Uttarakhand Agricultural Produce Marketing Board Tender

Water Proofing Treatement Under Roof Treatment to operate the Craks/ Crack Bridgeing, Crack Filled with Selent flex Bostik make sielent properly and after that direct coating of one layer of pure solution of master crete M-81 over the entire surface of roof & then finally two layer coating of master crete M-81 solution mixed with cement in proportion of 1:1.5 (1 master crete M-81 Solution and 1.5 part Cement)will be done over the entire surface of roof . Including supply of all materials labour T&P etc. with all complate work required for proper completion of the work as direction of engineer in charge. Approved Rate C.B No. 525 H

Providing and fixing water closet squatting pan (Indian type W.C.pan ) with 100 mm sand cast Iron P or S trap, 10 litre low level whiteP.V.C. flushing cistern, including flush pipe, with manually controlled device (handle lever) conforming to IS : 7231, with all fittings andfixtures complete, including cutting and making good the walls andfloors wherever required: White Vitreous china Orissa pattern W.C. pan of size 580x440 mm with integral type foot rests each 3494.20 17.1.1

Providing and fixing white vitreous china pedestal type water closet(European type W.C. pan) with seat and lid, 10 litre low level whiteP.V.C. flushing cistern, including flush pipe, with manually controlled device (handle lever), conforming to IS : 7231, with all fittings andfixtures complete, including cutting and making good the walls andfloors wherever required : W.C. pan with ISI marked black solid plastic seat and lid 17.2.2

Providing and fixing Stainless Steel A ISi 304 (18/8) kitchen sink asper IS: 13983 with C.I. brackets and stainless steel plug 40 mm,including painting of fittings and brackets, cutting and making goodthe walls wherever required Kitchen sink with drain board 510x1040 mm bowl depth 250 mm 17.10.1.1

Providing and fixing G.I. pipes complete with G.I. fittings and clamps,i/c cutting and making good the walls etc.Internal work - Exposed on wall 15 mm dia nominal bore 18.10.1

Providing and fixing brass bib cock of approved quality : 15 mm nominal bore 18.15.1

Providing and fixing 12 mm thick prelaminated particle board flatpressed three layer or graded wood particle board conforming to IS:12823 Grade l Type ll, in panelling fixed in aluminum doors, windowsshutters and partition frames with C.P. brass / stainless steel screwsetc. complete as per architectural drawings and directions ofEngineer-in-charge.Pre-laminated particle board with decorative laminationon both sides 21-2-2

Providing and fixing glazing in aluminium door, indow, ventilatorshutters and partitions etc. with EPDM rubber / neoprene gasketetc. complete as per the architectural drawings and the directionsof Engineer-in-charge . (Cost of aluminium snap eading shall bepaid in basic item): With float glass panes of 5.50 mm thickness 21-3-2

Providing and fixing PTMT towel rail complete with brackets fixed towooden cleats with CP brass crews with concealed fittingsarrangement of approved quality and colour.600 mm long towel rail with total length of 645 mm, width78 mm and effective height of 88 mm, weighing not lessthan 190 gms 17.73.2

Rectangular shape 1500x450 mm Mirror with Plastic moulded frame 1731

S/F 15 mm dia C.I Jali

Providing and fixing brass curtain rods of wall thickness 1.25 mmwith two brass brackets fixed with brass screws and wooden plugsetc. wherever necessary complete. 25 mm diameter.14.28.2

Brass handles 100 mm with plate 150x32 mm 0409

Brass handles 125 mm with plate 175x32 mm 0408

Providing and fixing precoated galvanised iron profile sheets (size,shape and pitch of corrugation as approved by Engineer-in-charge)0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 micronsepoxy primer on both side of the sheet and polyester top coat 15-18microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should besupplied in single length upto 12 metre or as desired by Engineerin-charge. The sheet shall be fixed using self drilling /self tappingscrews of size (5.5x 55 mm) with EPDM seal, complete upto anypitch in horizontal/ vertical or curved surfaces, excluding the cost ofpurlins, rafters and trusses and including cutting to size and shapewherever required. 12.50

25 mm wooden planking, tongued and grooved in flooring, including fixingwith iron screws complete with : Second class teak wood 11.33.1

Providing and fixing panelling or panelling and glazing in panelled orpanelled and glazed shutters for doors, windows and clerestory windows(Area of opening for panel inserts excluding portion inside grooves orrebates to be measured). Panelling for panelled or panelled and glazed shutters 25 mm to 40 mm thick : Kiln seasoned and chemically treated hollock wood 9.7.2

Providing wood work in frames of doors, windows, clerestory windowsand other frames, wrought framed and fixed in position with hold fastlugs or with dash fasteners of required dia & length ( hold fast lugs ordash fastener shall be paid for separately).Second class teak wood 9.1.1 (truss type)

25 mm wooden planking, tongued and grooved in flooring, including fixingwith iron screws complete with : Second classdeodarwood 11.33.2

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fastlugs or with dash fasteners of required dia & length ( hold fast lugs ordash fastener shall be paid for separately). Sal wood 9.1.2

Red oxide Zinc chromate primer 4202

Painting with silicon & acrylic emulsion based water thinnable sealerof approved brand and manufacture on wet or patchy portion of plastered surfaces :Two coats 13.51.2

Providing & fixing White vitreous china water closet squattingpan (Indian type) along with "S" or "P" trap includingdismantling of old WC seat and "S" or "P" trap at site completewith all operations including all necessary materials, labourand disposal of dismantled material i/c malba, all completeas per the direction of Engineer-in charge. Long pattern W.C Pan of size 580x440 mm 14.80.1

Cleaning the sand stone surface and removing dirt, dust, birddropping, grease, oil, algae, fungus, monkey beats, vegetable growthetc., including providing, applying and washing the surface with liquidAmmonia Chemical of 5% solution and other chemical cleaningagent as approved by Archaeological Survey of India/ Engineer-incharge,of approved brand and manufacturer, with the help of requiredscrubbers and also cleaning with machine operated water jet mixedwith desired quantity of fine silica where ever required, withoutcausing any scratching/ damage to the stone surface and finallywashing the surface with clean water with the help of pressure jetmachine, complete in all respect, including taking all precautions tosafeguard ventilators, windows, doors etc. by suitable covering soas to avoid any damage to the building/ structure, all as per directionof Engineer-in-charge (The rate is inclusive of all materials & labours involved except scaffolding).24.3

Applying two or more coat of Ethyl Silicate chemical as approvedby Archaeological Survey of India/ Engineer-in-charge, of approvedbrand and manufacturer, with brush or spray on the existing stonemasonry surface till there is no further absorption of chemical bystone surface, including protecting the applied surface from directsunlight by suitable means during application, all complete as perdirection of the Engineer-in-Charge (The rate is inclusive of allmaterials & labours involved except scaffolding). 24-7

Applying breathable, non-reactive, antifungal, and water repellantSilane/ Siloxane chemical as approved by Archaeological Survey ofIndia/ Engineer-in-charge, of approved brand and manufacture, dilutedwith solvent mineral Turpentine oil in the ratio of 1:12 (One part ofapproved chemical :12 Part of Turpentine oil), on the existing sandstone masonry surface with two or more coats to give uniformapplication of chemical on the surface, all complete as per directionof Engineer-In-charge (The rate is inclusive of all materials & laboursinvolved except scaffolding). 24-8

Applying priming coat: With ready mixed pink or Grey primer of approved brandand manufacture on wood work (hard and soft wood) 13-50-1