIL/RNTL

Hire and labour charges for shuttering with centering and necessary staging upto 4 m using approved stout props and thick hard wood planks of approved thickness etc-------------etc. after completion of works.25 mm to 30mm thick wooden shuttering upto P.L GROUND FLOOR

Above pl up to roof gf

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints etc.-----etc. complete where necessary.(ground floor). (b)10 mm thick plaster in out side (4:1) G.F

(b)15 mm thick plaster in out side (6:1) G.F

Supplying & fitting Fixing 1st quality Ceramic tile in Wall & floor to match with the existing work & 4 nos key stone(a) Area of each tile upto 0.09 Sq.m (i) Coloured decorative

Supplying, fitting & fixing granite slabs 15mm to 18 mm. thick with uniform texture & without decorative veins in columns, wall, facia etc. with 15 mm thick [avg] cement mortar (1:2) including making suitable arrangements to hold the stones properly by brass / copper hooks including pointing in cement mortar (1:2) (1 white cement : 2 marble dust) with admixture of pigment matching the stone shades all complete as per direction of the Engineer-in-charge including cost of all materials, labours, scaffolding, staging ,curing and roughening of concrete surface complete. Area of each Granite slab 0.6 upto 1.0 square metre. [Using cement slurry at back side of granite @ 4.4 kg/sq.m & white cement slurry for joint filling @ 1.8 kg/sq.m]

Supplying& laying 20 mm designer chequered tiles of any shade and of approved quality as per IS: 1237: 1980 laid in patterns as directed in pavement, footpath including necessary underlay 25 mm thick average cement mortar (1:3) complete in all respect with all labour and materials [using cement slurry @ 4.4 kg/Sq.m at back side of tiles. Cement of mortar & slurry will be supplied by the Department. Border concrete if necessary to be paid separately].

Labour for boring tube well of required dia. by water jet system through any type of soil strata including hire and labour charges for boring pipes,scaffolding, tools and plants as necessary and taking out them and lowering pipes, strainers, blind pipe etc. and fitting and fixing the same complete including bucket washing and other incidental works in the connection. The tube well should have a minimum 50 mm gap in between the outside of the tubewell pipe and the bore For100 mm dia

For 50 mm dia

Supplying, fitting and fixing PVC pipes for underground work of approved make of Schedule 80 (medium duty) conforming to ASTMD -1785 and threaded to match with GI Pipes as per IS : 1239 (Part - I). with all necessary accessories, specials viz. socket, bend, tee, union, cross,elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc.fitted including cost of all materials ,jointing materials, cutting pipes,making threads ,cutting trenches upto 1.5 metre below surface in all sorts of soil and refilling the same as directed complete in all respect. (Payment will be made on the centre line measurement of the total pipe line including all specials No separate payment will be made for accessories, specials.) For 50 mm dia

100 mm dia

25 mm dia

Supplying PVC strainer of approved make with adapter conforming to I.S.12818 specifications. 80 MM DIA

Supplying, fitting and fixing steel cutter piece upto 450 mm long with sockets

Supplying,fitting and fixing check valve (horizontal) G.M. tested to 21 kg per sq. cm.

PTMT (Polytetra Bib Cock / Stop Cock ( Prayag or equivalent)

Supplying P.V.C. water storage tank of approved quality with closed top with lid (Black) - Multilayer 1000 lt capacity

(a) Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.

Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary

Construction of circular soak well by coc ring (900x450x75) 5 pice with fixing complete

Supplying, fitting and fixing G.I. pipes of TATA make with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads, fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials. Payment for painting will be made seperately) TATA 40 mm dia medium quality

Solar Module: Supply, Transport, Installation & commissioning of ISI marked Solar Module Multicrystaline/ Monocrystaline/ Monocrystaline PERC/ bifacial cell with min efficiency of 15% & fill factor more than 70% laminated between sheet of Ethylene Vinyl Acetate (EVA) & high transmissivity 3.2/ 4.0 mm tempered glass, framed in anodized aluminium frame. The power output of individual PV modules used in the PV array under STC, should be a minimum 300 watt peak, with adequate provision for measurement tolerances. Modules supplied with the SPV system should have warranty for output wattage, which should not be less than 90% at the end of 10 years & 80% at the end of 25 years. Necessary Test Certificates also to be supplied.

Power conditioning unit Supply , transport , insiailaiion and commissioning of IP 54 protected enclosured Inverter Unit qualifying IEC 61683-Efficiency measurement and IEC 60068-2-Environment Standard , safety standard suitable for 3 Phase A.C. motor, lGBT based high voltage switching invener with MPPT technology, to take care of the variation of Sun Iight and will be suitabiy mounted inside the metai enclosure. lnveuer should have protection against t)ry run, Over current. Under current, Over voltage, Under voltage, Short circuit etc. System should be able to rim at low sunshine and minimum 7 to 8 hours a day run should be possible during normal sunshine.condition. Inveuer should have option to auto start for any short trip off due to low light/ cloudy situation except for dry run. Inverter should be provided with a display to show the various parameter by ihc user such as Voltage, C orreni. Solar panel DC voltage, lnveuer IGHT tcrnperature, Out put AC voltage, Output frequency, Pump from (dirc‘Ct or calculated method), Irradiation etc . I he system shouid store the data ai a set interval, be capable to transfer it to exicrnal storage device znâ support communication of its operational parameters and logs over Modbus protocol . It should also monitor and save total run time, total water pumped etc .

Cable & Accessories: Supplying, fitting fixing of UV rated Copper Cable laid inside HDPE conduit & other accessories as per followings with necessary connection with the Solar PV module, MPPT etc (i) 4.0mm sq mm single core multi studs - 5m (for 2HP) (II) Lugs, HDPE Pipe, Flexible Pipe , Saddle, Cable tie etc

Earthing: Earthing wiih 50 trim dia G I pipe 3.64 mv thick x 3.04 Mts. long and 1 X 4 SWG GI (Hot Dip) wire (4 Mrs. long). 13 mm dia x 80 mm long GJ bolts, double outs, double washers incl. S & F 15 mm dia GI pipe protection ( I Mts. long) to be filled with bitumen partly under the ground level and partly above ground level driven to an average depth of 3.65 Mts. be!ow ihe ground level as bclow: By ISI Medium Gl pipe including excavation of soil for installation of Earth Electrode and filling & ramming and connecting to individual structure to earth electrode including S&F 20 mm x 3 mm galvanised (Hot Dip) MS flat on wall/door with GI saddles as required and connection to equipments incl drilling holes with bolts nuts washers etc

Supply & Installation of 3 Phase Electromotor Pump-Motor Set Suitable For Solar Operation covering 5years warranty for the following conditions including loading, unloading, transportation etc 2-HP ISI marked -Submersible Pump-motor set for LDTW ISI marked as per lS: 8034 with discharge of 7.i Lps- 5.83 Lps at 30 mts.-3S mts. total head with cable(3m), cover plate, Socket, Fianged Nipple, Rubber Insertion, Nuts& bolts and all other accessories including zansportation of Bend, Column Pipes, cable, sluice value, lay flat hose pipe e‹c.

Testing & commissioning of scheme after completion of all work

Lighting system at Scheme: ( Mounted on Pump House Wall): Dusk to dawn lighting arrangement of at 4m height above G.L., with Hot dip galvanised 80mm X 50mm medium duty pipe, with 12V , 15Ah 2-in-1 Lithium ion/ Ferro - Phosphate battery with in built 7-11 watt LED lamp, 50wp solar panel to cover the scheme area. The lighting system should be warranted for 5 years from the date of installation.

Installation of Iron Removal filter-Dual Media filter with Treated Sand and Anthrasid of vessel size 1354. [Tata or equivallent]

GST(18%)

LABOUR CESS(1%)