Uttarakhand Cooperative Dairy Federation Limited Tender
View complete overview of Uttarakhand UCDF Tender
Uttarakhand Cooperative Dairy Federation Limited - UCDF Tender
Food Products
Eprocure
Opening Date13 Feb 2024
Closing Date1 Mar 2024
Tender Amount₹ 54,26,000
Costs
EMD
₹ 1,10,000Document Cost
₹ 4,720Tender Fee
Refer Documents
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2024_UCDF_69467_1Bid Award Id
ViewTender No
28(1-13)/ucdf/civil/23-24date 08.02.2024Tender Authority
Uttarakhand Cooperative Dairy Federation Limited ViewPurchaser Address
-Website
http://uktenders.gov.in
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
BOQ Items
Supplying and filling in plinth with Jamuna sand under floors including, watering, ramming consolidating and dressing complete.
60
-
-
Diluting and injecting chemical emulsion (Chlorpyriphos/Lindane E.C. 20% with 1% concentration), at the rate of one litre per hole at 300 mm c/c to all the horizontal and vertical surfaces of the excavations made for the foundation of the building, soil under floors, apron, back fill material and along all the faces of the walls for PRE-CONSTRUCTIONAL anti-termite treatment (including the cost of chemical emulsion) as per IS:6313 Part-II. Plinth area of Building shall be measured for Payment.
247.5
-
-
Providing and laying damp-proof course 50mm thick with cement concrete 1:2:4 (1 cement : 2 coarse sand(zone-III) : 4 graded stone aggregate 20mm nominal size).
50
-
-
Providing and laying in position specified grade of reinforced cement concrete excluding the cost of centring, shuttering, finishing and reinforcement - All work upto plinth level1:1.5:3 (1 cement : 1.5 coarse sand : 3 graded stone aggregate 20 mm nominal size)
20.45
-
-
Reinforced cement concrete work in walls (any thickness), including attached pilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers,abutments, posts and struts etc. upto floor five level excluding cost of centring, shuttering, finishing and reinforcement 1:1.5:3 (1 cement : 1.5 coarse sand : 3 graded stone aggregate 20 mm nominal size)
4.63
-
-
Reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15 degree landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases up to floor five level excluding the cost of centering, shuttering, finishing and reinforcement with 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size).
13.85
-
-
Centring and shuttering including strutting,ropping etc. and removal of form for Centring and shuttering including strutting,ropping etc. and removal of form for foundations, footings, bases of columns, etc. for mass concrete.
12
-
-
Centring and shuttering including strutting,ropping etc.Lintels, beams, plinth beams, girders, bressumers and cantilevers.
168.97
-
-
Centring and shuttering including strutting,ropping etc.Columns, Pillars, Piers, Abutments, Posts and Struts
60.45
-
-
Reinforcement for R.C.C. work including Straightening, cutting, bending, placing in position and binding all complete. Thermo-Mechanically Treated bars.
45.85
-
-
Brick Work Brick work with F.P.S. bricks of class designation 75 in foundation and plinth in Cement mortar 1:6 (1 cement : 6 coarse sand)
37.31
-
-
Brick work with F.P.S. bricks of class designation 75 in superstructure above plinth level upto floor V level in all shapes and sizes in Cement mortar 1:6 (1 cement : 6 coarse sand)
79.15
-
-
12 mm cement plaster of mix 1:6 (1 cement : 6 fine sand)
426.38
-
-
15 mm cement plaster on rough side of single or half brick wall of mix1: 6 (1 cement: 6 fine sand)
351.24
-
-
Cement concrete flooring 1:2:4 (1 cement: 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry, but excluding the cost of nosing of steps etc. complete.40mm thick with 20mm nominal size stone aggregate.
233.91
-
-
Providing and fixing glass strips in joints of terrazo/ cement metre concrete floors. 40 mm wide and 4 mm thick.
378.56
-
-
Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade New work (two or more coats) over and including priming coat with cement primer
426.38
-
-
Finishing walls with Premium Acrylic Smooth Exterior paint with Silicone additives of required shade New work (Two or more coats applied @ 1.43 ltr/ 10 sqm. over and including base coat of water proofing cement paint applied @ 2.20 kg/ 10 sqm).
351.24
-
-
Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture.
158.22
-
-
Steel work welded in built up sections/ framed work, including cutting,hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames, guard bar, ladder, railings, brackets, gates
and similar work
145.8
-
-
Supplying and fixing rolling shutters of approved make, made of required size M.S. laths, interlocked together through their entire length and jointed together at the end by end locks, mounted on specially designed pipe shaft with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs manufacturedfrom high tensile steel wire of adequate strength conforming to IS: 4454 -part 1 and M.S. top cover of required thickness for rolling shutters.80x1.25 mm M.S. laths with 1.25 mm thick top cover
18
-
-
providind & fixingBall bearing for Rolling shutter including all material ,T&P etc complete.
4
-
-
Supply & installation of precoated alvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm +/- 5% total coated thickness (TCT) thick Zinc coating 120gsm as per IS: 277 in 240mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches while transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be
fixed using self drilling /self tapping screws of size (5.5x 55mm) with EPDM seal or with polymer coated J or L hooks, bolts and nuts 8mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead complete upto any pitch in horizontal/ vertical or curved surfaces excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.
286.35
-
-
Providing and fixing precoated galvanised steel sheet roofing accessories 0.50 mm (+0.05 %) total coated thickness, Zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns using self drilling/ self tapping screws complete : Ridges plain (500 - 600mm) metre
15.9
-
-
Forming groove of uniform size from 12*12 mm and upto 25*1 plasterd surface as per approved pattern using wooden battens
440
-
-
Providing & fixing 4.0 mm thick glazing in window ventilator shutter and partion etc. woth a putty as per directed of engineer in charge.
4.86
-
-
Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.
1621.69
-
-
Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.
3088.98
-
-
WGPVCMOD point wiring in pvc conduit with modular type switch wiring for light point/fan point/exhaust fan point/call bell point with 1.5 sqmm fr pvc insulated coper conducter single core cable in surface/recessed pvc conduit with modular switch modular plate suitable gi box and earthing the point with 1.5sqmm fr pvc insulated coper conducter single core cable etc. as requiredGroupe A
25
-
-
WGPVCPP2 power plug wirinig in pvc conduit(2*4 sq.mm wirining for light/power plug with 2*4 sq.mm fr pvc insulated copper conducter single core cable in surface/recessed pvc conduit alongwith 1 no 4 sq mm fr pvc insulated copper conducter single core cable for loop bearthing as required
200
-
-
WGPVCSB Circuit/sub man wiring in pvc coduit wiring for circuit/sub man wiring alongwith earth wire with the following sizes of pvc insulated copper conduter single core cable in surface/reessed pvc conduit as required.2*4 sqmm +1*4 sqmm earth wire.
250
-
-
MB s/f metal boxes of following sizes (nominal sizes) on surface or in recsses with suitable size of phenolic laminated sheet cover in front including painting etc.required. 100mm*100mm*60mm deep
5
-
-
Supplying an fixing following rating, double pole, (single phase and neutral), 240 volts ,residual current circuit breaker (Rccb) ,having a sensitivity current upto 300 mamp in the existing MCB DB Complete with connections testing and commissioning etc.as required .25 amps
6
-
-
Excavation in Soil by Manual Means.(Excavation for roadway in soil using manual means including loading in truck for carrying of cut earth to embankment site with all lifts and lead upto1000 metres.)
830.38
-
-
Concrete with cement, coarse sand and 40 mm gauge stone ballast in proportion 1:4:8 in foundations and floors including supply of all material,labour and T&P etc. required for proper completion of the work. as per drawings and technical specifications Clause 802, 803, 1202 & 1203
26.31
-
-
Random Rubble Stone Masonry laid in 1:6 cement and sand mortar, in breast walls, retaining walls, parapets, scuppers, etc. including supply of all material, labour, T&P and royaltiies etc. complete as per drawing and technical specifications Clauses 702, 704, 1202 & 1203 of MORD Specifiction
174.25
-
-
Providing concrete for plain/ reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 P.C.C. grade M 20 Nominal mix (1:2:4)
9.52
-
-
Pointing with cement mortar (1:3) on retaining wall and brickwork as per drawing and technical
specification Clauses 613.3 and 1204
116.65
-
-
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements