District Magistrate Tender

Single brick flat soling of picked jhama bricks including ramming and dressing bed to proper level and filling ijoints with powdered earth or local sand

Cement concrete with 30 mm down graded shingles excluding shuttering. N.B Varietyln ground floor fal 1:3:6 drovortion

Ordinary Cerment concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes b) River bazree

Reinforcement for reinforced concrete work in all sorts of structures including 8 distribution bars, stirrups,binders etc. including supply of rods, initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape,placing in proper position and binding with 16 gauge black annealed wire at every inter-section, complete as per drawing and direction. (i) Tor steel/Mild Steel

Hire and labour charges for shuttering with centreing and necessary staging upto 4 m. using approved stout props and thick hard wood planks of approved thickness with quired bracing for concrete slabs, beams, columns, lintels curved or straight including fitting, fixing and striking out after completion of works. (upto roof of ground floor f) 25mm. to 30mm. shuttering without staging in foundation etc.

a)25 mm. to 30 mm. thick wooden shuttering as per decision & direction of Engineer in-charge.

Brick work with 1st class bricks in cement mortar (1:4) a) In foundation and upto plinth

125 mm. thick brick work with 1st class bricks in cement mortar (4:1) in ground floor

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints or rougening of concrete surface, including throating, nosing and dripcourse where necessary (ground floor) (a) With 6:1 cement mortar (b) 20 mm. thick plaster

C)15 mm. thick plaster (6:1)

C) 10 mm. thick plaster

Nent punning about 1.5mm thick in wall,dado,window sill,floor etc. NOTE:Cement 0.152 cu.m per100 sq.m.

Aplying decorative cement based paint of approved quality after preparing the surface including scraping the same thoroughly (plastered or concrete surface) as per manufacturer's specification. In Ground floor: Two Coat

Supplying, fitting & fixing 1st quality Ceramic tiles in walls and floors to match with thel existing work &4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with whitecement mixed with colouring oxide if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc.

Labour for boring tube well of required dia. by water jet system through any type of Isoil strata including hire and labour charges for boring pipes, scaffolding, tools and plants as necessary and taking out them and lowering pipes, strainers, blind pipe etc. and fitting and fixing the same complete including bucket washing and other incidental works in the connection. The tube well should have a minimum 50 mm gap in between the outside of the tubewell pipe and the bore. (d) For depth upto 150 metre for 50 mm dia. tube well with top enlargement of 100 mm dia.

50 mm dia

Supply of PVC pipes & fittings Schedule 80 (medium duty) conforming to ASTMD 1785 and threaded to match with GI Pipes as per IS: 1239 (Part- 1). (A) PVC Pipes100 mm

50 mm

supplying PVC strainer of approved make with adapter conforming to l.S.12818 specifications. ii) 50 mm dia.

Supplying, fitting and fixing steel cutter piece upto 450 mm long with sockets. (ii) 50 mm dia.

Digging earth in any soil including mixed soil but excluding moorum, laterite sand stone or any other hard stone including spreading or stacking the spoils within a lead of 75 metres as directed bailing out water upto 1 metre depth, shoring etc., when and if required and back filling with fine sand (including cost of sand) on completion of steining works. A) R.C.C. Ring Well ) 1.2 metre diameter of digging for 0.9 metre internal diameter of well ring a) Upto 3 metre below G.L.

R.C.C. well ring made with cement concrete 1:1.5:3 with stone chips and 0.80% reinforce fitted and fixed in position after proper curing true to plumb in the well including jointing with cement mortar 1:2 complete as per direction. b) 65 mm thick and 1.2 metre internal dia. ent (including the cost of shuttering and reinforcement) cast at site

Supplying, fitting and fixing CPVC (Chlori Polyvinyl Chloride) pipes of approved make conforming to IS-15778: 2007. with all necessary accessories, specials viz socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee short piece etc. fîtted with holder bats clamps, including cutting pipes, Atting, fixing etc complete in all respect including cost of all necessary fittings as required,jointing materials in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be For Exposed Work, (ii) CPVC Pipes Class-2,SDR-13.5 25mm

Supplying P.V.C. water storage tank of approved quality with closed top with lid (Black)-Multilayer b) 1000 litre capacity

Labour for hoisting plastic water storage tank. Upto 1500 litre capacity. a) Upto 1st story from G.L.

Supply of Chlorinated Polyvinyl Chloride (CPVc) pipes & fittings conforming to IS 15778: 2007 25 mm

Supply of UPVC pipes (B Type) & fittings conforming to IS-13592-1992 A) G) Single Socketed 3 Meter Length b)110 mm

(ii) Door Tee, (b) 110 mm

x)Bend 87.5° (b) 110 mm

xv) Vent Cowl, (b) 110 mm

i) Nahani Trap, 90 mm

Supplying, fitting and fixing bib cock or stop cock. (E) Supplying, fitting and fixing alloy iron with brass spindle bib cock/ stop cock of approved brand and make, spray painted and tested to 21 kg per sq. cm. ) 15 mm

Collecting sample of water for bacteriological and chemical test from any depth at any time during execution of work including hire and labour harges for tools and plants and sterilising the equipments, paying all charges and fees, testing etc. complete in al respect as per direction.

Supply, transport, installation and commissioning of Solar PV installation for water pumping system with fixed structure (on roof) consisting of solar panels framed in anodized aluminium frame mounted on stable hot dipped galvanized (with 80 micron thickness) mild steel structure of sufficient strength which can withstand load of modules and high wind velocities upto 150 Km/hr, having RCC foundation designed against all possible loads (Dead, Live and imposed load). Modules supplied with the SPV system should have certificate as per IEC 61215 specification or equivalent National or International standards and must be interconnected with 4/6 sq.mm cables routed in PVC conduits properly fitted along the G.I structure to provide a good aesthetic view. Modules must qualify to IEC 61730 part I and part Il for safety qualification testing. The power output of individual PV modules used in the PV array, under STC, should be a minimum of 250 Watts peak, with adequate provision for measurement tolerances. Solar cells should be crystalline silicon cell with min. efficiency of 14% and fill factor more than 70%, should be laminated between sheet of Ethylene Vinyl Acetate (EVA) and high transmissivity 3.2mm tempered glass including appropriate DC to AC inverter and power controlling unit (protected with IP65 class enclosure) with MPPT technology to run at low sunshine and minimum 5 hours a day run with all necessary accessories suitable for solar + grid operation and including all protections of AC induction motor pump. There should be a display of all measurable parameters including storing of data at a set interval and transfer it in a pendive thru USB port. There should also be provision of interfacing GPRS based data transmission. The rate is inclusive of manufacturer's warranty and comprehensive maintenance for 1st year and comprehensive maintenace for 4 years beyond Ist year )

Supplying, fitting and fixing and Installation of Water Pump with Motor 1 HP, 5 Metre. Head suitable for 100 mm dia. Tube well etc. including all (BIS Standards & including pannel board) 1H.P

Supplying, fitting and fixing and Installation of IRON REMOVAL FILTER including all. (BIS Standards & including 1 Year Warranty +3 Years' Service AMC)

GST @18%

Labour welfare Cess @ 1%